沉降速度 的英文怎麼說

中文拼音 [chénjiàngsùdù]
沉降速度 英文
dro ing velocity
  • 沉 : Ⅰ動詞1 （沉沒; 墜落） sink 2 （沉下 多指抽象事物） keep down; lower 3 [方言] （停止） rest Ⅱ形容...
  • 降 : 降動詞1. （投降） surrender; capitulate 2. （降伏） subdue; vanquish; tame
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 速度 : 1. [物理學] velocity; speed; blast; bat 2. [音樂] tempo3. （快慢的程度） speed; rate; pace; tempo
  1. They sediment toward the bottom of the centrifuge tube at a velocity.

    它們以某一速度向管底方向沉降。
  2. The floe settling velocity of sediment particles is taken as the function of current velocity, salinity and suspended sediment concentration

    泥沙顆粒絮凝沉降速度考慮了流速、鹽度、含沙濃度的影響。
  3. Differential flocculation was proposed as the mechanism to explain these observed variations in setting rates with salinity.

    有人提出用差異凝聚作用的機理來解釋所觀察到的沉降速度隨鹽度變化的原因。
  4. Sedimentation velocity method

    沉降速度法
  5. Keywords : sedimentation velocity and potential, electrophoretic mobility, electric conductivity, charged composite particle, charged porous particle, arbitrary double - layer thickne

    關鍵詞：沉降速度與電位、電泳可動度、電導度、帶電復合粒子、帶電多孔性粒子、任意電雙層厚度。
  6. The result shows that with the addition of rare earth elements, ultrasonic irradiation and magnetic field, the chemical component, surface configuration, microstructure and properties of electroless co - ni - b and co - fe - b alloy changes remarkably. such kind of change can be described as the followings. firstly the depositing speed of electroless alloy bath is raised while the polarizability and cathodic overpotential are reduced ; secondly the surface quality of the alloy coating and adhesion of the coating and matrix are improved ; thirdly in the coatings the content of the elements in the transient group increases, but the content of cobalt decreased ; fourthly the amorphous structure is transformed to microcrystal structure and polycrystal structure ; fifthly the microhardness and wear resistance of the coating are enhanced ; sixthly coercitive force is reduced, and magnetoconductivity of the coating is increased ; lastly the magnetic intensity of the coating increases with the addition of energy and light rare earth elements such as ce, la and decreases with the addition of heavy rare earth elements such as y. on the other side, when the alloy coatings passes through the heat treatment under the temperature of 250 or 500, their properties will change

    結果顯示化學沉積co - ni - b 、 co - fe - b工藝在稀土元素（ ce 、 la 、 y 、 dy ） 、能量（超聲波、磁場）介入后，沉積過程、合金成分、鍍層形貌結構和性能都有顯著變化，表現在：鍍液的陰極極化過電位和極化度降低，沉積速度提高；鍍層的結合力、表面質量改善；鍍層中過渡族元素的含量增加，輕元素硼的含量降低，同時證實了稀土元素與過渡族元素共沉積的可能性；鍍層的顯微結構由非晶態向微晶和多晶態轉變；鍍層的顯微硬度與耐磨性提高，力學性能優化；鍍層的矯頑力降低；磁導率提高；鍍層的磁化強度在能量（超聲波、磁場）和輕稀土元素ce 、 la介入后提高，重稀土元素y介入后降低。
  7. When sn2 + concentration in the bath is lower, sn2 + activity is not enough causes slow deposition rate and slow growth rate of crystallizing nucleus, so crystalline granularity deposited is smaller ; when sn2 + concentration in the bath is higher, the dispersive ability of the bath decreases and the surface quality of the deposits sets worse

    鍍液中sn ~ （ 2 + ）濃度較低時，離子活度不夠，沉積速度慢，晶核成長速度慢，使沉積的晶粒粒度較小； sn ~ （ 2 + ）濃度過高，鍍液分散能力降低，使鍍層的表面質量下降。
  8. The paper analyses the particle radial separating speed in inertia field and the dropping speed in the gravity field, determines the relations among the separating critical diameter, the rotate speed of screw, airflow speed and the radial size of separating interface, establishes and work out the separating diameter which value the separating effect of the new equipment

    根據物料的空氣阻力與離心分離理論分析了離心力場中粒子徑向分離速度及重力場中的粒子沉降速度，確定分離臨界粒徑與螺旋轉速、氣流速度及分離界面徑向尺寸等之間的關系建立了並求出了衡量此種新機型氣固二相流分離效果的衡量指標? ?分離粒徑。
  9. With the tracing particles, the sinking velocity of middle and higher density particles that pass through the lower density coal particles in jig bed for different jigging air circle were measured. the results showed that the air cycle with a long inlet period can promote the separation of middle and higher density particles and lower density coal particles

    運用彩色人工顆粒，對不同跳汰周期下中、高密度顆粒在低密度煤炭床層中的沉降速度進行了示蹤研究，確認長進氣期周期有利於中、高密度顆粒與低密度煤炭顆粒的分離。
  10. The setting velocity of a particle directly characterizes its reaction too flow.

    單顆泥沙沉降速度直接表現出它對水流的反作用。
  11. With the increasing initial orientation angle and length - width ratio, the drifting distance, the fluctuation of the orientation angle, lateral drifting velocity and rotation velocity all increase, while the final settling velocity decreases with the increasing length - width ratio

    初始取向角和長寬比增大，則粒子的橫向漂移以及取向角、側向漂移速度和轉動角速度的振蕩幅度都增大；同時隨著長寬比的增大，粒子的沉降速度相應減小。
  12. Based on comparison of several technical schemes, the method of sand bedding pre - elevating and step water - filling pre - compressing is adopted. so the dissertation is consist of two parts : ( 1 ) the applicability study for the method of sand bedding pre - elevating and step water - filling pre - compressing, including numerical analyses for the thickness of sand bedding, the consolidation, settlement and stability of foundation, drainage, possibility of foundation liquefaction under seismic loading, et al. ( 2 ) monitoring at construction stage and checking the effect of foundation treatment, including the measurements of the settlement velocity and non - uniform settlement of ring beam under the tank, pore pressures and horizontal displacements in foundation, the pressure distribution at the bottom of oil tank and the strength increase of soils

    通過多種技術方案比較，最終選擇了技術先進的砂墊層預抬高分級充水預壓法，論文工作主要由以下兩部分組成： （ 1 ）砂墊層預抬高分級充水預壓法的適用性研究，其中包括砂墊層厚度、地基沉降與固結度、地基穩定性、降水、地震作用下砂土液化的可能性等方面的計算分析； （ 2 ）施工監測與地基處理效果檢驗，其中包括油罐環梁基礎沉降速率與不均勻沉降程度、各分級充水加載階段地基超靜孔壓與深層水平位移、油罐底板壓力分佈及地基土強度增長等方面的實測與數據分析。
  13. It is suggested in this paper that the sediment of the high stand system tract is mainly composed of fine - grained sediment, hardly of the large scale of fluvial - delta because of the low dip of the ramp, low subsiding rate and low sedimentary rate in basin

    研究表明，盆地基底沉降幅度小、坡度極為平緩、沉積速率很低，因此導致層序內的高位體系域多以細碎屑沉積為主，大型河流三角洲沉積基本不發育。
  14. The indoor experiments and field investigation are applied to find the settlement speed of high earth fill subgrade. the steadiness of high earth fill sub - grade is discussed with random finite element data analysis method

    本課題擬通過設定的室內試驗及對室外試驗路段的觀測來尋求高填方路基的沉降速度，並作了隨機有限元數值分析，對高填方路基的穩定性方面作一定探索。
  15. In the process of single fiber sedimentation, it is steady that the fiber axis orients horizontally. the terminal sedimentation rate and the lateral shifting rate increase with the particle aspect ratio. the fiber with the aspect ratio of about 2. 8 rotates fastest to the stable location

    對于單根纖維的沉降，其穩定取向是軸線與重力方向垂直的方向；纖維的沉降速度隨長徑比的增加而增加，但趨勢變緩；纖維的橫向漂移隨長徑比增加而增加；長徑比在3左右的纖維，旋轉到穩定取向的速度最快。
  16. This paper, as for the contradiction happened in design, construction, acceptance check when the quality of the project was needed and the building speed is different in every section of the road, the residual settlement a h is needed to be less than the standard value, launches the project - - - - - - the analysis on the settling velocity o f high earth fill sub - grade and the study of stability

    本文主要是針對近幾年來在設計、施工、竣工驗收在工程質量評定中所出現的矛盾? ?一條公路少至幾公里至幾十公里，甚至上百公里，由於各個標段完工速度不一致，其剩餘沉降值（即竣工驗收時） h要求小於「評定標準」 （即垂直變形3cm ） ；而進行的《高填方路基沉降速度分析與穩定性研究》課題研究。
  17. Aim at the shortage in actual application that the frp pipe flange joint with the steel pipe and steel parts, in consideration of the special advantage of the adhesive boned joint, put forward the method that the steel flange adhesive boned steel pipe or steel part after the steel flange instead the frp pipe flange, or the frp pipe adhesive boned direct with the steel and steel part, it can reduce the stress concentration problem that cause from the different of the descend speed and the hot bulge or freeze coefficient in the applied process. thus reduce the damage number and the maintenance costs of the piping, so this method can have the greatly actual application value

    針對玻璃鋼管道與鋼管及鋼管件之間法蘭連接方式在實際應用中的不足之處，考慮到膠接連接的獨特優勢，提出如用鋼法蘭代替玻璃鋼法蘭與玻璃鋼管道膠接后，再與配套的鋼管及鋼管件進行連接，或玻璃鋼管道直接與鋼管（件）進行膠接連接，則可減少玻璃鋼管道在應用過程中與鋼管（件）連接后因沉降速度及凍脹系數均不同而產生的應力集中問題，減少管道的損壞次數及維護成本，有很大的實際應用價值。
  18. The maximal depth of source rock in china is distributed in 3000 - 4000 metres, the average subsidence rate of a basin is no more than 100 metres each million year, and maximal subsidence rate is more than 300 metres each million year ; the uplift rate is also no more than 100 metres each million year, and maximal uplift rate is more than 300 metres each million year, the maximal degradation thickness is more than 2000 metres

    中國含油氣盆地烴源巖最大埋深主要分佈在3000 - 4000m 。盆地沉降速率一般在100m / ma的范圍內，最大可達300m / ma ；經歷抬升型盆地抬升剝蝕速率一般在100m / ma的范圍內，最大也可達300m / ma ，剝蝕厚度最大可大於2000m 。
  19. In this paper, wastewater is looked on as solid - liquid two - phase flow. firstly, the sedimentation of the particles in fluid was analyzed, and some equations was induced under different flow conditions. this set a base for the velocity in the next chapters

    本文將污水視為固液兩相流，首先對顆粒在流體中的沉降理論進行了分析，從中得出沉降速度在不同流動狀態下的表達式，為後面分析顆粒的起動、揚動、止動流速與管道運行臨界不淤流速打下了一定的基礎。
  20. The tectonic movement controls different types of sequences by controlling subsidence of basement and sediment supply rate

    構造運動通過控制基底的沉降幅度和物源供給速度控制層序類型。
分享友人
分享到 Line

分享到臉書