水汽飽和 的英文怎麼說

中文拼音 [shuǐqìbǎohé]
水汽飽和 英文
water-vapor saturation
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 飽 : Ⅰ形容詞1 （吃足） have eaten one s fill; be full 2 （充實; 飽滿） full; plump Ⅱ副詞（充足; 充分）...
  • 和 : 和動詞（在粉狀物中加液體攪拌或揉弄使有黏性） mix （powder） with water, etc. : 和點兒灰泥 prepare some plaster
  • 飽和 : （在一定溫度壓力下, 溶液可含溶質的量達到最大限度, 不能再溶解, 泛指事物達到最高限度） saturation; saturated
  1. The temperature at which the water vapor in a given sample of air becomes saturated is called the dew point.

    使一已知空氣樣品中的水蒸汽達到飽和時的溫度稱為露點。
  2. Over the range of air temperature, the saturation vapor pressure fluctuates from less than 1 / 10 to over 100 millibars, or by a factor of 1000

    在氣溫變化范圍內，飽和水汽壓在小於1毫巴到超過100毫巴（即大於1000倍）間變動。
  3. Data of 2120 class saturated steam locomotive

    2120型飽和蒸汽式水櫃蒸汽機車基本資料
  4. The results show that in 185 saturated steam, pyrite tailing doesn ' t hydrate alone, but is converted into calcium silicate hydrate when mixed with lime

    結果表明： 185飽和蒸汽壓下，硫鐵尾礦不具有水熱水化的能力，硫鐵尾礦與石灰可以形成具有膠凝性能的水化產物。
  5. When the moisture content is below fibre saturation point, the movement of absorbed water is subdivided into two parts : one is diffusion transfer due to the vapor pressure gradient, the other is moisture movement caused by the pressure fluctuation due to the variation of medium

    在纖維飽和點以下時，木材內部吸著水的遷移可分為：水蒸汽壓力梯度下的擴散遷移和由於乾燥介質壓力的波動而引起的浮動壓力下的遷移兩個部分。
  6. Segment timer may use to record pressent year, month, date, display pressent time, and with four - segment alarm function, alarm circlate in the sequence of time from first segment to forth segment alarm point it is display intuitional, clocking accuracy, alarm reliable, with clock keep function while key off function

    採用先進的微處理器進行智能控制，主要適用於供熱供暖製冷等熱能系統中，對熱水過熱蒸汽飽和蒸汽氯化鈣水或其它制熱製冷介質中的熱能進行高精度的積算與控制。
  7. High water saturated vapour pressure leads to the more possible occurrence of cavitation phenomena in water hydraulic pump, and so as in sliding shoes hydraulic supporting without exception

    水的高飽和蒸汽壓力使得水壓泵中極易發生氣蝕現象，滑靴靜壓支承也不例外。
  8. Saturation vapour pressure

    飽和水汽壓
  9. On the saturate concentration, the moisture density in the micro - holes was 100 times larger than the vapor density in the standard state, but only 8 % of liquid water. the water inside the plastic material was in a special liquid state. the delamination and the delamination recovery were observed by c - sam

    當水汽濃度達到飽和時，在塑封材料中可以被水分子進入的有效體積內，實驗條件下的水汽密度為標準狀態下水蒸氣密度的100倍，為液態水密度的8 ，表明在塑封材料中的水分子以一種特殊的液態水形態存在。
  10. These are boxes containing air that is super - saturated with water vapour

    這是一些裝有水汽過飽和空氣的容器。
  11. The paper works out the ice crystal spectrum distributing in the different macroscopic and micro - backgroud of the cloud ( ie, the thickness, the temperature and the supersaturation with respect to ice of the nucleation layer ). this paper also works out the amount of catalyst which is allowed in the cloud nucleation layer according to the different quantity of the supercooled water, the density of the supersaturation of the vapor with respect to ice. simultaneously, the paper discusses the i nfluence of remaining time when seeding artificial ice nucleus in the different ascending - velocity and altitude, and elicits the proper seeding altitude of the catalyst

    以此解為依據，得出了不同均流時，人工引入冰核在核化層存留時間，再以此時間作為人工冰核凝華增長時間，求出不同的雲宏微觀背景（如核化層厚度、溫度、冰面過飽和度等）下的冰晶譜分佈，經和實際資料比對符合相當好。進而求出核化層中不同過冷水量、冰面過飽和水汽密度下雲核化層可允許的催化用量。同時討論了不同升速，不同高度引入人工冰核時對其存留時間的影響。
  12. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響，對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響，弄清了氮氣輔助蒸汽增產的機理主要表現在：氮氣輔助后增加攜熱能力，降低殘余油飽和度，氮氣的壓縮膨脹作用分散和改變了原油流動形態，增強了原油流動性；擴大蒸汽的波及體積，補充地層能量，提高回採水率，強化蒸汽蒸餾效應。
  13. The project studied the direct contact condensation behavior of saturated steam on the subcooled liquid in passive gravity injection system. the experiment parameters were as follows : the initial pressure of prz ranged from 0. 2 0. 6mpa and the initial fluid temperature of core makeup tank ranged from 10 80. condensation phenomenon in cmt was observed

    本課題進行了非能動重力補水系統中飽和蒸汽在過冷液面上直接接觸冷凝的實驗研究，研究了在加裝遮流板時，系統壓力0 . 2 0 . 6mpa ， cmt初始溫度為10 80條件下壓力容器cmt中飽和蒸汽在過冷液面上冷凝的瞬態特性。
  14. Presents the operating principle, deduces the temperature - saturated steam pressure relationship, analyses the force balance of valve plates, and points out the factors determining the action of valve plates and the key problems in making this trap domestic

    摘要介紹了膜盒式蒸汽疏水閥的工作原理，推導得到了膜盒內介質的溫度飽和蒸氣壓關系式，分析了閥片的受力平衡，指出了決定閥片動作的因素和膜盒式蒸汽疏水閥國產化進程中要解決的關鍵問題。
  15. The paper is on how to set up lab platform of vapour spewing to uppercooling water surface to coagulate directly and to observe and analyse which vapour coagulate on the water surface, the results enable people to know the security system of nuclear power. the range of the pressure parameters of prz is from 0. 2mpa to 0. 6mpa, and the range of the initial temperature parameters of cmt is from 23. 5 to 78. 5, all of the testing points are 30 and there are fifty thousand testing data. many results of vapour spewing to uppercooling water surface vertically to coagulate can get. for example : coagulating can make the water of cmt surge forcefully when vapour spews to uppercooling water surface, too many vapour - bubbles come into being and strike the water of cmt owing to rupture continually, all these will strengthen the surge because of the vapour pressure of cmt

    實驗中prz飽和蒸汽壓力變化范圍為: 0 . 2mpa - 0 . 6mpa ， cmt中水初始溫度變化范圍: 23 . 5 - 78 . 5 ，實驗中測試工況30個左右，實驗測試數據50萬余個，得出了很多與非能動安全系統相關的蒸汽垂直噴向過冷水表面凝結時的結論：蒸汽垂直噴入過冷水表面凝結時會造成cmt中液面的強烈波動和振蕩，產生大量蒸汽汽泡，汽泡不斷破裂對cmt中液體帶來很大沖擊，勢必引起cmt中液體的振蕩，造成cmt汽空間汽壓不均勻，加強cmt液體的振蕩和波動。
  16. When air is cooled to a point at which the air ' s capacity to hold more water vapor is zero, saturation is reached

    當空氣進一步冷卻到容納更多水汽的能力為零（的那一點）時，飽和狀態就達到了。
  17. There will be a hot water layer in the water of cmt when vapour spews to uppercooling water surface vertically and coagulates directly. the higher of the vapour pressure of prz and the initial water temperature of cmt are, the deeper the hot water layer is. and obtaining the experience formula of the hot water layer is as follows : the condensation coefficient is high when vapour coagulate at first, then it will lessen with the process of coagulation, the higher of the vapour pressure of prz and the initial water temperature of cmt are, the higher of condensation coefficient is

    蒸汽垂直噴入過冷水表面凝結時， cmt中水有明顯熱分層現象， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，熱分層厚度越大，熱分層厚度的經驗關聯式為：凝結剛開始時，凝結換熱系數非常大， ，隨著凝結的進行，凝結換熱系數越來越小， prz中飽和蒸汽壓力越高， cmt中水初始溫度越高，凝結換熱系數越大。
  18. 1. the moisture diffusion in plastic electronic packaging was investigated from both experiment and finite element simulation. the diffusion coefficient and the saturate concentration were determined on the pick ' s law

    利用實驗稱重和fick擴散方程模擬塑封材料對水的吸收過程，得到水汽在實驗塑封材料中的擴散系數和飽和濃度。
  19. Pressures, water level, surface and axial temperatures and total clotted liquid were obtained and analyzed. by experimental phenomenon, the condensation process was divided into two phases : steam supply limit and condensation limit. the interfacial heat transfer coefficient in steam supply limit phase was calculated

    通過實驗，觀察飽和蒸汽在cmt內的冷凝現象，獲取cmt內壓力、水位變化、表面、軸向溫度分佈和累積冷凝量等重要實驗數據，對實驗所得的數據進行分析。
  20. The enclosed space contains air, water vapor, and sufficient excess water so that the vapor is saturated.

    封閉容器的空間內儲有空氣、水蒸汽和足夠的使水蒸汽飽和的水。
分享友人
分享到 Line

分享到臉書