油量計 的英文怎麼說

中文拼音 [yóuliángjì]
油量計 英文
fuel content gauge
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 油量 : oil mass
  1. A method to calculate quantitatively the adsorption volume or adsorption space of per mass of adsorbent derived from both the adsorbed molecule volume and the maximum adsorbance of a solute in an adsorption isotherm under a given experimential condition is presented firstly for a solid / liquid adsorption system of the solute in a dilute aqueous solution. this method is suitable for not only mono - layer adsorption, but also mani - layer adsorption and micelle adsorpion of surfactant constructed by hydrophile and lipophile groups. therefore, the surface concentration of the adsorbate, cs, deduced from the adsorption volume is possessed of the meaning of true concentration, and the value of the patition coefficient of the adsorbate between solid and liquid phass, p, attained by the cs and the c, solution concentration of the adsorbate, can be accurate. the foregoing a set of calculations are presented for the solid - liquid adsorption systems consisted of the wool fiber and separately dodecyltrimethyl - ammonium bromide ( dtab ) and hexadecyltrimethyl - ammonium bromide ( ctab ) in this paper. this provides a strong basis for adsorption thermodynamic investigation of adsorbate

    對稀溶液中溶質的固/液吸附體系，首次提出了根據吸附分子體積和實驗條件下吸附等溫線中的最大吸附量計算單位質量吸附劑的吸附體積或吸附空間的方法.此法適用於單層吸附，也適用於多層吸附和具有親水親油結構的表面活性劑分子的膠團吸附.由此，吸附質的表面相濃度cs具有真實濃度的含義，相應地，計算得到的溶質的固/液分配系數p就有了準確值.分別計算由溴代十二烷基三甲銨（ dtab ）和溴代十六烷基三甲銨（ ctab ）與羊毛纖維構成的液/固體系分配系數等，為溶質吸附的熱力學研究奠定了基礎
  2. 5 per centum by weight of their fatty acid content of all the oils and fats in the food

    以重量計食物內全部油及脂肪所含脂肪酸的百分之五。
  3. This thesis described fuel management system theory and system reliability design to set forth system fuel management general design thought. many technical details are discussed in the thesis such as : fuel quantity measurement, fuel mass character calculation, fuel density measurement, the accuracy of fuel quantity measurement, the optimum location of fuel gauge probes in the fuel tank. the author brings forward a new method which is based on the software of catia to calculate fuel mass character

    本文對燃油管理系統的工作原理和可靠性設計等問題進行研究，以明晰燃油管理系統的總體設計思路；並對數字式燃油量測量、燃油質量特性計算、燃油密度測量、提高燃油量測量精度的措施、油箱油量傳感器安裝位置優化等具體技術展開研究；提出了一種基於catia軟體的燃油質量特性計算方法；論文最後探討了燃油管理系統的未來發展方向。
  4. The computer measuring and managing system of gas station

    加油站計算機計量管理系統
  5. Every greaser has an ic card reader, so the driver can pay for the oil with ic card, and the measure department can examine some measure parameters and the precision of greaser

    每臺加油機上都裝有ic卡讀寫器，加油時用戶可用ic卡代替貨幣加油，計量部門可使用ic卡檢測有關計量參數及校驗加油機計量精度。
  6. G ) the convertion of si 1126 data into ktva input data file : ktva ' s values, definition, unit and format are tested many times. h ) the result of simulation computation is visualized and analyzed, i ) the study on sll 126 parameters ; by altering the ajustment data, their performance changes are studied

    本文首次應用kiva模擬平臺，對s11126柴油機進行了模擬；通過主要參數（噴油量、轉速、噴嘴安裝高度等）的改變，分別計算出多項主要性能指標曲線和圖形，並對其進行分析，從而總結出以上參數的改變對性能的影響，驗證了kiva模擬平臺的強大功能。
  7. Application of haimo multiphase flow meter in well measuring

    海默多相流量計在油井計量中的應用
  8. A practical measurement for oil tank storage

    一種實用的油罐儲量計量系統
  9. Error analysis and improvement for oil tank measure system

    儲油罐計量系統中精度的分析及提高
  10. From the error resource, this paper emphatically analyzes the cause that the metering error produces in the process of crude oil metering with this flowmeter, and discusses the necessity of insulating the prover, installing the automatic sampler and automatic water cut analyzer

    著重從誤差的來源分析了用容積式流量計進行原油計量產生誤差的原因，指出了體積管保溫、安裝自動取樣器和自動含水分析儀的必要性。
  11. Calculation methods of recoverable reserves of oilfields

    油田可采儲量計算方法
  12. Methods for calculating oil recoverable reserves

    石油可采儲量計算方法
  13. This model provides theoretical basis for rational development of similar reservoirs and improved the calculation method of technical recoverable reserves of heavy oil reservoirs in liaohe oil province

    該模型為同類型油藏的合理開發提供理論依據，並完善了遼河油區稠油油藏技術可采儲量計算方法系列。
  14. A viscosity - temperature model of cumulative steam injection rate and cumulative oil production has been established for cyclic steam stimulation stage according to the standard viscosity - temperature curve of american material experiment society

    摘要根據美國材料試驗學會制定的標準粘溫關系曲線，建立蒸汽吞吐階段累計注汽量與累計產油量之間的粘溫模型。
  15. The dynamic metering of crude oil is a major way for the custody transfer of oil, in which the volumetric flowmeter is main metering tool

    摘要原油動態計量是原油貿易交接的主要方式，使用的計量器具主要是容積式流量計。
  16. Moreover, as an application of this module, the fuel volume calculation and error analysis of two types of training plane are made

    完成了兩個型號教練機的油量計算與姿態誤差分析。
  17. Installations for oil supply systems for oil burners - safety requirements and tests - parts, valves, pipes, filters, oil de - aerators, meters

    油燃燒器供油系統的安裝.安全性要求和試驗.部件閥門管道過濾器油空氣分離器油量計
  18. Crude oil vertical metal tank measurement - method of calculation of quantities

    原油立式金屬罐計量油量計量方法
  19. The technical line of the thesis is as follows : formula of quantity of fuel injection is got by studying relation of quantity of fuel injection and needle valve lift, time of fuel injection, rotation speed and pressure, and quantity of fuel injection is displayed

    本課題研究的技術路線為:通過研究噴油量與針閥升程、噴油時間、主軸轉速、噴油壓力等的關系，推導出精確的噴油量計算公式，最終由顯示器顯示噴油量。
  20. Dynamic measurement of crude oil - calculation of oil quantities

    原油動態計量油量計量
分享友人
分享到 Line

分享到臉書