水壓強度試驗 的英文怎麼說

中文拼音 [shuǐqiángshìyàn]
水壓強度試驗 英文
water pressure test for strength
  • : 名詞1 (由兩個氫原子和一個氧原子結合而成的液體) water 2 (河流) river 3 (指江、河、湖、海、洋...
  • : 壓構詞成分。
  • : 強形容詞(強硬不屈;固執) stubborn; unyielding
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 水壓 : water gage; hydraulic pressure (用英寸高度表示的)水壓泵 hydraulic pump; 水壓鍛造 hydraulic forg...
  • 試驗 : trial; experiment; test
  1. The additional flow is formed by the device of dentoid baffle, and the application of the device of dentoid baffle cooperated with a stilling basin has been investigated by systematic model tests. based on the research results, the hydraulic problems such as the characteristics of hydrodynamic pressure and cavitation on the head of the denotid baffle, the properties of flow under the condition that the device of denotid baffle is used with a stilling basin, the hydraulic computation about a stilling basin, the estimation of energy dissipation and its various affection factors, the mechanism and effect of energy dissipation, and distributions of velocity and pressure and aerating concentration, etc, have been analyzed ; the method and step of hydraulic design of device of denotid baffle by which the additional flow is produced has also been proposed

    文中利用齒墩設施實現附加射流,對齒墩設施與消力池聯合應用進行了大量的和系統的模型,分析研究了中低佛勞德數條件下,齒墩墩頭的動及空化特性,齒墩設施與消力池聯合應用時的流態特性,消力池的力計算,消能量的估算及其各種影響因素,消能機理和效果,消力池內的流速、特性,摻氣濃分佈等力學問題,並提出了實現附加射流齒墩設施的力設計方法和步驟。
  2. The result indicates that in the case of constant content of asphalt, marshall stability, compression strength, rupture strength, compression modulus and rupture modulus of cement emulsified asphalt concrete would increase along with the increase in cement content ; in the case of constant content of cement, these index values would decrease along with the increase in asphalt content ; while with the increase of coarse aggregate, rupture strength and rupture modulus of the concrete would increase conspicuously, yet compression strength and compression modulus would have a little change

    結果表明:在乳化瀝青含量不變時,隨著泥用量的增加泥乳化瀝青混凝土的馬歇爾穩定、抗、抗折、抗回彈模量、抗折回彈模量隨之增加;在泥用量不變時,隨著乳化瀝青用量的增加相應的力學指標呈降低趨勢;礦料級配中粗集料含量增加后,混合料的抗折和抗折回彈模量有明顯增加,但抗和抗回彈模量變化不大。
  3. Test methods for natural facing stones part 1 : dry, wet and after freezing test methods for compressive strength

    天然飾面石材方法第1部分:乾燥飽和凍融循環后方法
  4. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌:用xrd進行原料物相分析,及比較冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶;用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性;用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化;用銷盤式摩擦磨損機對固體潤滑劑進行摩擦性能測;採用專用的臺架模擬機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定;用萊次偏光顯微鏡( pm )測固體潤滑劑的硬;用材料機測固體潤滑劑的抗等。
  5. Because the best grade limits does not vary with material property, firstly, we can confine material grade to the best grade limits when doing subbase mixture design, secondly, after systematic temperature contraction test, aridity contraction test and compressive strength correction test, we can determine the best cement percentage which has the best crack resistance property

    因為最佳級配范圍是與粒料的粒徑大小有關的,所以在基層材料配合比設計時可首先將材料級配限制在最佳級配范圍以內,然後通過系統的溫縮、干縮性能以及抗校核,最終確定抗裂性較好的合理泥劑量。
  6. Finally, use spss analyzing experiment data, the most suitable mix design was gained, and an experience expression about material strength and cement / water ratio was found

    通過對數據的分析,給出了最優配合方案,利用spss證經公式,給出了高泥基材料與膠比的經公式以及抗折與抗之間的線性關系。
  7. The author of this article used orthogonal test design, arranged the test scheme scientifically, selected material carefully, at last yielded an ultrahigh strength cement - based material ( uhscm ), whose compressive strength exceeded 100 mpa, mainly by using 42. 5 ordinary portland cement, superfine aggregate : nano sio2, superplasticizers and so on

    本文是在廣泛閱讀國內外有關資料的基礎上,採用正交設計,科學地安排,精心選材,用42 . 5普通硅酸鹽泥、納米sio _ 2 、高效減劑等材料,採用常規工藝配製出了一種抗超過100mpa的高泥基復合材料。
  8. The author of this article used orthogonal test design, arranged the test scheme scientifically, selected material aboratively, at last yield a ultrahigh strength cement - based material ( uhscm ), whose compressive strength exceeded 120 mpa, mainly by using 625r ordinary portland cement, superfine aggregate - - silica fume, superplasticizers and so on

    本文在廣泛閱讀國內外有關資料的基礎上,採用正交設計,科學地安排方案,精心選材,用625r普通硅酸鹽泥、超細顆粒集料硅灰、高效減劑等材料,採用常規工藝配製出了一種抗超過120mpa的超高泥基材料。
  9. Dry, wet and after freezing test methods for compressive strength

    乾燥飽和凍融循環后方法
  10. Dry, wet and after freezing - test methods for compressive strength

    乾燥飽和凍融循環后方法
  11. This machine is fit for the testing use of water pressure intension for highpressure vase as oxygen carbon dioxide, nitrogen, hydrogen, etc., with for functions of loading and unloading valve, water pressure intension testing. auto overturn water pulling, pressure tested under free condition, advanced at home, and is the favorite equipment for steel vase testing stationgs and manufacturers

    本產品適用於高氣瓶(氧氣、二氧化碳、氮氣、氫氣等, )作水壓強度試驗,具有裝卸瓶閥、水壓強度試驗,自動翻轉倒,四大功能,在只有狀態下,是目前國內較為先進的高氣瓶裝置,是各鋼瓶檢測站、製造廠理想設備。
  12. Methods of test for hydraulic setting floor smoothing and or levelling compounds - determination of flexural and compressive strength

    樓層校平和或平層復合物的方法.抗彎曲及抗的測定
  13. In the light of its special property being not easy to gain strength, through mechanics researches on different methods to stabilize this kind of low _ liquid _ limit silty soil as subbase material, evaluated both technically and economically, we have got a cement lime stabilization plan to meet the index requirements for non _ side _ limit strength of compression of subbase of class2 road stipulated in the specification ; by means of improving the workmanship, thickening the loose layer of soil, adding soil on covering weave fabric before compaction, such problems can be solved as very poor compaction, loose surface during compaction, roughness and unevenness, coats of layer and shear damages

    本文針對黃河沖積而成的低液限粉土其粘粒含量極低、土的不均勻系數很小、膠體活性差的工程特性,通過採用不同方法穩定該類土作底基層材料的力學性能研究,從技術、經濟角綜合評價,得到滿足規范抗指標要求的泥石灰穩定方案。通過對原材料、配合比設計、施工、等方面進行優化,從而顯著減輕了基層的早期及長期縮裂程,從而提高了路面的耐久性。
  14. The unconfined compressive strength, shearing strength and permeabi lity of stabilized soils were tested in laboratory, the strength of contaminated composite soils sampled with different ph and soaped in corresponding ph were compared. the results from experiments indicate that there exists a certain relationship between the soft soil properties and the unconfined compressive of grouted soil. with the increase of water content, porosity ratio, degree of porosity, plasticity limit, liquid limit and liquid index, the compressive strength of cement - sodium silicate - stabilized soil decreases, while increases as the bulk weight and compressibility modulus

    通過對泥?玻璃加固土的無側限抗,以及用不同酸堿性製成與養護的固結土所進行對比,得出軟土的物理力學性質指標與加固土的抗之間存在一定的相關關系,即隨著含量、孔隙比、孔隙、液塑限及液性指數的增加,泥?玻璃加固土的抗相應地降低;而隨著原狀土的容重、縮模量的增加,泥土的抗也隨之增加。
  15. Evaluation of uncertainty in measurement crushing strength test of cements determination

    泥膠砂抗測量不確定評定
  16. Match ratio tests are done by using cement and fly - ash as curing agent, which include making soft clay with different water content into different mixing ratio cement - stabilised clay, and mixing cement and fly ash to make different cement - fly ash stengthened clay to soft clay with ascertaining water content. afterwards unconfined compression strength is tested at different curing age. the microstructures and mechanisms of cement soil and cement - fly ash soil are studied by mean ", of x - ray and scanning electron microscope ( sem ) technology

    採用泥和粉煤灰為固化劑在室內進行其配合比,對含量不同的軟粘土製成不同摻入比的泥土以及對含量值固定的軟粘土製成泥、粉煤灰摻入量分別不同的泥-粉煤灰加固土,並在不同齡期時進行無側限抗;運用x射線衍射和掃描電子顯微鏡技術,對泥土及泥-粉煤灰加固軟土的微觀結構和機理進行分析。
  17. Based on analysis on research existing status and application foreground of nanometer materials in cemented based material, the paper firstly discusses the microstructure properties of the three nanometer materials and compares them with the corresponding ordinary crystals. by unconfining compression strength tests of the cemented soil stabilized with the nanometer materials, influencing rules of nanometer material addition ratio and curing period on the strength are individually analyzed

    在總結納米材料在泥基材料中的應用現狀以及應用前景的基礎上,本文首先分析了三種納米礦粉的微結構特性及其與普通礦粉的微結構特性異同;通過泥土室內無側限抗,探討了納米礦粉摻入比和齡期對泥土的影響規律。
  18. Test methods of mechanical properties of mortar for ferrocement - test of axial compressive strength

    鋼絲網泥用砂漿力學性能方法軸心抗
  19. Building roofing. fibre - cement profiled sheets. resistance to passing through of large dimensions soft body. test method

    建築物屋頂.纖維型板.大尺寸軟波紋板的橫向.方法
  20. Building roofing. roofing made of fibre - cement profiled sheets. resistance to passing through of large dimensions soft body. testing and classification

    建築物屋頂.纖維型板制屋頂.大尺寸軟波紋板的橫向.和分類
分享友人