油壓調節閥 的英文怎麼說

中文拼音 [yóuyādiàojiéfá]
油壓調節閥 英文
oil pressure adjusting valve
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 壓 : 壓構詞成分。
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 閥 : 名詞1 （指在某方面有支配勢力的人物或家族） established house or power group; a powerful person or...
  • 油壓 : [機械工程] oil pressure
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. When the governing valve was series - connected on the return oil - line in the metering - out control system, under the same flow area and the same adjusted pressure of relief valve, with the incremental quantity of step load, the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod increased, meanwhile, it ' s time of rise, time to peak and the governing time all increased. at the same time, the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased

    當出口節流調速系統的回油路上串接調速閥時，隨階躍負載的增加，在相同流量閥開度、相同溢流閥調節壓力的情況下，液壓缸有桿腔壓力p _ 2 （ t ）的超調量是增加的，上升時間、峰值時間以及調整時間也是增加的；液壓缸無桿腔壓力p _ 1 （ t ）的超調量是增加的。
  2. The cooling system for engine adopted hydraulic drive and control technology to control the speed of the fan : the chip adjust the control - current of the proportional value, which used in the engine cooling system, to control the speed of the fan. and the size of the control - current is according to the coolant temperature, coolant temperature change rate and target temperature. as for as the hydraulic cooling system we used a motor to drive and control the fan ’ s work or stop according to the temperature of the hydraulic oil

    該系統的特點及其實現的功能為:電液混合驅動方式改變了工程機械冷卻裝置驅動方式單一的缺點，發動機冷卻系統採用了電液比例技術控制風扇轉速;單片機可以根據冷卻液溫度、冷卻液溫度變化率和目標冷卻液溫度調節液壓驅動系統中電液比例閥的控制電流，進而控制液壓油的流量，即可以實現冷卻風扇轉速的連續調節;液壓油冷卻系統採用了電動機驅動，然後由單片機根據液壓油的溫度控制電動機的起動和停止。
  3. The centrifugal pump for oilfield waterflooding and oil transfer worked with low pump efficiency owing to unstable load and its energy loss is fairly large

    油田注水集輸系統離心泵由於載荷經常變化，大多不能在其額定工況點工作，泵效低，且需要用泵出口閥調節流量，產生一定的泵管壓差，造成較大的能量損失。
  4. Makers of quality custom molded fiberglass products for water and wastewater treatment. product range includes flumes, shelters, weirs, odor control hoods and baffles

    -銷售爐頭，閥門，調節閥，助燃風機及其它燃油-空氣調節閥，節流閥，切斷閥，減壓閥等產品。
  5. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況，在回顧電梯液壓控制系統節能技術的基礎上，介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能控制系統研究」的基本原理，分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式；詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計，重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成控制閥組的設計等內容；最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。
  6. Besides, parker is also a famous supplier for refrigeration and air conditioning components including all kinds of sporlan products, such as mechanical and electric expansion valves, solenoid valves, filter driers, sight glasses, level master liquid controls, mechanical and electric pressure regulating valves, check valves, shut off valves, oil separators, and other industrial valves for r717 etc

    除此之外，派克漢尼汾還是一家全球著名的冷凍與空調另部件的供應商，其中包括美國斯坡蘭生產的各種產品，如，機械的和電子的膨脹閥，電磁閥，乾燥過濾器，視鏡，液位控制器，機械的和電子的壓力調節閥，單向閥，截止閥，油分及工業用氨閥等等。
  7. This mode of valve is a kind of brand - new patent electromagnetic valve developed by this co., with an electromagnetic block as the auxiliary valve and not directly acting on the switch valve while only through adjusting the force difference between the media to get the switch valve, having lower energy consumption, longer duration, more stable performance etc. notable feratures, compared with the traditional electric valves, and extensively used for various water etc. liquids control system

    A型閥是我公司開發的一種新型專利電磁閥。電磁塊作為輔閥，不直接作用於開關閥，僅調節介質壓力差獲得開關閥，與傳統電動閥相比具有耗能低壽命長性能穩定等顯著特點。廣泛應用於各種控水油等流質的控制系統。
  8. The research indicated that, if the secondary combustion chamber was looked on as a controlled object, with the adjusting valve as a input, the pressure and the temperature of a selected point on the inside wall of the combustion chamber as outputs, then such controlled system would be a strongly non - linear, time varying system with number of random disturbances, which resulted in huge difficulty to build an analyzed mathematics model for the spray burning of the liquid fuel, so that classic control methods were all invalid

    研究表明，若將rbcc發動機的二次燃燒室視為一個控制對象，同時以燃燒室內壁面取定點處的壓強、溫度和調節閥的開度為輸入輸出變量，則該系統將是輸入?輸出特性非線性很強、隨機干擾嚴重的復雜時變系統。這導致建立燃油噴霧燃燒具體模型的很大困難，從而宣告了經典控制方案的失效。
  9. The proportional relief valve is used to adjust control the pressure of hydraulic oil, therefore controls the brake moment by adjusting the thickness of oil film

    用電液比例溢流閥對控制油壓進行調節，從而調節油膜的厚度來控制制動力矩。
  10. The fcr / pcr regulators offer maximum control and fuel efficiency on applications involving preheated air to the burners, or where burners are firing against varying back pressures

    Pcr調節閥具有最好的控制性能和最大的燃油效率，應用領域包括爐頭預熱空氣，或者燃燒爐頭工作在爐內壓變化很大的情況下。
  11. Standard for safety for pressure - regulating valves for lp gas

    液化石油氣壓力調節閥的安全標準
  12. Accorded to the experimental research, under different flow area of flow valve and different adjusted pressure of relief valve, conclusion that the regulation of the pressure p1, p2 in the two cylinder chambers varied with the change of step load were as follows : when the throttle valve was series - connected on the return oil - line in the metering - out control system, under the same flow area and the same adjusted pressure of relief valve, with the incremental quantity of step load, the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod decreased, meanwhile, it ' s time of rise, time to peak and the governing time all decreased. while the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased

    通過試驗研究得出系統在不同的流量閥開度、不同溢流閥調節壓力（進口壓力）下，液壓缸兩腔壓力p _ 1 、 p _ 2隨階躍負載變化的規律：當出口節流調速系統的回油路上串接節流閥時，隨階躍負載的增加，在相同流量閥開度、相同溢流閥調節壓力的情況下，液壓缸有桿腔壓力p _ 2 （ t ）的超調量是減小的，上升時間、峰值時間以及調整時間也是減小的；液壓缸無桿腔壓力p _ 1 （ t ）的超調量是增加的。
  13. This constant - pressure hydraulic power adopts plvc4 programmable logical controller for valve to control the electro - hydraulic proportional relief valve to adjust the pressure at the entrance of the servo valve and makes it change with the pressure change at the exit thus to keep the pressure difference constant

    此恆壓油源採用閥用可編程式控制制器plvc4控制電液比例溢流閥調節伺服閥入口壓力，使其跟隨伺服閥出口壓力變化，達到入出口壓力差值恆定的目的。
  14. If by their ticket enforcement agencies use the power, control valves can be divided into pneumatic, electrical, fluid movement three, namely to compressed air to power sources pneumatic - valve to call for the engine electric control valves for the liquid medium ( such as oil ) pressure - driven electricity fluid moving control valves, and their functions and characteristics hours are electromagnetic valves, electronic style, smart, floor bus - control valves

    如果按其所配執行機構使用的動力，控制閥可以分為氣動、電動、液動三種，即以壓縮空氣為動力源的氣動調節閥，以電為動力源的電動控制閥，以液體介質（如油等）壓力為動力的電液動控制閥，另外，按其功能和特性分，還有電磁閥、電子式、智能式、現場總線型控制閥等。
分享友人
分享到 Line

分享到臉書