活動實驗裝置 的英文怎麼說

中文拼音 [huódòngshíyànzhuāngzhì]
活動實驗裝置 英文
portable laboratory
  • 活 : Ⅰ動詞1 （生存; 有生命） live 2 [書面語]（救活） save （the life of a person）:活人無算 （of a goo...
  • 實 : Ⅰ形容詞1 （內部完全填滿 沒有空隙） solid 2 （真實; 實在） true; real; honest Ⅱ名詞1 （實際; 事實...
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 裝 : Ⅰ名詞1 （服裝） dress; outfit; attire; clothing 2 （演員的化裝品） stage makeup and costume Ⅱ動詞...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 活動 : 1 （運動） move about; exercise 2 （動搖） shaky; unsteady 3 （不固定） movable; mobile; flexible...
  • 裝置 : 1 （機器設備的配件）installation; device; apparatus; equipment; arrangement; gear; appliance; rig...
  1. ( 1 ) for the first time, compositing the chemical compounds of alkaline - earth metal with the adsorption material, 13x molecular sieve, silica gel, and activated alumina to gain a series of composite adsorbents with good performance that higher adsorption capacity and lower regeneration temperature and suitable for adsorption refrigeration systems that can be driven by low - grade thermal energy

    首次將堿土金屬化合物及其鹽類與傳統吸附材料13x分子篩、硅膠和活性氧化鋁等復合，制取具有較高吸附量和較低再生溫度的適合於以低溫熱能驅動的吸附製冷過程的一系列優良復合吸附劑。分別在自製的吸附製冷、除濕製冷模擬實驗裝置上，測得該系列復合吸附劑與水和乙醇組成的吸附製冷工質對的吸附製冷性能以及除濕製冷性能均優于傳統吸附劑（ 13x ，硅膠和活性炭） 。
  2. At the same time, this thesis analyses the new characteristic of high school physics experiment course by the new standard after the reform. for example, enhancing students " practice, paying more attention to bringing up students " scientific method and scientism, considering students " cognizance disciplinarian and psychology characteristic, introducing advanced technology, advocating to make cheap experiment instrument, setting up experiment circumstance, encouraging students to design and research the experiment by themselves

    同時，分析中學物理新課程標準關於物理實驗課改革后的突出特點，比如：加強了學生的實踐活動；注意培養學生科學的工作方法；注重學生科學態度的培養；考慮了學生的認知規律和心理特點；引入了先進技術；提倡製作低成本實驗裝置；創設實驗意境；鼓勵學生自己設計、探索實驗等。
  3. The timing - and - quantitation precision injection of lpg was realized with high - speed lpg solenoid valve and a set of electronic control system, which was designed by the author and can flexibly control the gas supply system of lpg. based on the analysis of experimental data got by comparing the performances before and after the application of the set of equipment on lr6105q12 diesel engine, the effects of load, speed and replace ratio, etc on the emissions of smoke, hc and co of dual fuel engine were expounded. through optimization, the smoke emission was utmostly reduced and the emissions of hc and co were within the government restriction

    為此，本文通過對各個方案進行詳細比較，選擇了電控多點順序噴射的供氣方案；利用高速lpg噴射閥和自己獨立開發出一套電子控制系統對lpg供氣進行靈活地控制，實現了lpg的定時定量噴射，並把這套裝置應用到中國一拖生產的lr6105q12柴油機上，在對改裝前後的發動機進行大量試驗和分析的基礎上，闡明了負荷、轉速、摻燒比等因素對雙燃料發動機的煙度、 hc 、 co等排放的影響情況，並且通過優化，最大限度地降低了發動機的煙度排放，同時使hc 、 co排放限制在國家標準規定的范圍之內。
  4. This text completely and systematically studies the status and the development of the pyrolysis and the fluidization of biomass, which distill the bio - oil in the domestic and international area, as well as the existing problems. this thesis primarily include following aspects : ( l ), by experimenting and measuring the energy ( heat value ) and the content of c, h, n chemical element of right 20 kinds of common biomass, on the base of the experimental result, and respectively established the biomass energy predict experiment formula with the element of h and c is from change, and passed the ro. os examination, which provides the basis and convenience for flash pyrolysis fluidization device energy to convert the rate to compute with biomass energy utilization calculation ; ( 2 ), proceeded the tg and dtg experimentation equal velocity ( 10 ? / min, 20 ? / min, 40 ? / min, 60 ? / min ) heating and constant temperature heating by studying on eight kinds of biomass samples, according to the experimental data and arrhenius formula, we established the dynamics model of pyrolysis of, then, using the goast - redfern and p function, we also solved the dynamics parameters and analyze out every kind of biomass ' s frequency factor and parameters of activation energy, and established the every kind of dynamics model of pyrolysis of biomass, all of these provide the theories and basis to make sure the reactor ' s flash pyrolysis work temperature scope design and the describing of pyrolysis reactor dynamics ; ( 3 ), in order to study and ascertain the process of heat completely getting to pyrolysis time of varied size biomass particles, we observed and measured the ratio of length and diameter ( l / d ) with the varied biomass through electron microscope, we concluded the l / d ratios usually is from 5. 0 to 6. 0, the average is 5. 3 ; ( 4 ), we studied the process of biomass transiting and the theory of complete pyrolysis time with the theory of complicated heat field, we got the time ( t ) of the varied size biomass particles arriving to complete pyrolysis, and we knew that the complete pyrolysis time and the time which get to the biggest production ratio are identical, all of these studies provide the theory base for design and forecasting the flash pyrolysis reactor solid state resort time ; ( 5 ), according to the above experiment result, synthesize to make use of the engineering the mechanics, engineering the material, machine the design to learn the principle, deduce, establish the theory of rotation cone flash pyrolysis reactor material resort time ( t ) and reasonable rotation velocity ( or frequency ) relation theory ; and ( 6 ), we gave the reactor ' s smallest cone angle certain, reactor cone wall strength design theory, the reactor production ability theory, the power design method and the critical rotation velocity theory

    本文較全面、系統地綜述了國內外生物質熱解液化制取生物燃油技術研究發展現狀及存在的問題，主要研究內容有： （ 1 ）實驗、測定了20種常見生物質的能量（發熱量）和c 、 h 、 n元素含量，根據實驗結果分別建立了以h和c為自變量的生物質能量預測經驗公式，並通過r _ （ 0 . 05 ）檢驗；為閃速熱解液化裝置能量轉化率計算和生物質能量利用率計算提供了依據和方便； （ 2 ）選擇了8種生物質試樣作了等加熱速率（ 10 min 、 20 min 、 40 min 、 60 min ）和恆溫加熱的tg和dtg實驗，根據實驗數據和阿倫尼烏斯公式建立了生物質熱解反應動力學微分方程，並採用goast - redfem積分法和p函數對其動力學參數進行了求解，解析出各種生物質的頻率因子和活化能參數，進而建立了各種生物質的熱解動力學模型，為科學確定反應器的閃速熱解工作溫度范圍及熱解反應動力學描述，提供了理論和依據； （ 3 ）為研究和確定不同尺度的生物質顆粒中心達到全熱解的時間，在體視顯微鏡下對不同粒度的生物質顆粒的長徑比進行了實驗觀察和測定，得出生物質的長徑比（ l d ）一般在5 . 0 6 . 0之間，平均為5 . 3的結果； （ 4 ）採用復雜溫度場傳熱學理論對生物質傳熱過程及充分熱解時間理論進行了研究，解析推導出了不同尺寸生物質顆粒中心溫度達到充分熱解溫度的時間（ t ） ，得出了理論推導的充分熱解時間與最大產油率的熱解時間相一致的結果，為閃速熱解反應器固相滯留時間設計和預測提供了理論依據； （ 5 ）根據上述實驗結果，綜合運用工程力學、工程材料、機械設計學原理，推導、建立了轉錐式閃速熱解反應器物料滯留時間（ ）與轉速（或頻率）合理匹配理論； （ 6 ）提出了轉錐式閃速熱解反應器的最小錐角設計、錐壁強度設計、生產能力設計理論和功率計算方法及臨界轉速理論等。
  5. In the paper, theories and functions of the whole system are introduced, the typical theories and algorithms of relay protection employed in the system are lucubrated, the configuration of relay protections is researched, the demonstration constitution schemes are determined, the psd remote program upgrading method based on 80c196kc is provided, the relay protection software is designed based modular structure and in which the technologies of pts data transmission and the lcd multilevel menus which contain chinese characters and graphs are adopted, a configuration software design method is provided for adapting the need of training of different structure of substations, and a set of teaching, experimental and training software which has good teaching effects and has innovation to some extent is designed

    本文介紹了整個系統的結構、原理和功能，深入地研究了本系統所用的典型微機保護原理與演算法；研究了保護的配置；確定了變電站綜合自動化系統的示範構成方案；提出了基於80c196kc的psd微機保護遠程程序升級方法；設計了裝置保護軟體，軟體模塊化設計、流程清晰，並採用了pts數據傳送和lcd圖形和多級漢字菜單設計等技術；適應對不同結構的變電站培訓的需要，提出了一種組態軟體設計方法；設計了教學性好、啟迪性強、可靈活組態的教學實驗培訓軟體，有一定的創新性。
  6. To find a proper and convenient way in electron emitter research, in the paper, we have discussed the essential and possibility of setting up a new pld ( pulsed laser deposition ) device which connects with aes ( auger energy spectra ), and built such device in order to complete cathode deposition and analysis without exposing to the atmosphere and carried out cathode in - situ preparation and analysis electron emission phenomenon is a physical process taken place in surface of electron emitter

    為了解決電子發射體（陰極）研究方法中存在的問題，並尋求一種適當的、方便的陰極研究實驗方法，本論文論證了建立與aes相連的pld裝置的必要性和可行性，並實際建立了這一裝置，實現了陰極的原位沉積、原位分析。電子發射現象是在電子發射體表面發生的物理過程，發射表面是由活性元素構成的動態平衡系統，這一系統直接決定電子發射性能。表面分析手段對陰極研究是必不可少的。
  7. 4 ) the three - dimensional solid models of the spatial cam sliding tooth transmission are built up ; the assembling and exploding on the solid modes of those components are made ; the construction of this transmission device is described directly, and the checkout of the assembling coordination between the components of the spatial cam sliding tooth transmission can be done in the design stage

    4 ）建立了空間凸輪活齒傳動裝置的三維實體模型，並對實體模型進行裝配和爆炸處理，直觀地描述了該傳動裝置的結構，實現了在設計階段對空間凸輪活齒傳動零部件裝配協調性的校驗。
分享友人
分享到 Line

分享到臉書