流動摩擦特性 的英文怎麼說

中文拼音 [liúdòngmócātèxìng]
流動摩擦特性 英文
flow friction characteristics
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 摩 : 摩構詞成分。
  • 擦 : 動詞1 （摩擦） rub 2 （用布、 手巾等摩擦使干凈; 揩拭; 抹） wipe; scrub; clean 3 （塗抹; 搽） spre...
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 流動 : 1. （液體或氣體移動） flow; run; circulate 2. （經常變換位置） going from place to place; on the move; mobile
  • 摩擦 : 1 （互相接觸的兩物體作來回相對運動） rub; chafe 2 [物理學] （相互接觸的兩物體在接觸面上發生阻礙相...
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  1. Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed

    本文在總結和分析了一個世紀以來有關曲線管道流動和換熱特性的研究成果的基礎上，以旋轉正交曲線坐標系統下的多參數旋轉螺旋管道中的對流傳熱為物理模型，通過攝動方法和有限體積法，首次對各種截面（圓截面、橢圓截面、環形截面、矩形截面）旋轉曲線管道內充分發展流動的流動結構和傳熱特性（包括耦合對流傳熱特性）以及旋轉曲線管道開口段發展流動的流動結構和換熱特性進行了系統的數值模擬和理論分析，詳細討論了各種無量綱參數對管道內軸向速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦系數比以及管道nusselt數的影響，獲得了若干創新性成果。
  2. It utilizes two boltclamped langevin transducers with unanimous frequency characteristic which convert vertical vibration to flexural traveling wave. they are arranged on the place of a elastic pipe to generated traveling - wave. when the traveling - wave propagate, the particles on the elastic pipe traverse an elliptic trajectory, materiel is transported by friction or acoustic streaming

    利用兩套頻率特性一致並以縱向振動方式工作的夾心式換能器，通過合理的布局在導管中激勵出行波，使輸送管管壁質點產生橢圓運動，從而利用摩擦或在液體中產生聲流來實現固體及液體的傳送。
  3. A method is provided to measure the friction parameters of the bed. the maximum friction torque, coulomb friction torque, viscous friction coefficient and moment of inertia can be gotten by fitting the free reduced rate curve of the gimbals and measuring the motor current when the motor begins to rotate

    提出了一種測量轉臺摩擦特性的方法，通過對轉臺在無外推力作用下的速度衰減曲線的擬合以及電機啟動過程電流和轉速的測量，可以得到最大靜摩擦力矩、庫侖摩擦力矩、粘滯摩擦系數及轉動慣量。
  4. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模，並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究，主要針對影響系統特性的主要參數變化，動態分析系統的輸出特性，在上下行工況中，分析了電機軸系粘性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響；最後對軸向柱塞泵馬達的流量壓力脈動對電梯轎廂速度的影響和蓄能器內油液體積損失機理進行了理論研究。
  5. The experimental results of the flow characteristics of the mmc heat sink indicate that the critical reynolds number signifying the transition from laminar flow to turbulent flow is in advance ; under the same experimental conditions, the variation in entrance direction of the microchannel inlet and outlet has little effect on the microchannel ; the experimental values of the friction factor of the de - ionized water in a microchannel agree well with those calculated using the theoretical laminar formula ; furthermore, a comparison of the experimental results and simulation results shows that navier - stokes equation and rng - turbulence model can be used to model the laminar and turbulence flow regions in a microchannel ; meanwhile, the correlations of the flow resistance in the turbulent flow regions for the de - ionized water as the working fluids are obtained from experiments

    對歧管式單通道熱沉流動特性的研究結果表明，微通道內流體流態由層流向紊流轉變的臨界雷諾數提前;改變流體的進出口方向對熱沉總壓降造成的影響很小;摩擦系數的實驗值與理論值較接近;數值模擬結果能夠與實驗值較好吻合;並由實驗給出了紊流區流動阻力的實驗關聯式。此外，選用十二烷基硫酸鈉（ sodiumdodecylsulphate ， sds ）以及烷基多糖苷（ alkylpolyglycoside ， apg ）作為減阻添加劑，研究了表面活性劑添加對微通道流動特性的影響。
  6. Presents a simple method of compensating friction against the character of the nonlinear model of a brushless dc motor system which transfers the original system model to a simple linear model using the method of input - output linearization, and estimates the coulomb friction in the system in real - time using a nonlinear friction estimator, and then compensate the friction in the system using a friction feedforward, and concludes from simulation results that this method can effectively eliminate the influence of friction in brushless dc motor systems

    針對無刷直流電動機系統的非線性數學模型特點，提出了一種簡單的摩擦補償方法.該方法首先利用輸入輸出線性化方法將原系統模型轉化為一種簡單的線性模型，然後給出一種非線性摩擦估計器實時估計系統中的庫侖摩擦值，最後利用摩擦前饋補償方法對其進行補償.模擬結果表明該方法可以有效地抑制無刷直流電動機系統中的摩擦影響
  7. Experimental study on heat transfer characteristics of nitrogen and subcooled water annular two - phase flow through a small vertical tube

    水平管內油氣水三相流動摩擦壓降特性的試驗研究
  8. In this paper, the working fluid is air. experimental study of the nine different structure parameters of 3 - d ift with staggered arrangement fins in the reynolds number range of 250 to 30000 is performed to investigate the characteristics of heat transfer and flow friction behavior. analyses and reduces the experimental data by the least square method, obtains the nusselt and fanning friction fitting criterion equations

    本文以空氣為工質，在re 250 30000范圍內對九根具有不同肋形結構尺寸的肋叉排三維內肋管的換熱及流動特性進行了研究，並運用最小二乘法分析和處理實驗數據，獲得努謝爾特數，范寧摩擦系數與雷諾數，肋幾何參數的準則方程式。
分享友人
分享到 Line

分享到臉書