沉降電極 的英文怎麼說

中文拼音 [chénjiàngdiàn]
沉降電極 英文
agglomerator section
  • : Ⅰ動詞1 (沉沒; 墜落) sink 2 (沉下 多指抽象事物) keep down; lower 3 [方言] (停止) rest Ⅱ形容...
  • : 降動詞1. (投降) surrender; capitulate 2. (降伏) subdue; vanquish; tame
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : i 名詞1 (頂點; 盡頭) the utmost point; extreme 2 (地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 電極 : electrode; pole
  1. In this thesis, in order to reducing the amount of the pt catalyst, improving the electrocatalytic activity of the pt catalysts and utilization ratio of pt, the electrochemical codeposition method by cyclic voltammetry ( cv ) was used to prepare a series pt / moox / glassy carbon ( gc ) composite electrodes with high dispersibility. the composite electrode, pt / moox / gc, was characterized to study its composition and its electro chemical behavior by cv. using the xrd and sem techniques, the size and the dispersion degree of the catalyst particles were studied in presence or absence of moox in the catalyst

    為了低主催化劑pt的用量、提高pt的活性和利用率,本論文利用循環伏安法共積制備高分散的pt moo _ x催化劑顆粒,利用循環伏安化學表徵、 xrd和sem技術研究了引入moo _ x后的催化劑即pt moo _ x顆粒的粒子大小、分散狀態;利用icp - aes定量分析pt moo _ x催化劑顆粒的組成含量;並藉助于化學方法分別評價了pt moo _ x gc催化劑的對甲醇的催化活性和穩定性、氧還原催化活性。
  2. Using diethanolamine as aminating agent and glacial acetic acid as neutralizing agent, aminated epoxy acrylic cationic resin was prepared. the effect of technology of aminated epoxy acrylic resin on properties of eletrodeposition was studied by conductivity meter and electrophoresis apparatus. it was shown that, conductivity firstly decreased, and then increased with aminating temperature increase. in contrast with putting polyacrylic resin into thin acetic acid solution, the more compact film could be achieved by neutralizing polyacylic resin with glacial acetic acid and then add it into water. when neutralizing temperature was enhanced, the speed of electrodepsidon was found to increase, and the film was also more compact. increasing the dn leads to enhanced conductivity and smaller particle size. when dn equaled to 80, the smoothest film could be achieved

    以二乙醇胺為胺化劑、冰醋酸為中和劑,合成了胺化環氧丙烯酸陽離子樹脂.採用泳儀和導率儀,研究了胺化環氧丙烯酸樹脂合成工藝對陰泳塗料積性的影響.結果表明,隨著胺化溫度的增加,泳液導率先下後上升.將冰醋酸加入樹脂中中和,後用水稀釋,比樹脂在醋酸稀溶液中中和,積性能更好.積速率隨著中和溫度的上升而增加,積膜緻密性相應增加.中和度( dn )愈高,泳液導率愈大,粒徑越小,而塗膜外觀在中和度為80時達到最佳
  3. The result shows that with the addition of rare earth elements, ultrasonic irradiation and magnetic field, the chemical component, surface configuration, microstructure and properties of electroless co - ni - b and co - fe - b alloy changes remarkably. such kind of change can be described as the followings. firstly the depositing speed of electroless alloy bath is raised while the polarizability and cathodic overpotential are reduced ; secondly the surface quality of the alloy coating and adhesion of the coating and matrix are improved ; thirdly in the coatings the content of the elements in the transient group increases, but the content of cobalt decreased ; fourthly the amorphous structure is transformed to microcrystal structure and polycrystal structure ; fifthly the microhardness and wear resistance of the coating are enhanced ; sixthly coercitive force is reduced, and magnetoconductivity of the coating is increased ; lastly the magnetic intensity of the coating increases with the addition of energy and light rare earth elements such as ce, la and decreases with the addition of heavy rare earth elements such as y. on the other side, when the alloy coatings passes through the heat treatment under the temperature of 250 or 500, their properties will change

    結果顯示化學積co - ni - b 、 co - fe - b工藝在稀土元素( ce 、 la 、 y 、 dy ) 、能量(超聲波、磁場)介入后,積過程、合金成分、鍍層形貌結構和性能都有顯著變化,表現在:鍍液的陰化過位和化度低,積速度提高;鍍層的結合力、表面質量改善;鍍層中過渡族元素的含量增加,輕元素硼的含量低,同時證實了稀土元素與過渡族元素共積的可能性;鍍層的顯微結構由非晶態向微晶和多晶態轉變;鍍層的顯微硬度與耐磨性提高,力學性能優化;鍍層的矯頑力低;磁導率提高;鍍層的磁化強度在能量(超聲波、磁場)和輕稀土元素ce 、 la介入后提高,重稀土元素y介入后低。
分享友人