油泵軸油封 的英文怎麼說

中文拼音 [yóubèngzhóuyóufēng]
油泵軸油封 英文
pumshaft seal
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 泵 : 名詞（吸入和排出流體的機械） pump
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  1. Ma yan ? ying, liu jia ? qi. experimental investigation of oil film of port plate / cylinder block in axial piston pump j. lubrication engineering, 1999, 3 : 3539

    鄭煒， ?有雄，魯寶香.軸向柱塞泵配流副油膜的實驗研究j .潤滑與密封， 1995 ， 5 ： 3739
  2. Lqry series hot oil pump is supported by the ball bearings at the both ends, front end lubricated by lubricating oil, while back end lubricated by grease, with an oil conduit in the middle used to observe the conditions of sealing and recovery of heat conduction oil

    Lqry系列熱油泵的支撐採用了雙端球軸承支撐的結構形式，前端採用潤滑油潤滑，後端採用潤滑脂潤滑，中間有一導油管，用以隨時觀察密封情況和回收導熱油。
  3. Stern tube sealing oil pump

    艉軸管軸封油泵
  4. The reason for oil leak lies in the sealing problem of bearing box ends of centrifugal pump

    離心泵軸頭甩油實質是離心泵軸承箱兩端密封問題。
  5. Through the statistic analysis on the change of the melt gear pump working condition pre - and post - pet plant capacity increasing and concatenate direct spinning process, the reasons for the unsteady running were studied, the modification measures such as lubricating the oil groove with sliding bearing, mechanical sealing of the gear pump, decreasing the gear pump outlet pressure, changing the automatic speed increasing to hand speed increasing were put forward

    摘要通過對聚酯裝置增容和後接直紡長絲前後熔體齒輪泵工況變化的統計分析，研究其運行不穩定的原因，提出改造措施，包括滑動軸承潤滑油槽，齒輪泵的機械密封，降低齒輪泵出口壓力，改自動提速為手動提速等等。
分享友人
分享到 Line

分享到臉書