流性樹脂 的英文怎麼說

中文拼音 [liúxìngshùzhī]
流性樹脂 英文
casting resin
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 樹 : Ⅰ名詞1 （木本植物的通稱） tree 2 （姓氏） a surname Ⅱ動詞1 （種植; 栽培） plant; cultivate 2 （樹...
  • 脂 : 名詞1. （動植物所含的油質） fat; grease; tallow 2. （胭脂） rouge 3. （姓氏） a surname
  • 樹脂 : resin; jaffaite; peucine
  1. Ema is monsanto ' s trademark for a series of white, odorless, freeflowing resins made by copolymerizing one mole of ethylene with one mole of maleic anhydride

    Ema是蒙山都公司生產的一組樹脂的商標，這些樹脂白色、無味、流動性好，是經1克分子馬來酐聚合而成的。
  2. The chemical reaction happens when the solution of water soluble resin is filled into formation and generates water indissoluble material. the material will shut off the water channel

    將水溶性樹脂脂溶液注入到油層中，溶液發生反應，生成不溶於水的物質，堵塞水流通道，從而達到堵水的目的。
  3. In the study of the effect of electric field on the binding property of copper foil - covered veneer sheet, because of lack of experimental method and the complexity of the object studied, it is not found the regular effect of electric field on the binding strength between copper foil and veneer sheet or on the inter - laminar binding strength of veneer sheet. but it is further testified that dc electric field makes the free linkage generated during solidifying of epoxy resins orient along the direction of electric - power line

    在直流電場對覆銅箔板粘接性能影響的研究中，由於受實驗手段和研究對象復雜性的限制，沒有發現直流電場對覆銅箔板銅箔與基體及基體層間的粘接強度產生規律性影響，但在研究中進一步證實了直流電場會使環氧樹脂在固化過程中形成的交聯鍵沿電場方向取向。
  4. The flow behavior of resin, water outlet structure at bottom of the mixed bed, water inlet position of hydraulic transportation, water intake ratio, and pneumatic transportation etc. have been analysed, giving out optimal selection of them combined with reality in the field

    對樹脂的流動性能、混床底部出水結構、水力輸送進水位置、進水比例以及氣力輸送等進行了分析，並結合實際給出了最佳選擇。
  5. Lzct bushing type current transformer is suitable for is suitable for current measurement ， metering and microcomputer protection of distribution equipments in 35kv and 10kv ac power system

    該型電流互感器的環型鐵芯和二次繞組採用優質環氧樹脂真空澆注在可阻燃的塑料殼體內，防潮濕，性能穩定，無需維護。
  6. Three porphyrin complexes of palladium were chosen as phosphorescence sensing molecules : palladium - meso - tetra ( trimethylaminophenyl ) porphyrin ( pd - tapp ), palladium - coporphyrin ( pdcp ) and palladium - meso - tetra ( p - sulfonicphenyl ) porphyrin ( pd - tspp ). they were bound to dowex resins, and made into oxygen sensor. we detected the characteristics such as sensitivities and response times combined with flow injection analysis ( fia ) technology

    選取了三種金屬鈀的卟啉配合物：四- （三甲氨基苯基）鈀卟啉（ pd - tapp ） 、鈀糞卟啉（ pd - cp ） 、四- （對磺酸基苯基）鈀卟啉（ pd - tspp ）作為磷光傳感分子，將其固定在dowex樹脂上，製成傳感器，並與流動注射分析技術（ fia ）結合起來，考察了其對氧的傳感靈敏性，時間響應特性等條件。
  7. The electrode was found to decrease the solubility of dithizone in alkalescence solution and effectively minish the lose of deoxidize state of metal. third, a potentiometric sensor was prepared by adding copper diethyldithiocarbamate directly into the carbon paste mixture, and the electrode was found has nerst response to copper ion in solution. and in our research two pharmaceutical selective electrodes were fabricated by coating polyvinyl chloride ( pvc ) which contained electroactive material on carbon rod electrode

    第二，利用- cd與環氧氯丙烷形成的交聯聚合物（ - cdp ） （不溶性）包合了雙硫腙，然後將- cdp與雙硫腙包合物樹脂作為修飾劑制備了碳糊修飾電極，利用陽極溶出伏安法（ asv ）測定了pd ~ （ 2 + ） ，實驗發現通過包合降低了雙硫腙在堿性溶液中的溶解度並且減少了金屬還原態的流失，取得了較好的效果。
  8. 3. considering the shortcomings of hydrosoluble - cyclodextrin polymer, such as easily water - absorbed properties and poor endurance in a high electric field, two - cyclodextrin - starch resin electrorheological particles ( wss - - cdp and cls - - cdp ) were synthesized by copolymerization through a mixture of - cyclodextrin and epichlorohydrin in the presence of water - soluble and water - insoluble starch, respectively. the structures of these polymers were characterized by ft - ir and raman s

    在4kv / mm直流電場作用下，由可溶性澱粉參與共聚的p一環糊精樹脂電流變液的屈服應力可達6 . 2kpa ，與不含澱粉的p一環糊精聚合物相比，約增加了35 % ，抗電場能力也可增至5kv / mm以上，且持續時間較長。
  9. And factors, such as flow velocity, the concentration of hmi in influent water and usual cations ( ca2 +, mg2 + ) or anions ( cl -, so42 - ) in raw water, which can influence the effect of hmi removal by wbaer from dk has also been discussed

    並分析了流速、進水中重金屬離子（ hg2 + ）的濃度以及原水中常見的陽離子（ ca2 + 、 mg2 + ）和陰離子（ cl 、 so42 ）對弱堿性陰離子交換樹脂去除飲用水中微量重金屬離子的影響。
  10. By varying flow velocity and the concentration of hmi ( hg2 + ) in influent water and adding usual cations ( ca2 +, mg2 + ) or anions ( cl -, so42 - ) into raw water, the effects of hmi removal by wbaer and cations exchange resins from dk have been contrasted

    試驗中通過改變流速（通過離子交換柱） 、進水中重金屬離子（ hg2 + ）的濃度以及向原水中引入天然水體中常見的陽離子（ ca2 + 、 mg2 + ）和陰離子（ cl 、 so42 ）等方法，比較了弱堿性陰離子離子交換樹脂和陽離子交換樹脂對飲用水中微量重金屬離子（ hg2 + ）的去除效果。
  11. On the contrary if resin ' s viscosity is very low, the capacity of resin in soiled thing become lower. both this two conditions can lead to decrease product ' s performance. in the manufacturing of fiber reinforced plastic production, measurement and control of resin viscosity is always a difficult problem to resolve

    樹脂的粘度越高，那麼其流動性越差，原材料外表面上的樹脂分佈就越不均勻；反之，如果樹脂的粘度很低，被浸漬物的浸膠量會過低，這兩種情況都將導致製品性能下降。
  12. According the key factors we find, we bring forward a new conception : multilevel suppressor and design a new high performance suppressor whose ion - exchange membrane has bigger areas and using three electrodes including one cathode ( anode ) and two anodes ( cathode ), at the same time we fill the suppression compartment with one kind of ion exchange resin which has moderate exchange capacity. according to our experiment ' s results, we find the new type suppressor has quite high working current efficiency and suppressing capacity. in most cases, the suppressor ' s current efficiency is over 90 % ; the suppressor can transform the naoh ( concentration : 200mmol / l, flow rate : i. oml / min, conductance : over 10000 i - i s cm " ) to pure water ( conductance : 8. 9 it s cm in chapter 3, the high performance suppressor is applied in determination some trace - amounts ions in plating solution, sewage. in this chapter, we also have a research on the gradient ion chromatography

    第二章首先以xyz - 1型電化學抑制柱為例，分析了電化學抑制柱的抑制過程得出影響抑制容量的主要因素主要是抑制柱的電流效率和離子交換膜的極限電流密度，因此採用中等交換能力的離子交換樹脂作為抑制室的填料以提高電流效率，在通常情況下電流效率可達到90以上；在選用同種離子交換膜的前提下，可通過增加離子交換膜的有效面積達到提高極限電流的目的從而提高抑制柱的抑制容量，因此提出了多級抑制的概念並據此研製了共電極式高容量電化學抑制柱，該抑制柱最高可將流速為1 . 0ml / min ，濃度為200mmol / l電導率超過10000 s ? cm ~ （ - 1 ）氫氧化鈉溶液抑制為電導率低至8 . 9 s ? cm ~ （ - 1 ）的純水，並且具有穩定性高、分析結果準確等優點。
  13. Effects of the resin flow on the bubble moving behavior

    樹脂流動對氣泡運動特性的影響
  14. Research progress of phenol - formaldehyde resin adhesive

    提高鑄造用酚醛樹脂流動性的研究
  15. The cbb90 capacitors are used for hight - frequency electricity circuit, having charcteristic of samll dimension, low disipation factor under hight - frequency condition, fine self - healing character, withstanding hight - voltage and powerful electricity. the case is used in flame retardant hith - quality engineering plastic, filled with epoxy resin

    Cbb90型電容器主要用於電磁爐振蕩電路，適用於高頻電路中，具有耐高壓及耐大流的優良特性同時具有體積小、優良的自愈性能、安全性能高、高頻下低損耗等特點，外殼採用優質的工程塑料，用環氧樹脂灌封。
  16. We establish equations based on the darcy theory and incompressible - flow continuity - equation

    根據darcy定律和不可壓縮流體連續性方程建立樹脂流動控制方程。
  17. Standard test method for resin flow of carbon fiber - epoxy prepreg

    碳纖維環氧樹脂預浸料坯的樹脂流動性標準試驗方法
  18. In a word, wbaer can effectively remove micro - quantity hmi from dk with alkali metals, alkaline - earth metals and anions at high concentration. on the basis of lots of regeneration experiments of wbaer ( d301g ), the best regeneration manner ( regurgitation regeneration ), the optimal regeneration agents ( h2so4 and naoh ) and the optimum operating parameters of regeneration are obtained

    論文進而對d301g型弱堿性陰離子交換樹脂進行了再生試驗研究，確定了最佳再生方式（逆流再生） ，最佳再生劑（ h2so4和naoh ）以及酸液再生時的最佳濃度范圍（ 2 % 4 % ）和最佳流速范圍（ 3 4m / h ） ；並通過正交試驗確定了逆流再生過程中的最佳運行參數組合。
  19. Method for the assessment of pot life of non - flowing resin compositions for use in civil engineering

    土木工程用的非流動性樹脂膠料的適用期評估方法
  20. This article presents a review of the chemorheology during the curing reaction of thermosetting resins. two different approaches in modeling the chemovisity of thermosetting resins are briefly described

    摘要本文討論了熱固性樹脂固化時化學流變性問題，並通過兩種途徑模擬了熱固性樹脂的化學粘度。
分享友人
分享到 Line

分享到臉書