油缸出口 的英文怎麼說

中文拼音 [yóugāngchūkǒu]
油缸出口 英文
cylinder tapping
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • : 名詞1. (盛東西的器物) jar; jug; vat; crock 2. (缸瓦) earthenware with crude glaze 3. (像缸的器物) jar-like things
  • : Ⅰ名詞1 (人或動物進飲食的器官; 嘴) mouth 2 (容器通外面的地方) mouth; rim 3 (出入通過的地方) ...
  1. All our sugar came in little packets spirited out of restaurants in deep coat pockets, as did our jams, jellies, crackers ( oyster and saltine ), tartar sauces, some of our ketchup and butter, all of our napkins, and a very occasional ashtray ; anything that came with a restaurant table really

    我們所有的食糖都是小包裝的,是藏在深深的大衣袋裡,從餐館里順手牽羊帶來的,而我們的果醬、果凍、克力架餅干(耗和蘇打味) 、韃靼醬、一部分的番茄醬和黃、所有的餐巾紙、一個非常機緣下拿到的煙灰;所有確確實實可以從餐館桌子上得到的東西。
  2. When the governing valve was series - connected on the return oil - line in the metering - out control system, under the same flow area and the same adjusted pressure of relief valve, with the incremental quantity of step load, the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod increased, meanwhile, it ' s time of rise, time to peak and the governing time all increased. at the same time, the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased

    節流調速系統的回路上串接調速閥時,隨階躍負載的增加,在相同流量閥開度、相同溢流閥調節壓力的情況下,液壓有桿腔壓力p _ 2 ( t )的超調量是增加的,上升時間、峰值時間以及調整時間也是增加的;液壓無桿腔壓力p _ 1 ( t )的超調量是增加的。
  3. In the text, there analyzes the process of the mixture air and fuel in the two stroke gasoline engine and bring forward the specific solution to the improvementsing gasoline engine the high - press direct in - cylinder injection. this technology sprays the feul into the cylinder after the outlet vavle closed and scavengs the engine cylinder with pure and fresh air, which avoid the fuel escapes unburned

    本文分析了二沖程汽機混合氣形成過程,並提了具體的改進方案,用內高壓直接噴射技術進行改造。內高壓直接噴射是在發動機排氣關閉後向氣內噴射燃,使用純新鮮空氣進行掃氣,避免了燃短路損失。
  4. Relying on abundant technical power, advanced manufacturing technics and perfect detecting technology, the hydraulic - pressure oil cylinder series manufactured our company are exported to america, west europe, southeast asia and many other countries and regions

    本公司技術力量雄厚,生產工藝先進,檢測技術完善,生產的液壓系列到美國加拿大西歐東南亞等國家和地區。
  5. Accorded to the experimental research, under different flow area of flow valve and different adjusted pressure of relief valve, conclusion that the regulation of the pressure p1, p2 in the two cylinder chambers varied with the change of step load were as follows : when the throttle valve was series - connected on the return oil - line in the metering - out control system, under the same flow area and the same adjusted pressure of relief valve, with the incremental quantity of step load, the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod decreased, meanwhile, it ' s time of rise, time to peak and the governing time all decreased. while the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased

    通過試驗研究得系統在不同的流量閥開度、不同溢流閥調節壓力(進壓力)下,液壓兩腔壓力p _ 1 、 p _ 2隨階躍負載變化的規律:當節流調速系統的回路上串接節流閥時,隨階躍負載的增加,在相同流量閥開度、相同溢流閥調節壓力的情況下,液壓有桿腔壓力p _ 2 ( t )的超調量是減小的,上升時間、峰值時間以及調整時間也是減小的;液壓無桿腔壓力p _ 1 ( t )的超調量是增加的。
  6. 3. through experiment using sensor and technique of dynamic measurement, the data of the pump pressure, pressure of upper and nether cavity of hydraulic vat and punching power has obtained synchronously. then exact figure and corresponding relation of these parameter also some relationship between these parameter is got by means of technology of signal processing during elevating, falling and pressure - retaining. 4

    在液壓打樁錘實驗裝置上利用傳感器和動態測試技術得到壓力、液壓上、下腔壓力和樁錘下打力的同步實測數據,再利用信號處理技術分析上述參數在上升、下打和保壓過程的精確值及對應關系,獲取了液壓系統動力學參數與打樁錘力學特性關系的設計知識。
分享友人