水負荷試驗 的英文怎麼說

中文拼音 [shuǐfùhéshìyàn]
水負荷試驗 英文
water load test
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 荷 : 荷名詞（蓮） lotus
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 負荷 : [電學] load; charge; weight
  • 試驗 : trial; experiment; test
  1. Chapter 3 and 4 researches soil depurating function and rule to rainwater by soil columniation penetrating examination on the basis of the two former chapters. and it analyses the influence of soil structure, contamination burthen and penetrating deepness to depurating effect, and discusses contaminate cumulation and renewing ability of soil

    第三章和第四章在前兩章的基礎上，通過土壤柱滲透試驗，研究了雨水在土壤中的凈化作用及其規律，分析了土壤結構、污染物負荷、滲透深度對土壤凈化效果的影響，並對污染物的累積和土壤凈化能力的恢復進行了探討。
  2. In chapter 3, the subgrid eddy - viscosity model for large eddy simulation is applied to calculate the three dimensions unsteady periodic turbulent flow in yantan francis turbine. the pulsating characteristics of some main physical parameters in flow field are found. the calculated axial water thrust of hydraulic turbine agrees with the model - test value

    第三章採用大渦模擬亞格子渦粘模型，對巖灘混流式水輪機的流場進行三維非定常湍流分析，得到了流場中各物理量的脈動特性，計算出ms的軸向水推力與模型試驗值大小相當；同時論證了對于下機架承重的混流式水輪發電機組可採用其推力軸承負荷作為水電站廠房振動的最大垂直激振荷載。
  3. The experimental result shows that membrane bioreactor has unique characters, such as high load activated sludge, stable discharging water, quick biological reaction velocity, small occupation area, and simple maintenance and management

    試驗結果表明：膜生物反應器法具有污泥負荷大、出水水質穩定、生化反應速率快、佔地面積少和維護管理簡便等特點。
  4. Roofing and wall cladding. fasteners. determination of the characteristic resitance of the assembly. test method to determine pull - out load of fasteners in crow or valley fixing out of their subconstruction

    屋面和墻壁覆面.緊固件.組件抗性測定.拱頂和屋面排水溝安裝的緊固件從基底拉出的拉拔負荷的測定試驗方法
  5. The height of media 、 the ratio of gas to liquid 、 hydraulic loading 、 the organic and ammonia loading of influent are the key factors influence the performance of one - stage aerobic baf. the conclusions of the experiment are as following : the best height to remove the organic matter and ammonia is at 60cm 、 120cm from the influent side respectively. the best ratio of gas to liquid is 3 : 1 4 : 1 ; the organic and ammonia loading of influent have litlle influence on the performance of one - stage aerobic baf when the concentration are low ; whe the ratio of gas to liquid is 3 : 1, the ammonia loading is blow 0. 87kgnh _ 4 ~ + - n / m ~ 3. d, the enfluent concentration of ammonia is blow 5mg / l which satisfies the water reuse standard ; at different organic loadings, the removal of organic matter keeps 35 % 45 %. hypothermia is unfavourable to nitrification for one - stage aerobic baf to removel ammonia, the influent concentration of ammonia can ’ t satisfy the water reuse standard

    試驗表明:對有機物的去除主要發生在進水端60cm內，對氨氮的去除主要發生在進水端120cm內;曝氣生物濾池運行的最佳氣水比為3 : 1 4 : 1 ;在進水有機物和氨氮濃度比較小時，水力負荷對其去除率影響不大;在氣水比為3 : 1 ，進水氨氮負荷小於0 . 87kgnh4 + - n / m3 （濾料） ? d時，出水氨氮小於5mg / l ，滿足回用水的要求;在不同有機負荷下，有機物去除率保持在35 % 45 % 。
  6. Putting the potassium permanganate into the filter can improve its effect, the removal of organics and ammonia is increased, the influent concentration can satisfy the water reuse standard. but the turbidity of influent is unsatisfactory. the c / n ratio is the key factor to influence the nitrogen - removal of the anoxic / aerobic two - stage baf when the reflux ratio 、 hydraulic loading and the ratio of gas to liquid in aerobic filter are fixed. the anoxic / aerobic two - stage baf has a good removal of organics at different c / n ratio when the reflux ratio is 2, hydraulic loading is 2. 55m ~ 3 / m ~ 2 ? h and the ratio of gas to liquid in aerobic filter is 3 : 1. the influent concentration of organics is blow 7mg / l. from the beginning to 30cm of the anoxic filter, the removal of the organics is significant ; as the c / n ratio increasing, the influent concentration of ammonia is decreasing. when the c / n ratio is 3. 60, the enfluent concentration of ammonia is 3. 05mg / l which satisfies the water reuse standard. when the c / n ration is less than 3. 60, because of the imperfection

    迴流比為2 : 1 ，水力負荷為2 . 55m3 / m2 ? h ，好氧柱氣水比為3 : 1時試驗表明:不同的c / n （ 1 . 05 7 . 45 ）下，兩級曝氣生物濾池對有機物有很好的去除作用，出水有機物濃度小於7mg / l ，其中在缺氧柱進水端30cm內對有機物的去除最為明顯;隨著c / n的增加，系統出水氨氮濃度降低，當c / n為3 . 60時，出水氨氮濃度降到3 . 05mg / l ，已經滿足回用水的氨氮標準; c / n < 3 . 60時，因為缺氧柱的不完全反硝化，體系中硝酸鹽氮和亞硝酸鹽氮發生積累影響了好氧柱的硝化反應使氨氮降解效果較差;系統對總氮的去除隨著c / n的增加而增加，當c / n為3 . 60時，出水總氮已經降到11 . 18mg / l ，滿足回用水的要求。
  7. Four different schemes have been tested on the basis of load variation features concerning the hot water, obtaining optimal design parameters and operation mode

    根據熱水負荷變化的特點，進行了4種方案的試驗，獲得了最佳的設計參數及運行方式。
  8. Abstract : this paper apply asme & quot; feed water pump npsh analysis during load rejection & quot; theory to check bfp npsh of zhuhai power plant 700mw units in the condition of vwo and also confirm the calculating result by load rejection test

    文摘:利用asme的「甩負荷時給水泵汽蝕余量的分析」理論，校核了珠海電廠容量700mw機組在最惡劣工況即閥全開跳機工況時的給水泵汽蝕余量，並在甩負荷時，進行了試驗驗證。
  9. This paper establishes the linear model of hydro - turbine and deducts its transfer coefficients. then the optimized operation parameters are gained in the frequency disturbance and load rejection simulation. through comparing dynamically, this paper analyses the impact on its dynamic performance if some governing system parameter changes

    在研究小波動情形時，即系統在穩定工作工況點附近小瞬變時，可以把非線性系統進行線性化處理;本文建立了水輪機調節系統的線性化模型，推導了其中的傳遞系數;對水輪機調節系統的頻率擾動和機組突甩負荷工況進行了模擬試驗，整定了最佳調節參數;通過動態比較，分析了調節系統參數改變對其動態性能的影響。
  10. Experiment of intensifying primary treatment was conducted to treat urban wastewater with bio - flocculation adsorption technique. sludge precipitation property and affecting factors of biological phase under different sludge load were analyzed

    摘要應用生物絮凝吸附技術對城市污水進行強化一級處理試驗，對不同污泥負荷條件下污泥沉降性能及生物相的影響因素進行分析研究。
  11. Standard test method for flexural strength of soil - cement using simple beam with third - point loading

    用簡支梁三點負荷法測定摻土水泥抗撓強度的標準試驗方法
  12. This study dealled with high concentrated pharmaceutical wastewater treatment. the high level sediments of organic pollutants were examined qualitatively and quantitatively, and the three dominated strains, which can degrade the sediments of albendazole, chlor - trimeton and brufen, had been screened. the three dominated strains were trailed to solidify by materials three of bounded solidification and two of embed solidification. the results of degradation experiment announced that at high loading condition a removal ratio over 90 % of organic compounds had been obtained, about 1 / 3 higher than conventional activated sludge process. assumes to treat the high level organic wastewater has been suggested

    針對制藥行業的高濃度有機廢水，定性定量地測定了高濃度有機物底物；篩選出降解以阿苯噠唑、撲爾敏和布洛芬為主要底物的3種優勢細菌；應用了3種結合固定化材料和2種包埋固定化材料對優勢菌群進行了固定化試驗；通過降解試驗，在高負荷的情況下有機污染物最高去除率可達90 %以上，比一般活性污泥法提高功效1 / 3 ；提出了利用現有設施對高濃度有機廢水的處理工藝設想。
  13. Thermoplastics piping systems - end - load - bearing joints between small diameter pressure pipes and fittings - test method for leaktightness under internal water pressure, including end thrust

    熱塑管道系統.小直徑壓力管和配件間端部負荷軸承接頭.在包含端推力的內部水壓下密封性的試驗方法
  14. Under different rev and loads, the optimal diesel / alcohol proportion would be different. in order to find out the change rule of optimal diesel / alcohol proportion, an orthogonal regression rotating experiment of three factors ( rev, diesel / alcohol proportion and load ) at five levels has been carried out. based on the experiment, four regression equations including energy consumption, soot emission, noise level, and power equations concerning the three factors have been established

    在性能試驗的基礎上，還進行了三因素五水平的二次正交回歸旋轉組合試驗，建立了能耗率、煙度、噪聲、功率與轉速、酒精摻燒率及負荷率之間的回歸模型，通過分析可知，這些模型具有較高的可信度；利用這些模型，本文最後對不同工況下的最佳酒精摻燒率進行優化分析，並利用正交多項式回歸，求出了最佳摻燒率與轉速、負荷之間的回歸模型，該模型在今後的深入研究中將起到一定的指導作用。
  15. Thermoplastics piping systems. end - load bearing joints between small diameter pressure pipes and fittings. test method for leaktightness under internal water pressure, including end thrust

    塑料管道系統.小直徑壓力管與配件間的端負荷軸承連接.包含軸向推力的內部水壓下密封性試驗方法
  16. By heat - trial n cold - trial and operating experience in half a year, the practice prove that : the horizontal concweak ellipse cone combustion technology with primary air and secondary air added side secondary air, have the ability of preventing slagging ^ high - temperature corrosion and stable combustion onlow - load condition. shigeng - ling ( power engineering ) direected by prof

    經冷態和熱態試驗及半年來的運行考驗，實踐證明：一、二次風同心反切加側二次風水平濃淡煤粉橢圓錐燃燒技術，具有防止結渣、高溫腐蝕和低負荷穩燃的能力。
分享友人
分享到 Line

分享到臉書