泵抽水量 的英文怎麼說

中文拼音 [bèngchōushuǐliáng]
泵抽水量 英文
discharge of pump
  • : 名詞(吸入和排出流體的機械) pump
  • : 動詞1 (把夾在中間的東西拉出; 提取) take out (from in between) 2 (從全部里取出一部分; 騰出) ...
  • : 名詞1 (由兩個氫原子和一個氧原子結合而成的液體) water 2 (河流) river 3 (指江、河、湖、海、洋...
  • : 量動1. (度量) measure 2. (估量) estimate; size up
  • 水量 : water yield; the yield of water水量計[表] watermeter; 水量平衡 water balance; 水量收支 water budget
  1. In the study of the lumber carrier, one of the very important problem is the in spot and ultimate station due to flooding which will bring tremendous threat to the ship because of the few holds in order to study the lumber carrier buoyancy, stability and longitudinal strength under the condition of flooding, the paper adopt fundamental ship principle and iterative and accumulative concept on the basis of insumersibility theory to detailedly calculate the flooding speed flooding amount front draft after draft stability and longitudinal strength considering the ship " s sinking and inclination which will change the center of gravity and the loading station both in hold and on deck and the effect of flooding and lumber amount in holdo in the last, the paper introduces an example of the actual ship named " fei yun ling " and makes a contrast between not taking measure and taking measure which draws a reasonable conclusion and comes up to some advice the method avoids the cockamamie calculating while insures enough precision the paper draws a conclusion that not all the lumber carrier will submerge when suffering the damaged flooding if the loading or measure is suitable

    為了研究運木船舶在破艙狀態下的浮性、穩性和強度,本文在抗沉性理論的基礎上,運用船舶基本原理,採用了迭代和累計的思想,將船舶的進過程劃分為很多次進的積累,詳細計算了運木船在破艙進的過程中,考慮到各種破艙參數、船舶本身的下沉、艙室內木材、甲板貨的裝載情況和在進過程中船舶本身的傾斜對進重心的影響,以及艙室內的進和木材對破口處進速度的影響,船舶總的進速度、進、首尾吃、穩性的實時狀態和最終船舶的總縱強度,給出了計算實例,並進行了在採取用前後浮態參數的對比,得出了該船舶在艙室內的貨物積載達到某個數值時可以保證船舶在破艙進時不會沉沒,或者在當開口小於某數值時,採取適當的措施后,可以使船舶避免沉沒。
  2. Through analyzing the structure of open caisson, and according to sinking stress principle, the paper introduced in the open caisson construction process sinking, correcting error, survey control as well as peculiar circumstance processing technical measure, such as in open caisson construction the inner - mold for sanding, framework supporting and steel binding, and concrete casting ; in open caisson sinking - control the sand in edge foot inner - mold, sand - pumping sinking, and pressure hydraulic monitor breaking and pressure - blowing sinking by air pressure blower etc

    摘要根據下沉受力原理,分析了沉井結構,介紹了沉井施工過程中的下沉、糾偏、測控制以及特殊情況處理的技術措施,如沉井製作中的填沙內模,模板支設和鋼筋綁扎,混凝土澆注;沉井下沉控制中的刃腳內模沙土,沙下沉,高壓槍破壓、空壓機吹壓下沉等。
  3. According to non - newtonian fluid mechanics theory and mathematical method, conbined with plunger moving property, the hypothesize fluid is imcompressive, hydraulic radius of flow of liquid in crevice is very little, and it is laminar flow, the flow is treated fixed continuous flow at every instant position of plunger, equation of motion and boundary condition were set up in condition of concentric and eccentric of pump barrel and plunger

    運用非牛頓流體力學理論和數理方法,結合柱塞運動特點,假設液體為不可壓縮的,液體在縫隙中流動的力半徑很小,呈層流流動,柱塞在每一位置的瞬間,流動做定常流處理,建立了筒與柱塞同心和偏心兩種情況下運動方程和邊界條件,引入無綱坐標、無綱速度和柱塞與筒偏心配合時的縫隙高度,並給出縫隙流流速、流的解析解。
  4. The ground water exploit mainly relies on deep well diving pump for drawing water, that is to say, the cost depends primarily on electricity consumption

    地下開采主要依靠深井潛到地面,也就是說,供成本主要取決于用電
  5. After the coke being puted into the coke - quenching device, the lid of the device should be shut at once. while the suction pump, refrigeration compressor, high pressured water circuling pump are started, the subpressure will be produced by the burning coke. then, in the vacuum, the coke will be extinguished in a flash. the burning of the coke instantly, still, produces a large quantity of heat which can be taken away by circulating water in refriger and the interlayer, after that, the temperature will fall to 60oc, even lower. in this condition, the coke will be pushed out to be stored, thus, the coke won ' t rekindle

    當焦炭推上攔焦車進入熄焦器后,立即關閉罐蓋,同時啟動真空、冷凍機、高壓循環,這時,燃燒著的焦炭就會因真空把熄焦器內成負壓,由於缺氧,使焦炭熄滅,雖然煤炭在瞬間被熄滅,但由於焦炭生成過程中所產生的大的熱還存在,這時,冷凍機和夾層中的循環的工作就會把焦炭中的熱帶走,使之在短時間內將溫度降到60以下,在這種狀態下把焦炭從熄焦器內推出入庫,焦炭就不會復燃。
  6. The equipped air valve design, can remove air with slight amount of vapors by suction as well as protect the cooling vapor from mixing into oil, so as to prolong the lifetime of oils in the pump

    裝有氣鎮閥,在除含有少蒸汽的空氣時,打開氣鎮閥可避免蒸汽凝聚后混入油中,延長油的使用壽命。
  7. Those pumps will now have to shut down for much of the year, reducing water output by up to a third

    那些現在不得不基本停閘至年尾,減少了1 / 3 。
  8. The results show that the wellhole and pumping condition, such as depth of the pump, quantity of pumping, all have great influence on the observational result

    結果表明,井孔條件,條件,如深度、等因素的改變對觀測結果產生較大影響。
  9. The telemetric monitor measured and logged six physical water quality parameters at short intervals, and then transmitted this data to the epd offices via a phone line the trial revealed a number of problems

    由站內的起流經遙測監測器,每隔一段短時間測和記錄六項物理質參數,並透過電話線將數據傳送至環保署總部。
  10. According to the gravity - elasticity similar law the model scale of bai shan pumped - storage hydroelectric plants is taken as the trashrack bar is made of zinc, the relative errors between its practical density and elastic modulus and its proper values are - 7. 82 % and + 1. 43 %, respectively. by lvs measuring the velocity distribution ahead the trashrack bar and on the basis of the velocity distribution the working conditions of the pumped - stroage hydroelectric plant are controled. the dynamic strain of the trashrack bar induced by flow are measured using strain slips

    選擇白山蓄能站攔污柵彈性模型的主要比尺為_ l = 3 、 _ e = 3 、 _ p = 1 ,柵條用鋅板加工而成,模型材料的實際密度和應有密度的相對差為- 7 . 82 ,模型材料的實際彈模和應有彈模的相對差為+ 1 . 43 ,用激光流速儀測柵前流速分佈,並用流速分佈作為控制工況的依據,用應變儀測柵條應變。
  11. Based on the results of testing site, some problems of vacuum preloading was analyzed by plane strain finite element method. the relative stable seepage velocity field can be produced with the pumping time. the depth of negative pore - water pressure transferring increases with the pvds length

    最後,對真空聯合堆載預壓的施工工藝進行了研究,提出了在真空聯合堆載預壓的中期,出已相對較少,可適當減少開,並可採用停結合的變真空能法,在不影響加固效果的前提下,可以大大節省用電
  12. When the water head and the flow are given, we can regulate the pump ' s blade mounting angle to control the discharge of pump in this pumping station that contains only one type of pump. we also can determine the number of running machines with machine ' s optimal combination. so we can reduce its energy consumption, and make it run optimally and economically

    頭和給定時,這類型單一的站,可以通過調節的葉片角度,控制的流,併合理確定開機臺數,通過機組間的優化組合,使整個站的能耗最少,達到整體最優、經濟運行的目的。
分享友人