泵吸入 的英文怎麼說
中文拼音 [bèngxīrù]
泵吸入
英文
pumsuction-
Equally effective in checking back flows from head pressure on the discharge or suction sides of pump
無論是泵的排泄口的排出壓力,還是泵的吸入口,其流體止回的效果都是相同的。D the inspiratory and vent pipeline of pump must use nog to support, not to use pump ; e finished
4泵的吸入排出管路應有支架,不能用泵來支承Suction piping for all pumps shall have at least five ( 5 ) times the nominal pump suction flange diameter of straight pipe upstream of the suction nozzle
所有水泵的吸水管道直徑至少應有5倍于吸入口的上升直水管段的額定邊緣直徑。Monitoring sucking condition of mud pump with wavelet analysis of vibration signal
用振動信號的小波變換監測泥漿泵的吸入狀態It is mandatory to prevent the reverse flow of fire protection system substances, i. e., glycerin wetting agents, stagnant water and water of non - potable quality from being pumped or siphoned into the potable water line
也就是強制性要求防止消防系統物質,如甘油潤濕劑,積滯水和非飲用水品質等級的水由於泵吸或虹吸進入到飲用水管線中。Before the pump installation, it is necessary to remove the impurities in the pipeline thoroughly like welding slag and metal scraps lest they are sucked into the pump causing accidents when the pump starts
泵安裝前一定要徹底清除管路內的雜物,如:焊渣、金屬屑等,以免泵起動時被吸入造成事故。The result certifies that the suction system design is reasonable
結果表明:給水泵吸入口系統設計是合理的。The height of the base shall be sufficient so that the centerline of the suction elbow lines up with the centerline of the suction piping and shall include an allowance for grouting between the concrete base and the pump mounting pedestal in accordance with the pump manufacturer ' s recommendations
根據泵製造商的建議,泵基座應該有足夠的高度,使得吸入彎頭的中心線能夠與吸入管道中心線連接起來,混凝土基座與泵安裝基座之間有足夠的空間用於灌漿。This principle is a lettle like centrifugal pump. when runing, stock enters via the center of tubine wheel, and then under the function of centrifugal force is flung to the direction of tangent and drains out through specified channel
其作用原理類似離心泵,運轉時漿料從渦輪中心吸入,由於離心力的作用,被甩到葉輪的切線方向,經特定的腔道流出。For pump with open impeller, the diameter of solid particle in the liquid to be delivered should better not exceed the 30 % of the suction diameter of the pump
採用開式葉輪的泵,被輸送液體中含有的固體顆粒直徑不超過泵吸入口直徑30 %為宜。When ready to start centrifugal pumps, fully open suction valves and throttle discharge valves of a positive displacement
當準備好啟動離心式泵時,吸入閥全開,容積式排出閥節流。End - suction centrifugal pumps, rating with 10 bar with bearing bracket. nominal duty point, main dimensions, designation system
帶支承架的額定值10巴的端部吸入式離心泵.公稱負荷點主要尺寸和命名體系Both suction and discharge nozzles are horizontal, which has simplified the connection of pipeline
泵吸入口和吐出口均水平方向,簡化了管路的連接。Clinical investigation on acute asthma episode of children treated by inhalation of budesonide and bricanyl nebulized in the air pump
布地奈德聯合博利康尼泵霧化吸入治療小兒哮喘急性發作It is mandatory to prevent the reverse flow of fire protection system substances, i. e. glycerin wetting agents, stagnant water and water of non - potable quality from being pumped or siphoned into the potable water line
這種裝置強制性防止消防系統物質,如濕甘油劑,停滯水和非飲用級的水通過泵吸或虹吸進入飲用水系統中。Specification for sealless horizontal end suction metallic centrifugal pumps for chemical process
化學工藝用無縫水平末端吸入式金屬離心泵規范The base shall be of adequate height to provide suitable clearance between the pump suction elbow and the mounting floor and of sufficient strength to accept all forces imposed by the pump unit
這個基座應該具有適當的高度,使得泵吸入彎頭與安裝地面具有適當的間隙,並有足夠的強度承受泵設備所產生的所有壓力。End - suction centrifugal pumps - baseplate and installation dimensions
軸向吸入離心泵底座尺寸和安裝尺寸End - suction centrifugal pumps. baseplate and installation dimensions
端部吸入離心泵.底盤及設備的尺寸Iso 3661 : 1977 ; end - suction centrifugal pumps - baseplate and installation dimensions iso 3661 : 1977 ; german version en 23661 : 1993
離心式末端吸入泵.基座和安裝尺寸分享友人