泵測試效率 的英文怎麼說

中文拼音 [bèngcèshìxiàolǜ]
泵測試效率 英文
pumtest efficiency
  • 泵 : 名詞（吸入和排出流體的機械） pump
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 效 : Ⅰ名詞（效果; 功用） effect; efficiency; result Ⅱ動詞1 （仿效） imitate; follow the example of 2 ...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 測試 : test; testing; checkout; measurement
  • 效率 : productiveness; efficiency; productivity; workpiece ratio
  1. Standard test method analytical procedure for determining the efficiency of a production well in a confined aquifer from a constant rate pumping test

    通過一連續比率的泵試驗對限制性含水層內生產井效率測定的標準試驗方法
  2. These characteristics and phenomenons have effect on the quality of gear pump, and it is difficult relatively to research them by theory. at present the research is limited to the phase of examination testing. theoretic research of the characteristics and the phenomenons of polymer gear pump are blank in china when the gear pump feeds the viscous polymer liquid of chemical flow with high temperature and high pressure

    齒輪泵除具有流量和容積效率、扭矩和機械效率、功率和總效率等基本特性外，還存在著困油、噪聲和氣穴等現象，這些特性和現象直接影響齒輪泵的質量，對斜齒齒輪泵的這些特性和現象的理論研究難度較大，目前大多仍局限於實驗測試研究階段，而聚合物齒輪泵在輸送化工流程中的高溫、高壓的粘流態聚合物時特性的理論研究在國內基本還處于空白。
  3. Based on many references form civil and abroad, the author mainly studies the measurment theory and method for flux, raising height, axial power and rotational velocity. avoiding many complicated and intermediate courses for power wastage analysis, introduces the electric measurement and using efficiency curve of motor in measureing axial power, and satisfies the automatization of the device. the paper also provides a new method, inductive winding, in measuring rotational velocity of electromotor, supplys limitations of other method in measuring rotational velocity of electromotor in water, and meet practical needs in developing diving electric pump for corporation

    作者在參閱大量國內外有關文獻，著重探討了水泵流量、揚程、軸功率、轉速的測試原理和測試方法，提出了採用電測法並結合電機效率特性曲線測量水泵軸功率，從而避免了損耗分析法中大量復雜的中間過程，滿足了試驗裝置的自動化測量要求；採用漏磁感應線圈法測量電機轉速，彌補了其它轉速測量方法對水下電機測試的局限性，適應了萊恩公司開發潛水電泵的實際需要。
  4. A test system was developed and an l9 ( 3 ^ 4 ) orthogonal experiment design was used to test the pump efficiency under different flow rates, lifts, electric voltages and currents

    並設計了試驗系統，採用l9 （ 3 ^ 4 ）正交試驗，以離心式水泵效率為試驗指標，進行了離心式水泵的流量、揚程、電壓和電流的測量。
  5. This experiment include many contents, in a word, that is summer condition experiment, winter condition experiment > summer - winter transition condition experiment and winter - summer transition condition experiment, furthermore summer condition experiment still include flux changing experiment and winter condition experiment still include thermal balance experiment this article dealt with the data of the test, calculating out energy absorbing ( energy discharging ) of buried pipe in winter condition ( summer condition ), input power of heat pump x heat exchanging of piece buried pipe length x co - efficiency performance ? op ( energy efficiency rate ? er ) and average heat exchanging coefficient ; in additiont this article compares the inlet water temperature and outlet water temperature of underground the first layer and the second layer buried pipe when heat pump was running, the results are that the heat exchanging ability of the second layer buried pipe outgos the first layer buried pipe, and heat exchanging is more stable ; and still analyse earth temperature resuming in the transition season. the results are earth temperature resume fast in the first week when the heat pump runs off

    本文測試內容相當多，概括地說就是四個工況的測試，即夏季製冷工況的測試、冬季供熱工況的測試、夏?冬過渡季測試和冬?夏過渡季測試；另外在夏季工況的測試中還進行了變流量測試，在冬季工況的測試中還進行了熱平衡測試。本文對測試數據進行了處理，計算出了冬（夏）季工況埋管吸（放）熱量、熱泵空調器供熱量（製冷量） 、熱泵空調器輸入功率、埋管單位管長換熱量、供熱性能系數（製冷能效比）和平均傳熱系數等；另外，還比較了熱泵運行時地下一二層埋管進出水溫度變化情形，得出地下二層埋管換熱能力優于地下一層埋管，且換熱很穩定；並分析了過渡季地下一二層埋管溫度恢復情形，得出熱泵系統停機一周內地溫恢復特別快。
分享友人
分享到 Line

分享到臉書