流變粘度計 的英文怎麼說

中文拼音 [liúbiànniándùjì]
流變粘度計 英文
rheoviscometer
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  1. Ultrasonic has being attracted much attention gradually in fuel atomization because of some specialities of cavitation and infection on liquid flow. in the course of atomization of pitchy oil, especially, does it show greatly its advantage, but its material atomizational mechanism need research ulteriorly. the primary content of this thesis is about adding cantilever reed to effervescent atomizer so as to combine ultrasonic and effervescent. this thesis has discussed ultrasonic some mechanism, ultrasonic dynamical procreator, effervescent and liquid mucosity infection on atomization, at the some time we make some experiments and discuss atomization rule following some machinery parameter and run parameter so as to find some rule about ultrasonic atomization and to rich the research of ultrasonic atomization mechanism. all that will be beneficial to the design about ultrasonic atomization atomizer

    超聲波由於其空化機理及對液體的流變性影響等特性，在燃油霧化燃燒中逐步引起人們的重視，尤其在重渣油等高粘度液體的霧化過程中逐步顯示出其優越性，但其具體的霧化機理還需要做進一步的研究在氣泡霧化噴嘴基礎加入懸臂式簧片哨，將超聲波與氣泡霧化相結合是本文討論的主要內容本文從研究超聲波的一些機理入手，討論了超聲動力發生器氣泡霧化以及液體粘度對霧化質量的影響，並通過具體的實驗，根據實驗數據來討論霧化質量隨各種結構參數運行參數的變化規律，以便找到超聲霧化的一些規律，豐富對超聲霧化機理的研究，對超聲霧化噴嘴的設計具有一定的指導意義。
  2. According to the principle of mutual transformation between potential energy and kinetic energy, the vertically falling law of power law fluid by the action of unconstant static pressure and the relation between rheological parameter and time were studied, thus providing a theoretical basis for calculating the rheological parameters of fluid in funnel viscometer

    根據位能與動能的變化關系，作者研究了在非恆定靜壓作用下冪律流體垂直下落的規律及流變參數與時間的關系，從而為計算漏斗粘度計中流體的流變參數提供了理論依據。
  3. In addition to a comprehensive range of laboratory rheometer, contraves manufacture a series of viscometers.

    康特拉維斯公司除了生產實驗室流變儀的許多品種外，還生產一系列粘度計。
  4. The sort, material composite, structure properties and conduction mechanisms of eca ( electrical conductive adhesive ) were discussed in this paper. then three types of ega specimens were designed and made, on which temperature cycles test from - 55 ? to + 125 ? and thermal aging at + 125 ? were carried out. changes of the adhesive strength, eca ' s bulk resistance and contact resistance under the environment stress were summarized and a detailed evaluation on these specimens was given

    本文在全面闡述導電膠的分類組成、物理結構、導電機理的基礎上，設計並製作了三批導電膠樣品，通過對樣品進行長時間的- 55 ? ? + 125溫度循環和125高溫存儲試驗，總結了導電膠粘接強度、體電阻和接觸電阻在環境應力下的變化規律，對三類樣品的長期可靠性做出了全面的評價，並結合導電膠電阻率和「穿流閾值」的計算機模擬，給出了提高導電膠可靠性和電導率的建議，介紹了國內外在高電導率高可靠性導電膠研製方面的一些最新進展。
  5. Stirring viscosimeter is employed to research the rheological property of fresh cement paste with different superplasticizers

    用旋轉粘度計法研究了摻加不同高效減水劑的新拌水泥漿體的流變性能。
  6. The derivation of the leakage flow rate formula of the special annular clearance between the piston and cylinder under condition of variable viscosity in the axial piston pumps was carried out. at same time, considering the questions of the eccentricity and the variable sealing length of piston friction pair, the modified coefficient of the calculation formula of the flow - rate of the leakage was given

    在變粘度、柱塞偏心以及變密封長度條件下，對軸向柱塞泵中柱塞與缸孔之間的特殊圓環縫隙的泄漏流量公式進行推導，得到了該計算公式的修正系數； 6
  7. The flowing law of fluid and the determination of rheological parameters in funnel viscometer are not yet well settled up at home and abroad currently

    摘要流體在漏斗粘度計中的流動規律及流變參數的確定，是目前國內外尚未很好解決的問題。
  8. Standard test method for rheological properties of paste printing and vehicles by the falling - rod viscometer

    落桿粘度計測定漿料印刷和載色體流變性的標準試驗方法
  9. Graphic technology - determination of rheological properties of paste inks and vehicles by the falling rod viscometer

    圖形技術.採用墜桿粘度計對糊狀油墨和載色體流變性的測定
  10. To discuss the rheological effects of soft soil, shear strength is divided for rheological analysis. viscosity coefficient of remolding soil is used to modify partial parameters of routine soil mechanic tests. so the shear strength caused by rheological effects can be considered

    在前人研究的基礎上，本文採用對土體抗剪強度分類的方法研究了軟土的流變性，提出了重塑土粘滯系數的計算方法，重點分析了常規試驗中部分參數由於流變而引起的試驗誤差。
  11. The paper uses a high order method to solve incompressible viscous complex flows based on a domain decomposition and matched method, the primitive variable and pressure poisson equation formulation are employed for the numerical solutions of the incompressible navier - stokes equations, in tensor forms, on non - staggered grids

    本文採用了一種基於分塊耦合求解粘性不可壓縮復雜流場的高精度計算方法。計算模塊採用原始變量和壓力poisson方程方法，差分方程為張量形式的粘性不可壓縮navier - stokes方程組在非交錯網格上離散。
  12. Based on prandtl ' s momentum transportation, this paper calculates in detail the physical quantities such as eddy viscosities, and ratio of eddy viscosity to motion viscosity, total stresses with respect to relative position in three regions of viscous sub - layer, buffer layer, and main turbulent stream for non - newtonian fluid flowing turbulently in ducts, which according to karman ' s three layer models and measurement of fluid parameters in evaluation apparatus, discusses the influence of polymer drag reduction on flowing properties of non - newton fluid, analyzes quantitatively principle of turbulent reduction phenomenon and condition of increasing reduction rate

    摘要以普蘭德動量傳遞理論為基礎，按照卡門的三層模型，通過室內模擬環道用0號柴油及加入減阻劑在圓管內的流動參數的測定，計算了非牛頓型流體管內湍流邊界層的層流內層、過渡層、湍流中心的渦流粘度，渦流粘度與運動粘度比、總應力隨相對位置的變化等定量參數，探討了高分子減阻劑對非牛頓流體流動特性的影響，對湍流減阻現象的機理與增大減阻率的條件進行了定量分析。
  13. A simple pressure - reduced capillary viscometer was designed. it was used for studying the abnormal rheological properties of surfactant solutions, such as fluid patterns, thixotropy and negative thixotropy

    安裝了一種簡單的減壓型毛細管粘度計，用於測量非牛頓性表面活性劑溶液的流變性質，如判斷流體類型，判斷流體的觸變性及負觸變性等。
  14. The calculated value of shear force model fit well with the experimental results. it means that compare to the tensile stress during squeeze flow the shear stress can be omitted especially when the molding rat e is low and distortion rate is low

    拉伸粘度模型的計算結果與實驗結果吻合得相當好表明：在合模速率不大或變形率不是很大的情形下，擠壓流動過程中剪切力相對于拉伸應力可以忽略。
  15. A ndj - 4 type rotary viscometer made in shanghai has been ameliorated and calibrated, and a set of important rheological parameters for the evaluation of rheological properties of slurries has been obtained

    1 、對國產ndj - 4型旋轉粘度計的改良、校驗及其重要流變學參數估算。
  16. By applying four kinds of fluids and through contrasting the relevant parameters measured by rotary viscometer with the calculation results from funnel viscometer and rotary viscometer, it is indicated that the funnel viscometer is of relatively high measuring accuracy and can be well applied to the rheological design of drilling fluid

    文章最後應用四種不同性能的液體，採用旋轉粘度計實測的有關參量，與漏斗粘度計及旋轉粘度的計算結果對比，說明了漏斗粘度計在一定條件下具有較高的測量精度，能較好地用於鉆井液的流變學設計。
  17. Plastics - determination of dynamic mechanical properties - part 10 : complex shear viscosity using a parallel - plate oscillatory rheometer

    塑料.動態力學性能的測定.第10部分:用平行板振蕩電流計測定復切變粘度
  18. And at the same time, considering the situation of varying oil viscosity and oil - flow inertia, this paper analyzes flowing properties of fluid in bearing clearance, which provide theory reference for more reasonable design and application of hydrostatic bearing in the equilibrium of axial force, and then carries out computer simulation a nd experiment verifying

    同時，在考慮油液粘度變化和油流慣性的情況下，分析了支承縫隙中流體的流動特性，並進行計算機模擬和實驗驗證，這為靜壓支承在軸向力平衡中的進一步合理設計和應用提供了理論參考。
  19. Abstract : the article introduces cement slurry rheological characteristics and the method of determining the main parameters for cement slurry rheological characteristics, and analyses the difference between the rotation type and funnel type of viscometers in measuring plastic viscosity and apparent viscosity of cement slurry, and then the limitation of the funnel type of viscometer is described. the difference between rigidity and yield value is pointed out. finally through analysis of cement slurry rheological characteristics, the cement slurry filling mechanism is proposed, and the main factors affecting cement slurry are studied

    文摘:介紹塑性流體水泥漿的流變性及確定水泥漿主要流變參數的一般方法；分析旋轉式粘度計與漏斗式粘度計在測定水泥漿塑性粘度、表觀粘度時的區別，說明漏斗式粘度計在使用上的局限性；針對粘聚力（動切力）的測定進行分析，認為粘聚力與動切力為不同的概念.通過對水泥漿流變性分析，提出水泥漿充填機理，並對影響水泥漿擴散的主要因素，即粘度影響水泥漿在節理裂隙中向前擴散的速度，動切力限制水泥漿擴散距離作了說明
  20. Cone - based rheometer was modified to estimate the rheological properties of fresh mortar, which can measure yield stress and plastic viscosity of mortar in relative units. effects of many factors on rheological properties of mortar were studied. a set of test theory and method for designing rheological properties of mortar was recommended

    用它研究了各種因素對砂漿流變性的影響；證實了砂漿的屈服應力與塑性粘度是互相獨立的物理量，屈服應力決定變形能力，塑性粘度決定變形速率；為砂漿流變性設計提供了一套測試理論和方法。
分享友人
分享到 Line

分享到臉書