注入鎖定 的英文怎麼說

中文拼音 [zhùrùsuǒdìng]
注入鎖定 英文
injection locking
  • 注 : Ⅰ動詞1 （灌入） pour; irrigate 2 （集中） concentrate on; fix on; focus on 3 （用文字來解釋字句）...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 鎖 : Ⅰ名詞1 （安在開合處使人不能隨便打開的器具） lock 2 （姓氏） a surname Ⅱ動詞1 （上鎖） lock up 2 ...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 注入 : pour into; empty into; inpouring; injection; infusion [拉丁語]; infunde [法國]; abouchement; influxion
  • 鎖定 : [電子學] lock; locking; [訊] lockout; [航海學] caging; locking in; lock in; latch down鎖定插銷 de...
  1. This thesis describes the properties of millimeter wave, and development of the millimeter wave sources nowadays, and introduces the solid - state devices impatt diodes, and analyses the technology of the injection locked. then this thesis gives out how to design the pa module in detail. and practical circuit is given out with the test result and analyses

    本文首先綜述了毫米波特點，毫米波源的發展現狀，介紹了w波段impatt器件的基本工作原理，分析毫米波波導電路中的注入鎖定技術，給出實現連續波或脈沖功率放大的w波段信號源的功放模塊的技術方案、測試結果和綜合分析。
  2. The injection locked can make power be amplified, but limited by the working state of the injection locked oscillator, the injection locked power amplifier can only work in continued - wave or pulsed - wave condition

    雖然採用注入鎖定功率放大方案，可以實現功率的放大，但受被注入鎖定振蕩器的工作狀態限制，該種方案功率放大器只能工作在連續波或者脈沖狀態。
  3. 2. we studied the relationship between the locking bandwidth and the injected signal light intensity and verified that the locking bandwidth is asymmetric. the negative frequency detuning is larger than positive frequency detuning

    實驗證實了鎖頻范圍是不對稱的，負失諧范圍大於正失諧范圍，並且注入功率越大，鎖定范圍越大。
  4. 3 using current injecting frequency modulation method and modulating sine wave around the resonator point, the lock - in phenomena is observed in a comparatively short period of time. this has achieved the basic goal for a closed loop r - fog

    3 、採用電流注入法，在諧振點附近進行正弦調制，實現了對諧振點的短時間鎖定，達到了閉環光纖陀螺設計的首要基本要求。
  5. Generation of tunable dual - wavelength optical short pulse using a self - seeding scheme with enhanced sidemode suppression ratio

    以自激注入鎖定方式生成邊模抑制比高的可調諧雙波長超短光脈沖
  6. Above all, with the data acquired by tests, this thesis has analysized the lateral resistanc, longitudinal resistance and rail creep etc between ballast and sleeper before and after mass machine work, discussed the effect of mass machine on stability of continuously welded rail track, reseached the change regularity of fastening - down temperature of rail, which is resulted by mass machine work, and have settled the suitable range of work temperature which guarantees the stability of jointless railway. what ' s more, this thesis has put forward the appropriate work pattern, work temperature and work area for mass machine work in future. at the same time, this thesis has given rational suggestions about some conditions worth of attention in production of mass machine, which can in return raise the work productiveness of mass machine. at last, this thesis has considered formulating reasonable measures for operation organization and work standard, so that mass machine work can play an important role in maintenance, which can reduce work load, raise work efficiency and maintenance cost in daily maintenance

    本文通過實測的各種數據，分別對大機作業前後道床對軌枕的橫向阻力、縱向阻力、鋼軌爬行情況等進行深入分析，進一步探討大機作業對無縫線路穩定性的影響，研究大機作業引起的鎖定軌溫的變化規律，確定保證無縫線路穩定的合適作業軌溫范圍。為我國今後的大型養路機械作業提出合理的作業方式、合適的作業軌溫和作業地段，同時對大型養路機械作業中應注意的問題提出合理化建議，為大型養路機械作業提供更高的安全保障，進一步提高大機作業效率。最後，對工務段在大機作業中的配合制定完善的施工組織措施及作業標準，使大機作業在養護維修中發揮更大的作用，為工務段日常的養護維修減少工作量，提高勞動效率，降低維修成本。
  7. The injection - locking technology, characterized by the frequency stabilization, amplification, modulation and etc, has been widely used in the small - signal recovery, frequency synchronization, power synthesis, phase modulation and etc in the microwave, millimeter wave and higher frequency range communication and phased - array systems

    注入鎖定技術具有穩頻、放大、調制等特性，已被廣泛應用於微波毫米波以及更高頻段通信和相控陣系統中的小信號恢復、頻率同步、功率合成、相位調制等。
  8. In order to realize a experiment of laser cooling and trapping atoms, we have set up a laser diode injection locking system and achieved a laser with single mode, narrow linewidth and 60mw power output

    為了進行原子冷卻與俘獲的實驗研究，我們用注入鎖定的方法獲得了約60mw的單模窄線寬激光輸出。
  9. It can be deduced from the characteristics of ilpll circuit that injection - locking bandwidth is not only related to the injection - locking bandwidth without feedback loop, but also related to the characteristics of frequency mixing, loop gain and the change of the loop phase. thus, the needed bandwidth can be obtained by adjusting the loop parameters. and the phase noise characteristics are mainly determined by loop transmission factor

    由ilpll電路特性的推導得出:注入鎖定帶寬不僅跟開環時的注鎖帶寬有關，而且與混頻特性、環路增益以及環路相位變化相關聯，可以通過調節環路的參數得到所需帶寬;相噪特性主要由環路傳輸因子決定，可以通過調節環路濾波得到比開環注入鎖定相噪更優的特性。
  10. The frequency of the slave laser is not locked to the master laser when the polarization direction of the injected laser is perpendicular to the polarization direction of the slave laser which is free - running. the slave laser frequency shifts toward low frequency because of thermal effect in the slave laser cavity induced by the injected laser

    當注入光偏振方向與從激光器輸出光偏振方向垂直時，從激光器頻率不會被鎖定到主激光器頻率上，但由於外部光注入引起的從激光器腔內熱效應，使得從激光器頻率向低頻方向移動。
  11. And the new circuit structure for improving the locking range, that is, injection - locked phase - locked loop circuit ( ilpll ) is introduced into the millimeter wave circuit

    在此基礎上，結合注入鎖定和環路鎖相原理，在毫米波頻率源中引入了一種新型的展寬帶寬的電路結構環路注入鎖定鎖相電路（ ilpll ） 。
  12. Theoretic and experimental study on large - frequency - difference side - mode injection locking of high power semiconductor lasers for laser cooling

    用於激光冷卻的半導體激光器大頻差邊模注入鎖定的理論及實驗研究
  13. In the paper some newly developed technologies on all - fiber coherent beam combining are introduced. theoretial explanation of injection locking is given based on the simulation

    摘要全面介紹了光纖激光器相干組束技術的發展現狀，對注入鎖定現象給出了相應的理論解釋。
  14. Considering of the subject ' s requirement and the practical conditions, the technology of three stages inject - locking amplifying was used to achieve the goal. in chapter 2, we introduce the theory used in the experiment

    以此為根據結合課題需要和實驗室的實際條件，確定採用三級注入鎖定放大技術實現ka波段固態脈沖放大源的研製。
  15. In the thesis, firstly, we report the setting up of our laser diode injection locking system. secondly, we analyzed the transient optical nonlinear response in four - level atomic medium induced by quantum interference effect

    本文主要介紹半導體激光器注入鎖定系統的研製以及四能級原子量子相干過程中瞬態非線性光學響應的分析。
  16. The thesis aims at finding a proper proposal to solve the difficult issue regarding the reliability of locking and make the system become stable and reliable and in the meantime, simple - structured and low - cost

    本文旨在尋求合適的方案解決注入鎖定存在的入鎖可靠性難題，實現同步帶寬的展寬，使其應用系統穩定可靠，同時結構簡單、成本低廉。
  17. The mathematical model expression of asynchronous quenching differential injection locking ( il ) and a method which is used to analyse the asynchronous quenching injection locking ' s synchronizing band are expressed in this paper

    摘要給出異步抑制差分型注入鎖定數學模型的數學表達式，同時介紹一種用於分析異步抑制差分型注入鎖定同步帶的方法。
  18. The paper firstly introduces the various calculation methods of injection - locking bandwidth, compares their merits and demerits and from the perspective of the model analysis illustrates the differences of the bandwidths calculated by these methods. on such a basis, the injection - locking range improvement technology is discussed and the features of various locking range improvement technologies are elaborated

    文章首先介紹了注入鎖定同步帶寬計算的不同方法，進行了優缺點的比較，並從分析模型的角度闡釋了這些方法計算出的同步帶寬的不同之處;然後對注入鎖定同步帶寬展寬技術展開了討論，闡述了不同展寬技術的特點。
  19. The injection locking technique is a effective method to obtain such laser

    注入鎖定則是獲得這種激光的一種有效的方法。
  20. 3. in the experiment, we studied how can the polarization direction of the injected signal influence on the locked state of the slave laser

    實驗研究了注入光偏振方向對從激光器鎖定狀態的影響。
分享友人
分享到 Line

分享到臉書