泵特性 的英文怎麼說

中文拼音 [bèngtèxìng]
泵特性 英文
pumcharacteristics
  • 泵 : 名詞（吸入和排出流體的機械） pump
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  1. For the avoidance of rigidity impact of commutative piston mortar pump in movement, the amendatory cam mechanism was designed, and the characteristic of movements was analyzed

    為避免互逆活塞式砂漿泵在運動過程中出現的「剛性沖擊」 ，對凸輪機構進行了修正設計，並分析了修正凸輪機構的運動特性。
  2. Fitting method for pump complex characteristic curve based on b - spline

    樣條的水泵復雜特性曲線擬合方法
  3. At present there is a lack of fundamental data of dynamic thermal transfer performance of ground loop exchanger and energy - saving performance of gshp system

    但有關埋地換熱器動態特性以及地源熱泵節能潛力方面的基礎性研究較缺乏。
  4. Then after analysising each characteristics of phosphate glass material, the fiber rod - in - tube by invaginating core rod, inside cladding and outside cladding is used to fabricate the er / yb phosphate glass fiber successfully by polishing and vacuumizing fiber rod - in - tube. finally some techniques, such as cladding pump, prism coupling pump and fusing pump are used to measure the gain of fiber amplifiers

    最後對拉制出的光纖提出了包層泵浦、棱鏡耦合泵浦和熔接耦合泵浦三種可行的增益和傳輸特性測試測方案，並針對鉺鐿共摻磷酸鹽玻璃光纖的特性，指出了熔接耦合是測試增益和傳輸特性的最佳方案。
  5. Experiental research on the characteristics of small diameter jet pump

    66型小直徑射流泵特性試驗研究
  6. Advances in study of hydraulic characteristic parameter conversion for low - lift pumping devices

    低揚程水泵裝置水力特性參數換算研究綜述
  7. It has important significance to probe and master in theory the dynamic characteristic during suspending period in improving the pumping stations designing, reducing the investment and ensuring the safe and reliable operation of pumping systems. - in this paper, a theoretical study was made on the dynamic characteristics of a large low - lift pumping system within suspending period

    停泵動態特性是大型低揚程泵、泵裝置、泵站重要運行特性之一，但其研究成果卻很少，不適應實際工程要求。從理論上探求和掌握大型低揚程泵站停泵動態特性，對于提高泵站工程設計水平，降低工程投資，實現科學管理，保證泵系統、泵站安全可靠運行具有十分重要意義。
  8. Flow characteristics of moveable teeth gear rotator pump

    農用高揚程大流量活齒齒輪轉子泵的流量特性
  9. Based on the ostwald - de waele equation, the leakage characteristics of power - law transmitted by helical gear pump are researched, and the leakage model of power - law in the clearence is founded, and - the velocity distributing and the leakage capacity are worked out by the boundary condition. the power loss of leakage is got through the clearence leakage capacity, and the friction power loss is attained by the velocity distributing. the mathematic calculation model

    利用冪律流體本構方程，首次對聚合物流體在斜齒齒輪泵中的漏流特性進行了研究，建立冪律流體在間隙中的泄漏模型，利用邊界條件求出速度分佈及泄漏量；由間隙泄漏量得到漏流損失功率，由速度分佈得到流體摩擦功率損失，並得到間隙最優解的數值計算數學模型，同時給出實例及數值計算結果。
  10. Study of standard compound gear rotator pump

    橢圓齒輪轉子泵的流量特性研究
  11. The flow characteristics of the parallel gear rotator pump

    並聯式齒輪轉子泵流量特性的理論研究
  12. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用摩擦零部件材料發展的需要，在實驗室摩擦磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的碳化硅和氧化鋁基陶瓷材料摩擦副在水、化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
  13. Study on the abrasion behavior of carburizing carbonitriding steel for pump body

    碳氮共滲鋼水泵體的磨損特性研究
  14. In chapter four, according to the analysis on the boundary theory and velocity field of main fluid zone of two - phase fluid pumps, the parameter equations of vane ' s modular curve of centrifugal pump are given, which contact the boundary " layer and eular theory of two - phase fluid pump by the fixing angel of vane as variable and leading into the velocity coefficient a. the results show that, in designing process of vane ' s modular curve of centrifugal pump, the determination of the total shape and parameters relates the flow properties of two - phase fluid and output ability of pump, or the design of the modular curve of centrifugal pump is the kernel of hydraulic design

    第四章依據固液兩相流泵的邊界層理論及對主流區速度場的分析，給出了離心泵葉片型線的參數方程；它是以葉片安裝角為參變數，以引入的速度系數k _ v作為中間因子，將兩相流泵的邊界層理論和歐拉理論聯系起來? ?它說明了這樣一個事實，在離心泵葉片型線的設計過程中，它的整個形態或參數的確定都關繫到兩相流體的流動特性和泵的輸出能力，或者說，離心泵型線的設計是其水力設計的核心。
  15. The theoretical analysis on the operational characteristics of gshps taking into consideration of the characteristics that taking soil as the heat source and cold source, by means of thermodynamic methods, the theoretical research on the operational changing patterns of gshps with a scroll compressor using r22 as refrigerant has been conducted

    土壤源熱泵系統運行特性的理論分析針對以土壤為冷熱源的特點，運用熱力學的方法，對r22渦旋壓縮式土壤源熱泵系統的運行變化規律進行理論研究。
  16. Experimental results are reported on temporal instability of phase - conjugate beam in a self - pumped ce : batio3 phase conjugator at 532nm. dark decay behaviors of sppc gratings in ce : batio3 are studied, for the first time to our knowledge, by measuring the decay of sppc reflectivities at 532nm and 790nm wavelengths at room temperature

    首次在實驗和理論上研究了自泵浦位相共軛光柵暗衰減的特性，與以往一深一淺兩個陷阱能級參與光折變過程不同的是，發現了兩個深陷阱能級同時參與了自泵浦位相共軛光柵的建立。
  17. Surface treatment ; determination of characteristics of air driven piston pumps

    表面處理.第1部分:空氣傳動活塞泵的特性測定
  18. It can be seen from the model that the two valve - controlled motors would be coupled with each other if the characteristic of variable - displacement pump is taken into account

    由該模型可以看出，在考慮變數泵特性的條件下， 2個閥控馬達是相互耦合的。
  19. Analysis on the boost pump specific property and type selection count

    增壓泵特性分析及選型計算
  20. By discussing in detail the shapes and types of pump characteristic curves and the effects of geometrical parameters on them, this paper points out that the main reason of the brake horsepower of the low specific speed sewage pump increasing with capacity rapidly is that we often select larger geometrical parameters such as b2, ft and so on to enhance the capacity of the sewage pump

    詳細討論了離心式排污泵特性曲線的形狀和種類，以及幾何參數對排污泵特性曲線的影響，指出排污泵設計中增大b _ 2 、 f _ t等幾何參數是導致軸功率曲線隨流量增加上升很快的原因。
分享友人
分享到 Line

分享到臉書