活性碳柱 的英文怎麼說
中文拼音 [huóxìngtànzhù]
活性碳柱
英文
carbon column-
The solenoid plunger pulls the vent valve down, blocking off the passage to the charcoal canister.
電磁柱塞拉下通氣閥，堵住通向活性碳罐的通路。The influence of nano - al2o3 on the sintering and the properties of the si3n4 ceramics was researched in this paper. the samples with different amount of nano - al2o3 were obtained by using pressureless sintering at 1600, 1650, 1700 in the nitrogen atmosphere. the microstructure and the composition of the ceramics were determined by the means of x - ray, sem, micro - hardness meter etc. it is show that the sisty ceramics can be densified at 1650c to % percent of the theory density through the addition of nano - al2o3 ( the value could be 90 percent by other technique ). the crystalline growth of the cylindrical - si3n4 and the ratio of its longitude to its diameter are increased with the addition of nano - al2o3. a uniform microstructure and an fined crystal as well as more sialon phases can be obtained in the si3n4 ceramics through the addition of that
實驗結果表明：在碳管爐中、氮氣保護下進行燒結，添加劑為納米al _ 2o _ 3粉末時，由於納米粉末的高活性、高燒結驅動力，在1650就可使si _ 3n _ 4完全地燒結，並使其緻密度可達理論密度的96以上（比其它工藝高6左右） ；同時，納米al _ 2o _ 3地加入大大促進了長柱狀? si _ 3n _ 4的生長和發育及柱狀晶長徑比的提高，使微觀結構均勻、細化，形成了更多力學性能優異的固體? sialon相，減少了不利於陶瓷材料性能的晶間玻璃相，凈化了晶界。Methods : the method was based on the adsorption of organic solvents on activated charcoal, desorption with cs2 and analysis of the abtained solution by ffap capillary gc with fid detector
方法：用活性碳吸附管採集空氣中有機溶劑， cs2解吸，經ffap毛細管色譜柱分離，以氫火焰離子化檢測器檢測。An apparent activation energy of 182. 35kj / mol was obtained for the range of 1250 c to 1350 c, and that of 82. 32kj / mol for the range of 1350 c to 1400 c. at the same time, the relation between reaction velocity and reaction time is linear in the range of 1250 c to 1350 c, but it is a parabola curve in the range of 1350 c to 1400 c. so it can be concluded that the process undergone in the range of 1250 c to 1350 c is controlled by chemical reaction while that in the range of 1350 c to 1400 c by diffusion
本實驗採用的試樣是以鈦白粉和活性碳按1 ： 30的比例混合料為原料，在6mp下成型為37 . 2 26mm的柱形樣塊，分別在1250 、 1350和1400于氮化爐中測定反應速率與時間的關系。當反應在1250 1350時，表觀活化能為182 . 35kj mol 160kj mol ，反應速率與時間的關系是線性的，說明此階段反應由化學反應控制。當反應在1350 1400時，表觀活化能為82 . 32kj mol 160kj mol ，反應速率與時間的關系符合拋物線方程，說明此階段反應由擴散控制。分享友人