油壓法 的英文怎麼說

中文拼音 [yóuyāfǎ]
油壓法 英文
test method for wool content of raw wool by oil pressure method
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 壓 : 壓構詞成分。
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 油壓 : [機械工程] oil pressure
  1. " investigation showed that the culprit used high - pressure tanks, which were stuffed with activated carbon for filtration process, to decolourize the industrial marked oil

    海關發言人說：調查所得，不法份子利用高壓泵原理的化油方法，以減少化油時間。
  2. " the vessel is also equipped with a hydraulic crane for launching and retrieving its high - speed small craft used for intercepting boats suspected of smuggling goods and illegal immigrants

    新船更設有油壓起重機，可放出及收起高速小艇，以便攔截進行走私及非法入境活動的船隻。
  3. The litter - resistance slowly closing butterfly check valve is developed a newest product based on our butterfly check valve, hydra - matic transmission to be add in the valve with unique design, new stuction and optimum performance, can be used pipeline of water supply and dring with such media : fresh water, sea water, sewage, raw water, ect. the valve should be installed at outlet of the water pump, in stapping the pump, the process of slowly closing after valve plate shuts rapidly. can be guard effectively against the destruction water hummer, so to ensure the safe operation of the pipline

    微阻緩閉蝶式止回閥是在我廠生產的蝶式雙瓣止回閥的基礎上利用能量轉換原理增設油壓緩閉裝置的新型模式止回閥，設計獨特，結構新穎，性能優宜，適用於凈水，源水，污水，海水等介質的供、排水管路中，安裝於水泵出口端，停泵時由於油壓阻尼作用法盤先速閉后緩閉，以消除破壞性水錘，保證灌路安全運行。
  4. A minor hydraulic leak detected, we are unable to stop the leak but it is not very serious

    查明液壓系統輕度漏油，無法停止漏油，但情況並不嚴重。
  5. The performance experiments of emulsified diesel oil are done on a 1135 diesel engine. by a lot of experiment data and charts, the factors that influence the combustion effect are analyzed, including the factors of emulsified fuel self such as emulsifiers, water content, emulsifying way, and the factors of diesel engine such as fuel injection advance angel, injection pressure, load, model of engine, and so on

    在1135柴油機上進行了乳化柴油的臺架試驗，通過大量試驗數據及圖表分析了影響乳化油燃燒效果的因素，包括乳化油自身的因素如乳化劑、含水量、乳化方法等，以及發動機的狀況與參數如噴油提前角、噴油壓力、工況、機型等。
  6. To start vehicle rapidly and smoothly, a kind of method based on fuzzy technique to control the engaging - pressure of wet - clutch has been established. fuzzy control will achieve the following advantages : the engine can be controlled to be operated steadily during lower speed and the starting noise can be reduced

    為了實現汽車起步的迅速和平穩，建立了基於模糊技術控制濕式離合器油壓的計算方法，該控制方法的優點表現在汽車起步過程中控制發動機在低速下穩定運行，縮短起步時間，減少起步沖擊。
  7. Verification regulation of hydrostatic tank gauging

    靜壓法油罐計量裝置檢定規程
  8. A method based on the application of an injection process analysis software is introduced in this article, which optimize injection process through changing the design of fuel - injection pump cam. a model of 1115 single cylinder direct injection diesel engine is used as an example. with the help of pre - journey optimization, increasing cam lift and using tangent - function can make the matching of the injection system with the diesel more reasonable. without changing fuel pump installing size, it can enhance injection rate and injection pressure and improve the diesel operating stability in low speed condition

    本文以國產1115型單缸直噴柴油機為例，介紹一種應用噴油過程分析軟體改進噴油泵凸輪設計的方法，通過增大噴油泵凸輪升程、採用切線函數凸輪並優化預行程的方式，在不改變噴油泵安裝尺寸的前提下，可提高噴油壓力和噴油速率，改善柴油機低速工作穩定性，使噴油系統與柴油機匹配更合理。
  9. The force control of suspension bridge anchorage cable is the main contents which will be researched. according to the character of suspen - sion bridge anchorage, three questions is solved in this paper on the basis of the construction control experience of the highway bridge of yichang yanzhi river. firstly, an effective method of cable force control is presented in this paper, which has settled the puzzle of cable force accurate operate through fixing a pressure transducer at the behind of the hydraulic jack. secondly, an exactitude calculation model is founded in this paper. in addition the influence of boundary condition, sag, inclination, flexural rigidity and environment temperature to the cable vibration frequency which make the frequency method could be used to the measurement of cable force. in the end of this paper, a control system of anchorage cable force is developed on the basis of the above research. this system is very steady, credible, high precision and convenient. it is a new and credible method to be used to the force control of sus - pension bridge anchorage cable. in this paper, the conundrum of cable force control has been solved. the fruits are very useful to the development of inland suspension bridge

    提出了一種有效可行的錨跨張力控制方法，即通過在油壓千斤頂后加壓力傳感器，並利用單片機技術進行數據採集，解決了懸索橋錨跨索股初張力精確控制的難題；建立了錨跨索股索力的精確計算模型，分析了索股的邊界條件、斜度、垂度、抗彎剛度及環境溫度對索股頻率的影響，解決了弦振法在大跨徑懸索橋索力測試中的應用問題；在上述研究成果的基礎上，研製出了錨跨張力控制系統，該系統具有穩定可靠，精度高，使用方便等特點，它的投入使用將為我國今後大跨徑懸索橋錨跨張力控制提供一種全新的、可靠的手段。
  10. Hydraulic fluid power - test method for electrically controlled oil hydraulic pumps

    液壓流體動力.電控油壓泵試驗方法
  11. Based on comparison of several technical schemes, the method of sand bedding pre - elevating and step water - filling pre - compressing is adopted. so the dissertation is consist of two parts : ( 1 ) the applicability study for the method of sand bedding pre - elevating and step water - filling pre - compressing, including numerical analyses for the thickness of sand bedding, the consolidation, settlement and stability of foundation, drainage, possibility of foundation liquefaction under seismic loading, et al. ( 2 ) monitoring at construction stage and checking the effect of foundation treatment, including the measurements of the settlement velocity and non - uniform settlement of ring beam under the tank, pore pressures and horizontal displacements in foundation, the pressure distribution at the bottom of oil tank and the strength increase of soils

    通過多種技術方案比較，最終選擇了技術先進的砂墊層預抬高分級充水預壓法，論文工作主要由以下兩部分組成： （ 1 ）砂墊層預抬高分級充水預壓法的適用性研究，其中包括砂墊層厚度、地基沉降與固結度、地基穩定性、降水、地震作用下砂土液化的可能性等方面的計算分析； （ 2 ）施工監測與地基處理效果檢驗，其中包括油罐環梁基礎沉降速率與不均勻沉降程度、各分級充水加載階段地基超靜孔壓與深層水平位移、油罐底板壓力分佈及地基土強度增長等方面的實測與數據分析。
  12. Because the hydraulic oil cannot replace the brake fluid in caliper disc brake, a dual fluid power converter, which can both retain the advantages of full power hydraulic brake system and lower the cost of the whole machine, has been designed

    因普通液壓油無法替代使鉗盤式制動器工作的制動液，設計了既能保持全動力液壓制動系統優點，又能降低整機製造成本。
  13. Based on research of theory and methods, this thesis presents design scheme of the dynamic fault tree analysis platform dfta and implement the platform ; practices a dynamic fault tree analysis example of boeing 707 plane engine oil indication system and alarm system on the platform and gets top event occurrence rate 、 minimal cut sequence 、 probability importance sequence 、 structure importance sequence and critical importance sequence and presents system improvement suggestion based on the analysis results

    在理論方法研究的基礎上，本文提出了動態故障樹分析平臺dfta的設計方案，並進行了實現;利用該軟體對波音707飛機發動機滑油壓力指示和警告系統進行了動態故障樹實例分析，得到了頂事件發生概率、最小順序割集、概率重要度排序、結構重要度排序、關鍵重要度排序等分析結果，並根據上述分析結果提出了系統設計改進建議。
  14. Complying method of the symbols for governors and oil pressure supply units of hydraulic turbines

    水輪機調速器及油壓裝置.型號編制方法
  15. Add up to the oil deposit carries on parameters such as year, month output, daily output and oil pressure moisture content etc, and uses the man - made nerve communication method to analyze the nonhomogeneity characteristic of seam cave mould oil deposit system

    油氣從地層向井筒的動態滲流過程，直接受儲層各向異性影響。對油藏進行年度、月產量、日產量、油壓含水率等參數統計，利用人工神經網路方法分析縫洞型油藏系統的非均質特徵。
  16. In the research on pid control, a method, which weakens integral when the control value exceeds the limit, is introduced. a new method combining the experiential and the orthogonal method is used to determine the parameters of pid, which can reduce the amount of experiment

    在pid控制研究中，採用遇限制削弱積分方法進行油壓控制，並提出經驗法和正交試驗法相結合的方法整定pid參數，從而獲得pid參數對控制影響的主次和規律，減少了試驗工作量。
  17. Analyzing the sound characteristics of each part in frequency domain, it will be a guidance to the resolution in attenuating the engine ' s noise level

    經與九點聲壓法測量得到的整機噪聲結果對比，表明表面振動法識別柴油機噪聲源是準確可靠的。
  18. On the basis of researches above, the database of cost estimating function of mechanical product are constructed. the software system of cost estimating and analysis of mechanical product is developed. the effectiveness of cost estimating method is validated by piston shaft of oil damper

    在上述研究的基礎上，建立了機加工成本特徵估算函數支持庫，研製和開發了機械製造產品成本估算與分析軟體系統，以油壓減振器中活塞軸為實例，驗證了估算方法的有效性。
  19. An algorithm about calculating frequency of motor vehicle brake oil pressure

    一種計算汽車制動油壓波動頻率的演算法
  20. The research work focuses on the following four main investigations : 1. theory of fluid system design for adjustable linear oil damper by use of dynamic mathematical models and dynamic - parameter - compensat ing method, the first research of this item has established the generalized optimiz - - ation mathematical model of the fluid system of an adjustable linear oil damper ; by use of the mechanical generalized optimization theory and platform, the first research has also made a multi - objective and overall - performance optimal design to the fluid system which gives the damper both the best damping performances and the best economic capacities ; by modeling the whole damper and analyzing it by numerical method, the second research of this item has solved the problem of the damper ' s dynamical damping characteristics calculation, simulation and analysis

    主要涉及以下四個方面的內容： 1 、可調式線性油壓減振器阻尼系統的設計理論採用動態數學模型和動態參數補償的方法對可調式線性油壓減振器的阻尼系統進行了廣義優化設計建模；運用機械廣義優化設計理論和平臺對可調式線性油壓減振器的阻尼系統進行了多目標、全性能的優化，實現了其技術性能和經濟性能的綜合優化設計；通過對整個油壓減振器進行建模與數值分析，解決了工程上對多級擬合線性油壓減振器的阻尼性能進行求解、對其動態特性進行分析的難點。
分享友人
分享到 Line

分享到臉書