水油流度比 的英文怎麼說

中文拼音 [shuǐyóuliúdùbǐ]
水油流度比 英文
water-oil mobility ratio
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  1. Also the theoretical basis of the method have been checked through simple deducing simulation and the influences of various physical parameters on the method have been studied. it is shown that the method is theoretically reliable for the production oil wells without very high production rate and is more suitable in field production for oil wells ( i ) in area with bigger geothermal gradient ; ( ii ) producing fluids ( oil and water ) with distinguish thermal characteristics ; ( iii ) producing oil with lower heat capacity or water with higher heat capacity ; ( iv ) with good surface measurement accuracy, as well as the method h as certain requirements on the accuracy of the temperature and flowmeter logs sensors

    就該產出剖面方法的理論基礎進行了簡單的正演模擬和可能影響該方法的各項物理參數進行了全面的考察，結果表明，該方法對于非高產的生產油井來說在理論上是可靠的，在實際生產中適合於（ 1 ） 、油井所在地區地溫梯度較大的油井； （ 2 ） 、油水熱特性差別較大的油井； （ 3 ） 、油比熱容值偏低水比熱容值偏高的油井； （ 4 ） 、井口計量精度較高的油井，並且對井溫測井和流量測井的傳感性精度有一定的要求。
  2. Borrowing ideas from design theory and structure type of oil hydraulic proportional throttle valve and taking domestic and overseas correlative development as reference, this paper determines working conditions of the valve, designs its structure, selects suitable materials of its components, and performs corresponding intensity and temperature check

    在借鑒油壓比例節流閥的設計理論、結構型式以及參考國內外相關研究成果的基礎上，確定了水壓比例節流閥的工作條件，設計了水壓比例節流閥的結構型式，選取了合適的元件材料，並進行了相應的強度和溫升校核。
  3. The paper points out that the reasons for displacement efficiency improving of pressure coring well are as follows : firstly, extra - high injection multiples ; secondly, extra - low critical drive ratio ; thirdly, high velocity fluid ' s big differential pressure drive during the process of coring

    得出導致礦場密閉取心井驅油效率高的原囚：一是特高的注水倍數，二是特低的臨界驅動比，三是取心過程中高黏度流體的大壓差驅動。
  4. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等；改進了水冷壁布置使換熱效果更好，減少輻射換熱損失；改進對流段結構，更充分的利用爐膛出口煙氣余熱，提高熱效率；並且進行了煙氣阻力計算、熱效率計算和能量平衡測試，對改進后的稠油燃料和改進前進行了對比，燃燒狀況和熱效率有明顯改善。
  5. The theoretical study of the recovery percent vs. water cut of thin and bottom water reservoir in luliang oilfield is based on developing its geologic and flow models, obtaining oil - thickness ratio, oil - water viscosity ratio, relative permeability curve parameter and chart of effect of bottom water toning, etc., on water - yielding pattern of the reservoir

    摘要在建立了陸梁薄層底水藏地質及滲流模型基礎上，採用理論研究的方法，研究了薄層底水油藏采出程度與含水率關系式，並獲得了油厚比、油水粘度比、相滲曲線特徵參數以及底水錐進等對油藏產水規律的影響關系圖版。
  6. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響，對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響，弄清了氮氣輔助蒸汽增產的機理主要表現在：氮氣輔助后增加攜熱能力，降低殘余油飽和度，氮氣的壓縮膨脹作用分散和改變了原油流動形態，增強了原油流動性；擴大蒸汽的波及體積，補充地層能量，提高回採水率，強化蒸汽蒸餾效應。
  7. As compared with the conventional straight well, the horizontal well can greatly increase the contact area between well and reservoir, change the filtrational mode in the vicinity of wellbore in the reservoir and reduce filtrational resistance, thus obtaining higher oil and gas production by a relatively low producing pressure difference

    摘要同常規的垂直井相對比，採用水平井開采能夠大幅度增加油氣井與油氣藏的接觸面積，改變油氣藏中井筒附近區域的滲流方式，降低滲流阻力，進而可以利用較低的生產壓差來實現更高的油氣產量。
  8. By comparing vertical fracturing well simulation with a streamline model and black oil model, it was pointed out that in simulation of vertical fracturing wells of hydraulic fracturing by using grid amplification there existed many drawbacks, such as grid orientation, calculating times doubled with the increase of grid number, the heterogeneity of model increased as fracture existence, which resulted in difficulties of equation solution and convergence

    摘要通過流線模型和黑油模型模擬垂直裂縫壓裂井的對比分析，指出了在黑油模型中運用網格放大技術模擬水力壓裂垂直裂縫井生產動態存在的諸多缺陷，如網格取向嚴重、計算時間隨網格數目增加而成倍增加、裂縫的存在增加模型的非均質性從而嚴重加大方程的求解難度，方程求解出現不收斂等。
  9. According to the analyses of the research results about the feasibility of 4 - d seismic and the successful 4 - d seismic cases of foreign companies, the author put forward the suggestions for 4 - d seismic pilot area selection ; briefly analyzed the influential function of producing way on the seismic response ; utilized theory calculation, coring data analyses, and reservoir numerical simulation to define the fluid substitution effects on the p - wave velocity. through long time water driven to the reservoir, some of the properties and the log curves have changed, the author tried to find the variation rule of the reservoir and its effects on seismic velocity. the " blind point " in 4 - d seismic feasibility study both in china and overseas was found, that is the lack of consideration of the influence of physical property variation by long time water driven on the seismic response

    在深入分析國外四維地震可行性研究成果和成功實例的基礎上，提出了有利於水驅四維地震成功的工區優選條件；簡要剖析了各種開采方式及其對地震特性的影響；利用理論計算、巖心分析、油藏數值模擬三種方法確定了流體替代對縱波速度的影響；通過對長期水驅造成的物性參數、測井曲線以及油藏溫度和壓力變化規律的總結，分析了這些變化對地震速度的影響，指出了目前國內外水驅四維地震可行性研究中存在的盲區?沒有充分考慮長期注水造成的物性、溫度和壓力變化對地震響應的影響，完善了水驅四維地震可行性研究的內容；在考慮了這些變化因素后，高29斷塊水驅四維地震可行性研究結果表明：四維地震監測注水前沿可能要比監測油藏變化容易的多；以四維地震巖石物理可行性研究結果為基礎，提出了五個有助於突出四維地震造成的微小差異的途徑，為今後水驅四維地震研究指明了方向。
  10. Analysis of the test results of the rear - installed cooling system revealed that the overheat problem resulted from the measured cooling air temperature being higher and the coolant flow and transmission oil flow being smaller than the correct design value, and that the wrong location of the hydraulic oil cooler cannot completely meet the need of the cooling system

    通過對測試數據進行分析，確定了系統過熱的原因，即系統中測試獲取的冷卻風的溫度比設計值高，冷卻水和傳動油的體積流量比設計值小，而且液壓油散熱器布置位置錯誤。
分享友人
分享到 Line

分享到臉書