油壓型控制器 的英文怎麼說

中文拼音 [yóuyāxíngkòngzhìqì]
油壓型控制器 英文
oil hydraulic type controller
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 壓 : 壓構詞成分。
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 油壓 : [機械工程] oil pressure
  • 控制器 : controller; regulator; monitor; pilot; keyer; manipulator; control unit; control device; [自動化]...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  2. In oilfield, feeder line of 6kv often has many branches. the pole high voltage automotive capacitor compensation system controlled by single chip computer is designed for this situation. in the system, we separate the measure position and compensation position and realize the supervision of reactive load in local area

    文章以油田6kv輸配電線路為例，針對多分支樹狀結構線路的特點，研製出由單片機系統控制的戶外術上型高壓電容器自動補償系統。
  3. Its current products include : top oscillation electrical precipitator, side electrical oscillation precipitator, magnetism controlled static electricity precipitator, wet electrical precipitator, honeycomb electric catching tar instrument, high - pressur silicon rectifier equipment and plc low - pressure controlling system, blast furnace gas impulse precipitator, high concentration pulverized coal collector, coke oven and boiler flue gas low pressure impulse precipitator, blower fan inhaler, crossing piping gas cooler, high temperature fume cooler, gyre - orientation impulse hop - pocker and all sorts of molded sections

    目前主要產品有：頂部振打臥式電除塵器、側部振打電除塵器、磁控靜電除塵器、濕式電除塵器、蜂窩電捕焦油器、高壓硅整流裝置及plc低壓控制系統、高爐煤氣脈沖除塵器、高濃度煤粉收集器、焦爐及鍋爐煙氣用低壓脈沖除塵器、風機空氣過濾器、橫管式煤氣冷卻器、高溫煙氣冷卻器、回轉定位脈沖大布袋及加工各種冷彎型鋼。
  4. The system is different from traditional silicon controlled dephasing method, such speedy modules as whole controlled electric and electronic equipment igbt and high frequency pwm controlling methods are employed, and the voltage of exchanging power supply of motor of beam pumping units can be controlled automatically, so there is no problem of power factor being decreased brought by silicon controlled phase single controlled, power factor in power net of beam pumping units " motor is enhanced really

    由於雙管齊下，電機電網側的功率因數得到了大大提高。與傳統的可控硅移相控制方式不同，本系統採用全控型電力電子器件igbt等快速模塊及高頻pwm控制方式，對抽油機電機的交流供電電壓進行自動控制，不存在可控硅相控角所帶來的功率因數變差的問題，真正提高了抽油機電網側的功率因數。
  5. For the existing transformer cooling control system has many shortcomings such as the complicated system control circuit, the low reliability, the protection methods of blower fan being so simple, large control error, high fault rate, massive maintenance work and no method to realize telecommunication, this thesis develops a novel intelligent power transformer air - cooled control system based on the center of microprocessor through all - round technology analysis and research

    本文針對變壓器冷卻系統使用常規控制系統存在的系統控制迴路復雜、可靠性低、風機的保護方式簡單而無法進行故障預測、主變壓器油溫測量精度低造成控制誤差大、故障率高、維護工作量大、無法實現遠程通訊等問題，經過多方面的技術分析和調研，設計開發了新型的以微處理器為核心的智能式電力變壓器風冷卻器控制系統。
  6. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況，在回顧電梯液壓控制系統節能技術的基礎上，介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能控制系統研究」的基本原理，分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式；詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計，重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成控制閥組的設計等內容；最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。
  7. The force control of suspension bridge anchorage cable is the main contents which will be researched. according to the character of suspen - sion bridge anchorage, three questions is solved in this paper on the basis of the construction control experience of the highway bridge of yichang yanzhi river. firstly, an effective method of cable force control is presented in this paper, which has settled the puzzle of cable force accurate operate through fixing a pressure transducer at the behind of the hydraulic jack. secondly, an exactitude calculation model is founded in this paper. in addition the influence of boundary condition, sag, inclination, flexural rigidity and environment temperature to the cable vibration frequency which make the frequency method could be used to the measurement of cable force. in the end of this paper, a control system of anchorage cable force is developed on the basis of the above research. this system is very steady, credible, high precision and convenient. it is a new and credible method to be used to the force control of sus - pension bridge anchorage cable. in this paper, the conundrum of cable force control has been solved. the fruits are very useful to the development of inland suspension bridge

    提出了一種有效可行的錨跨張力控制方法，即通過在油壓千斤頂后加壓力傳感器，並利用單片機技術進行數據採集，解決了懸索橋錨跨索股初張力精確控制的難題；建立了錨跨索股索力的精確計算模型，分析了索股的邊界條件、斜度、垂度、抗彎剛度及環境溫度對索股頻率的影響，解決了弦振法在大跨徑懸索橋索力測試中的應用問題；在上述研究成果的基礎上，研製出了錨跨張力控制系統，該系統具有穩定可靠，精度高，使用方便等特點，它的投入使用將為我國今後大跨徑懸索橋錨跨張力控制提供一種全新的、可靠的手段。
  8. The sprayer is usually connected with water supply network, control value, detection alarm unit, etc. to form an automatic water spray system ( such as sprinkler fire - extinguishing system ) for saving electrical equipment, fighting burning flammable liquid, etc. it is widely used for fire control and cooling protection for such equipment / places as power plant * generating machinery, large size transformer, liquefied petrolatum tank, factory, shopping mall, hotel, warehouse, storied building and so on

    該水霧噴頭通常與供水管網、控制閥門、控測報警器等組成自動噴水滅火系統（如雨淋噴水滅火系統等） ，用來撲救電氣設備，可燃液體火災等，廣泛用於保護電廠的發電設備，大型變壓器，液體石油儲罐、工廠、商場、賓館、倉庫、樓房等必須滅火、控火或防護冷卻等場所。
  9. Because it was trouble to control the heavy apron type feeder ' s rotate speed, the paper put forward a new method to achieve control the hydraulic motor speed efficiency by control electro motor rotate speed in transducer to control the hydraulic liquid flux of varable delivery pump

    摘要文章針對重型板式給礦機速度控制困難，提出了用變頻器控制電機轉速來控制變量泵液壓油流量，以實現對液壓馬達速度的調節方法。
  10. Hyoda brand thermometers are used widely for the automation of temperature management and control and as a danger alarm measure for use with heavy electrical machinery such as electric power generators, transformers, miscellaneous food processing - use machinery and devices, oil refinery and petrochemical plant equipment

    主要廣泛用於發電機變壓器等的重型電機食品用的各種機械裝置或石油精製化學成套設備等的溫度管理控制自動化或危險警報等。
  11. Based on theories of hydraulic and nonlinear control system, this paper analyses the force of oil film in the hydro - viscous drive, and establishes its mathematic model

    在液壓流體力學理論和非線性控制理論的基礎上，對液粘制動器中的油膜的受力進行了研究並建立其數學模型。
  12. New breakthroughs are obtained in manufacturing large - scale ultrahigh pressure container, design of ultrahigh hydraulic pressure system, design of multi - media large delay nonlinear control system, detecting state of device tested under simulation environment, modeling of in - well environment of oil field

    並在大型超高壓容器製造、超高壓液壓系統的設計、多介質大延時非線性控制系統設計、模擬環境中試驗設備工作狀態的檢測、油井井下環境的建模等方面取得了新的突破。
  13. Wide plus 8 series miniature pressure transmitter is widely applied for industrial process field pressure measurement and control such as aerospace, petroleum, chemical industry, metallurgy, electric power and water conservancy by the fine reliability and wide applicability, flexibility and multiplicity of the product

    Wide plus - 8系列精小型壓力變送器以其優良的可靠性，廣泛的適用性，產品的靈活性和多樣性，廣泛應用於航空航天石油化工冶金電力水利等工業過程現場壓力測量和控制。
分享友人
分享到 Line

分享到臉書