泵激閾值 的英文怎麼說

中文拼音 [bèngjīyùzhí]
泵激閾值 英文
pumping threshold
  • 泵 : 名詞（吸入和排出流體的機械） pump
  • 激 : Ⅰ動詞1 （水因受到阻礙或震蕩而向上涌） swash; surge; dash 2 （冷水突然刺激身體使得病） fall ill fr...
  • 閾 : 名詞1. [書面語] （門坎兒） threshold; doorsill2. （界限; 范圍） threshold
  1. Abstract : in view of the crystal structure, this paper repo rts thecharacter of single crystal growth of germanate and the properties as me dium of laser crystal. the study and progress in germanate crystals used as widel y tunable laser crystal, self - doubling - frequency crystal and highly efficient and low pumping threshold laser crystal are introduced

    文摘:從晶體結構上分析了鍺酸鹽的單晶生長和作為激光晶體基質的特點，並介紹了鍺酸鹽作為可調諧激光晶體，自倍頻晶體，高轉換效率和低泵浦閾值的激光晶體的研究及進展。
  2. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  3. Based on these foundations, we give a perfect scheme of the bbo opos : single pass amplification coefficient of the opg under different pump intensity is calculated ; collinear type - i and type - ii phase matching tuning curve pumped by the q switch nd : yag various harmonics as well as noncollinear type - i tuning curve are calculated in details ; the effect of the walkoff for the nonlinear effect coefficient and the group velocity matching are analyzed ; the acceptance angle in parametric process is calculated ; the numerical threshold of the bbo opo is calculated ; the process of the saturation and depletion of the pump beam are analyzed ; the relationship of the conversion efficiency and reflectance of output mirror are discussed ; various linewidth controlling methods are discussed ; the improvement of the beam quality applying the unstable cavity is discussed ; and the crystal bbo design is considered

    在此基礎上，給出了一整套bbo - opo激光參數設計方案：計算了不同泵浦強度下的參量放大倍數；詳細計算了在nd : yag調q激光器各次諧波泵浦條件下的共線類和類相位匹配的調諧曲線，以及非共線類相位匹配調諧曲線；分析了走離角對非線性系數和群速匹配的影響；計算了參量過程的允許角；計算了bbo - opo的理論閾值條件；分析了飽和與泵浦光束的消耗過程；給出了轉換效率與超過泵浦閾值的倍數的關系；討論了轉換效率與輸出鏡反射率的關系；討論了線寬控制的各種方法；研究了利用非穩腔改善光束質量的方法；考慮了bbo晶體的設計。
  4. Adopting the amendatory rate equation, the threshold of the micro - cavity has been studied and the conclusion is shown as following : if there is not non - radiation transition, the pump velocity just need to compensate the photon velocity escaped from the cavity, and the intensity of output light will direct ratio to the intensity of input light then we got a micro - cavity laser with no threshold

    採用修正的速率方程對微腔激光器的閾值進行研究，得到如下結論：在沒有無輻射躍遷時，激光器的泵浦速率只需恰好補償光子向腔外的逃逸速率，輸出光強隨著輸入泵浦光強性線增加，實現所謂的「無閾值」激光器。
  5. In this paper, some investigation and design as following. have been carried out on er - yb codoped phosphate glass waveguide laser first, three primary performance parameters of er - yb waveguide laser pump threshold power ; output power and slope efficiency have been commulated and analysed theoretically based on er ~ ( 3 + ) - yb ~ ( 3 + ) energy configuration ; rate equation of stable state and transmitting equation. the influences of er - yb ions concentration ; enabled waveguide length ; light dot radius of signal light and pump light ; reflectivity of output lens on three above parameters have been researched

    首先，從er ~ （ 3 + ） - yb ~ （ 3 + ）能級結構出發，結合激光穩態速率方程與傳輸方程，對鉺鐿波導激光器的三個主要性能參數:閾值功率、輸出功率、斜率效率作了理論計算分析，並研究了鉺、鐿離子濃度、光波導激活長度、信號光與泵浦光光斑半徑比例、輸出耦合鏡反射率對這三個關鍵性能參數的影響。
  6. The analyses given in this paper to quasi - three - level for 946 nm laser are complete. the relation between 946 nm laser transmission and optimal crystal length has been derived from the rate equations describing the population inversion and the photon density in the laser cavity in the steady - state case. the minimal claims to coating have been given on the base of contrasting 946 nm transmission with 1064 nm transmission in the condition of different cavity losses and how the pump beam radius in the laser crystal and optimal crystal length affect the laser threshold and output power of 946 nm laser has been given as well

    對產生946nm譜線的準三能級結構給出了較為完整的分析，利用激光諧振腔處于穩態時的速率方程，導出了準三能級nd ： yag946nm起振時，透射損耗與最佳激光晶體長度的關系，在與1064nm透射損耗相比較的基礎上，給出了不同的腔損耗情況下的最低鍍膜要求，並且給出了激光閾值、輸出功率和最佳激光晶體長度及泵光光斑大小的關系，這為設計室溫下高效運轉的946nm激光器的提供了理論基礎，這種分析方法對研究此類低增益，準三能級或三能級激光系統輸出特性有借鑒意義。
  7. We also experimentally observed the effect of sodium atom - molecular collisions and sodium atom - atom collisions on the line - shape and intensity of fluorescence spectra. in addition, the optically pumped infrared stimulated emission and energy transfer up - conversion process are observed in pr3 + : y2sio5, and with the threshold energy, temperature dependence and divergence angle for the stimulated radiation are measured

    此外還研究了摻雜在固體y _ 2sio _ 5中的pr ~ （ 3 + ）的光泵紅外受激輻射和能量轉移上轉換，分別測得了紅外受激輻射的閾值能量和發散角，並擬合得出了能量轉移速率。
  8. The study of srs in non - linear optic fiber by simulink emphatically. the initial intensities of pump beam and stokes beam are similar, and small signal gain theory needs to amend have been pointed. srs comply with the special growth law, does not have " threshold " characteristics. lt depends not only on the intensity of pump beam but also on the intensity of stokes beam itself. even if the intensity of pump beam is weak, fhe srs effect is maybe still take place. in addition, the problem about srs effect depends on the number of channels, power in each channel and space of the channels, in a dwdm system has been studied

    並著重論述了如何利用simulink研究非線性光纖光學中的受激喇曼效應，指出在光纖通信的情況兩個光束的初始強度相差不多時，小增益理論需要修正。 srs遵從特殊的增長規律，並不具有「閾值」特性。 stokes束的增長不僅依賴于泵浦波的強度，而且也和自身的強度有關系。
  9. Furthermore, the variation of sbs performance parameters, such as threshold and reflectivity, with parameters of pumping laser and multi - mode optical fiber has been researched by analysis of the numerical solution. experiments have also been operated in ld - pumped solid - state laser system with high - repetition more than 100hz and narrow pulse - width between 15ns and 47ns. the experimental results agree with calculated results by the theoretical model

    第三章在重復頻率100hz 、脈寬15 47ns可調的dpl系統中，實驗研究了不同芯徑、長度的光纖在不同能量、脈寬的激光泵浦下sbs閾值、反射率等性能參數等變化趨勢，實驗結果和理論分析一致。
  10. Because of high threshold of 946 nm laser, severe thermal lens effect will appear when the 946 nm laser operations. in the consideration of thermal lens effect, the - optimized folding cavity has been devised. the relation between thermal lens effect and the radius of laser beam waist has been given as well

    由於946nm激光閾值很高，需要更強的泵浦功率密度，因此較大功率藍光激光器的熱透鏡效應將會比紅光和綠光激光器更明顯，而熱透鏡效應是影響激光功率提高和激光輸出穩定性的重要原因，所以在考慮到激光晶體熱透鏡效應的情況下，優化設計了折疊腔結構，並給出了熱透鏡效應和折疊腔中腔模半徑大小的關系。
  11. We analyzed the polarizing character, threshold condition, raman shift of srs in different polarizing pumping light. in addition, the empirical formulas on stimulated raman scattering are given. theoretical analyses and experimental results are in good agreement

    對它們在不同偏振態泵浦光激勵下各級stokes的偏振特性、閾值條件、喇曼頻移等各參數進行了分析，並給出了經驗公式，其結果和實驗數據符合良好。
  12. 2. a theoretical analysis and numerical simulation considering pumping beam waist, q - switch, cavity design are presented. combine with the theoretical analysis and the request of fundamental wave, the appropriate cavity and q - switch are chosen

    2 .從諧振腔設計理論及調q技術進行分析，討論了ld泵浦固體激光器的輸入輸出特性及影響閾值的主要因素;結合理論和我們下面工作的要求，選擇合適的腔形及調q方式。
  13. At the case of excess of nonlinear effects appearance threshold, not only are quality reduction of the wave front passing optical elements and energy losses possible, but also the fatal destruction of optical elements in themselves are the most grievous

    當泵浦光強度超過產生非線性效應的閾值時，激光通過諧波轉換晶體后，不但光束波前質量將有可能變差，而且還會損失一部分能量，更嚴重的是光學元件的致命破壞。
分享友人
分享到 Line

分享到臉書