油膜厚度 的英文怎麼說

中文拼音 [yóumóhòudù]
油膜厚度 英文
oil film thickness
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  1. By means of c - language, the paper has developed a large - scale computer program, in which the combination of both the newton iteration and the gradient method is introduced to solve reynolds equation and film thickness equation, and the march method is used to solve the energy equation and heat interface equations, the satisfactory results are obtained

    本文採用c語言編制了大型計算機程序進行數值計算，數值計算中採用梯度-牛頓聯合法求解reynolds方程和油膜厚度方程，採用步進法求解能量方程和熱界面方程，獲得了滿意的數值結果。
  2. Then we can estimate the lubrication state between the friction faces. with the old large numbers of testing numbers the wear parameter k of every point on the steady work ' s cam can be decided

    通過計算凸輪表面各位置潤滑油膜厚度，判斷其潤滑狀態，結合以前大量的實驗數據，確定出凸輪各位置在穩態下工作時的磨損系數k值。
  3. It is shown that : with the enhancement of er effects, the pressure and the thickness of lubricant film are obviously increased, while the friction coefficient and force are increased, the leak flow is reduced

    計算結果表明：隨著電流變效應的增強，油膜壓力和油膜厚度都有明顯提高，但是摩擦系數和摩擦力有所增加，端泄流量有所減小。
  4. 3 ) based on the analysis result of equal contact stress curve and the theory of elasto - hydrodynamic lubrication, the expression of the oil film thickness between roller ( or ball ) and orbit are calculated. the simulation result proved that the thickness of oil film is enough for bearing and lubricating

    （ 3 ）基於等接觸應力曲線的求解結果和彈性流體動力潤滑理論，求得滾動體和軌道曲線間的油膜厚度表達式，並通過模擬分析論證了馬達正常工作時這種油膜能滿足承載能力和潤滑的需要。
  5. If the paint becomes too thick ( e. g. in cold weather ) or low film thickness is required ( e. g. sealer ), thinners in product data sheet can be used during application to obtain good performances

    如果油漆變得過稠（如：天氣寒冷）或要求的漆膜厚度很低（如：封閉漆）可在施工時採用產品說明書上指明的稀釋劑適當調配，以取得良好的效果。
  6. Chapter two constructed the mathematical model of robot and its environment solved by the fem analysis. the functions or relations between the robotic parameters and its drive forces, thickness or its velocities were given, and also the functions or relations between the environment and the robot force, friction, robot velocity, minimum thickness of film or sustain force of dynamic films were given

    論文第二章通過建立機器人和環境的數學模型，利用有限元方法求解其中的n - s方程，得出管道中微型機器人的各種設計參數與機器人的驅動力、形成的最小潤滑油膜厚度和機器人的運行速度之間的關系曲線，研究了管道環境與機器人驅動力、摩擦阻力矩、機器人運行速度、形成的最小潤滑油膜厚度、油膜的承載能力之間的關系。
  7. Abstract : this paper derives thecalculating formulas to the contact strength and oil - film thickness of the involute spur gear according to hydrodynamic lubrication principle. through check with test, shows that they may rully replace now available hertz formula and dowsonformula respectively

    文摘:根據流體動力潤滑原理，推導出了漸開線直齒圓柱齒輪接觸強度及油膜厚度的計算公式，通過實驗驗證，說明它們可以完全分別代替現有的赫芝公式及通森公式。
  8. The optimize design of roller radius is discussed based on the touch intensit y and the thickness of lube film in this paper

    從接觸應力和潤滑油膜厚度兩方面入手，進行滾子半徑的綜合設計。
  9. Roller radius sizes of slave mechanism of cam machin e affect the touch - stress of touch region and the thickness of lube film directl y

    凸輪機構從動件滾子半徑的大小直接影響凸輪副接觸處的接觸應力和潤滑油膜厚度並影響凸輪機構的壽命和運動精度。
  10. Abstract : roller radius sizes of slave mechanism of cam machin e affect the touch - stress of touch region and the thickness of lube film directl y

    文摘:凸輪機構從動件滾子半徑的大小直接影響凸輪副接觸處的接觸應力和潤滑油膜厚度並影響凸輪機構的壽命和運動精度。
  11. Based on reynolds equation and solid particles carrying model, a theoretical model for piston ring - cylinder liner lubrication in liquid - solid lubrication had been proposed. the effect of solid particles " diameter and concentration are introduced in the model. the influence of the particles " diameter and concentration on load, film thickness and friction force had been analyzed

    基於reynolds方程及顆粒承載模型，引入顆粒直徑、濃度等參數，並建立了分析液固二相潤滑下活塞環?缸套摩擦副潤滑狀態的模型，探討了不同顆粒直徑和濃度對承載、油膜厚度及摩擦力的影響。
  12. It also sets up a cycling instantaneous heat transferring simulating model of tri - dimensioned coupling system of piston assembly and cylinder liner, and induces the thin oil film between piston assembly and cylinder liner and reticulates it. the model advances a great lot over the previous researches and approaches closer to the real case. at last, the coupling system of the cycling instantaneous temperature field of piston assembly and cylinder liner of diesel engine type 4135 is formed

    在模型的建立上，充分考慮了活塞組和缸套間非常細薄的油膜厚度並對其進行了網格劃分，使得所建立的傳熱模型和以往的研究相比前進了一大步、更接近真實情況，最終得出了4135柴油機活塞組、缸套耦合系統的循環瞬態溫度場。
  13. On the other hand, the quasi - dynamic method has advantages in calculational efficiency. ( 2 ) the minimum oil film thickness and oil film stiffness characteristics of ball bearings are studied by the elastohydrodynamic lubrication theory

    （ 2 ）基於彈流潤滑理論，研究了滾動軸承的最小油膜厚度和油膜剛度特性，分析了不同載荷參數對它們的影響規律。
  14. Study on minimum oil film thickness distribution in sliding bearing of an internal combustion engine

    內燃機滑動軸承最小油膜厚度分佈狀態的研究
  15. The experimental equipment based on theoretical analysis and simulation was set up hi order to measure the oil film thickness of the ball friction coupling and the slipper coupling based on hydrostatic support

    在理論分析和模擬結果的基礎上，設計出測量球鉸副和滑靴副油膜厚度的實驗臺。
  16. Finally, the life predicted software with the matlab is developed. this software includes the parameterized calculation module, film thickness calculation model and wear state model

    最後利用matlab開發出凸輪使用壽命預測軟體，該軟體包括凸輪參數化計算模塊、油膜厚度計算模塊和磨損狀態模塊。
  17. The simulation results provide basic data for the thickness calculation of oil film considering dynamic load, and valuable theoretical basis for further research on involute gear with unsymmetric teeth and double pressure angles

    模擬結果對考慮動載荷情況下的油膜厚度計算提供了基礎數據，為進一步研究非對稱漸開線的各種特性提供了理論依據。
  18. Taking gear without tooth face invalidation such as agglutination and abrasion as a precondition, and according to the relation between minimal oil film thickness and tooth face roughness of elastic liquid dynamic pressure lubrication theory, viscosity of gear lubrication oil was educed by reliability method in this paper, and the calculation formula has been elicited and applied

    摘要以齒輪傳動不發生膠合、磨損等齒面失效為前提，根據彈性流體動壓潤滑理論的最小油膜厚度與齒面粗糙度的關系，用可靠性方法確定齒輪潤滑油的粘度，給出計算公式並進行了實例計算。
  19. The condition of secondary surface preparation prior to first coating and the total dry film thickness after final coating shall be inspected by three parties ( builder, paint maker and owner )

    第一度塗裝之前的二次除銹和完工塗層的干膜厚度應由三方（船廠、油漆商、船東）來檢驗。
  20. Experimental research for gear pair lubricating oil film thickness

    齒輪副潤滑油膜厚度的實驗研究
分享友人
分享到 Line

分享到臉書