流變系數 的英文怎麼說

中文拼音 [liúbiànxìshǔ]
流變系數 英文
rheological coefficient
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. Changes in the microstructure of the trabecular meshwork may cause a decrease in outflow facility and an increase in iop

    小梁網顯微結構的改變能夠引起房水流暢系數的降低而升高眼壓。
  2. The paper described the building process of model that can identify the shock - absorber parameter of landing gear and at the same times optimize performance of system. in this paper, there are also some debate, it include identifying parameter which can not be measured, such as the air polytropic exponent and the orifice discharge coefficient of shock - absorber

    本文利用復合形優化演算法建立了起落架緩沖系統參數識別與系統優化模型，對緩沖器空氣壓縮多變指數和油孔流量系數等不可測參數的識別和著陸、滑跑載荷多目標優化問題進行了討論。
  3. Many factors have effect on irrigation uniformity. with the growing of pressure, how is irrigation uniformity of trickle irrigation varying on different condition of the diameter of drip line, the distance of emitters, the length of drip line, the style of emitters, the flux ratio of emitters and the face gradient of little irrigation district. the consequence shows that pressure has puny effect on irrigation uniformity

    滴灌系統的灌水均勻度受眾多因素的影響，本文通過毛管的管徑、滴頭間距、毛管的管長、灌水器的類型和灌水器的流量系數不同的情況下，灌水均勻度隨壓力水頭變化模擬結果顯示，壓力水頭對灌水均勻度影響非常小。
  4. According to the principle of mutual transformation between potential energy and kinetic energy, the vertically falling law of power law fluid by the action of unconstant static pressure and the relation between rheological parameter and time were studied, thus providing a theoretical basis for calculating the rheological parameters of fluid in funnel viscometer

    根據位能與動能的變化關系，作者研究了在非恆定靜壓作用下冪律流體垂直下落的規律及流變參數與時間的關系，從而為計算漏斗粘度計中流體的流變參數提供了理論依據。
  5. Eev should be selected for various refrigeration systems according to the thermal properties of refrigerants ; the discharge coefficient of eev is sensitive to the aperture and impulse quantity of eev ; when the eev structure is made, the discharge coefficient goes up with the lowering of evaporation temperature or goes down with the hoisting of the condensation temperature. it is le

    對于不同工質的冷藏集裝箱製冷系統，電子膨脹閥應該根據具體製冷劑的熱力性質選取；電子膨脹閥流量系數對孔徑和脈沖數比較敏感；在結構固定時，流量系數隨蒸發溫度的降低而升高，隨冷凝溫度的增加而增大，受過冷度變化的影響較小；電子膨脹閥的容量受孔徑影響最大。
  6. Some conclusions can be drawn from the experiment. first, the discharge coefficient of liquid is almost constant when the pressure before injecting is high enough, but the discharge coefficient of gas fluctuates because of the influence of liquid flowing. second, when the total pressure of gas is low, under the same total pressure, increasing the pressure before injecting or under the same the pressure before injecting, lowing the total pressure of gas make the mean diameter smaller

    流量特性試驗表明，在液體噴注壓降較高時，液體的流量系數基本不變，但是氣體的流量系數受液體流動的影響較大;霧化特性試驗表明，在同一氣體總壓條件下，增大液體噴注壓降或者在相同液體噴注壓降條件下，減小氣體總壓對液滴霧化有利。
  7. Then the thermal visualizations of jet impingement cooling with single or double row holes inside semi - enclosed ribbed channel are measured by using infrared camera and the effects of flow and geometry parameters on convective heat coefficients are obtained. the results show that : the impingement cooling effectiveness of ribbed surface is affected greatly by the jet - to - surface spacing, and the best effectiveness is achieved under the jet - to - surface spacing equals to 1. the correlation formulas of impingement heat transfer characteristics to the parameters are finally concluded and in good agree with the experiment data

    最後，對單排、雙排沖擊孔試驗板在半封閉通道展開了流量系數的研究，在變化各種幾何因素及流動因素的情況下由實驗得出了沖擊孔流量系數值，討論並分析了各種因素對流量系數的影響程度，建立了沖擊孔流量系數的準則關系式，與實驗結果對比表明:該準則關系式與實驗實測數據吻合較好，精度較高，有較高的工程應用價值。
  8. Deposits of foreign materials will change the sharp contours which govern its coefficient of discharge.

    雜質的淤積會改變決定流量系數的輪廓形狀。
  9. The fuel cells models are presented in chapter 3. based on the balance conditions in fuel cells stack, the dynamic performance is analyzed. the dynamic model is developed with a set of correlation equations of voltage, fuel utilization, current density and other variables involved in the operating course, which are some partial differential equations with variable coefficients

    第三章以熔融碳酸鹽燃料電池為例，以數值分析的方法，根據mcfc電堆發電過程中物質與電量平衡，分析了電堆的內部動態特性，就輸出電壓與燃料氣體利用率和電流密度等相關量建立了由一組變系數偏微分方程和積分方程描述的數學模型。
  10. Using compressed air and transformer oil as working substance, this paper studied the pressure characteristic of internal - mixing nozzle and acquired the experimental relation on the pressure in the mixing chamber of internal - mixing nozzle against the operation parameters and structure parameters according to the method of step by step regression

    摘要以壓縮空氣和變壓器油為工質對內混式介質霧化油噴嘴的流量特性進行實驗研究，並通過逐步回歸分析的方法獲得了內混式介質霧化噴嘴油、氣流量系數與運行及結構參數的實驗關系式，可供設計使用部門參考。
  11. The sofware design of drilling fluid rheology parameter automation detect system

    鉆井液流變參數自動檢測系統軟體設計
  12. The measurements of discharge coefficients and pressure coefficients along the models with aspect ratios of 0. 5, 1. 0 and 2. 0 were carried out under various aerodynamic and geometric parameters ( reynolds numbers : 20000, 40000, 60000, 80000 ; suction rates : 0. 3, 0. 45 and 0. 6 ; rib angles : 45, 60, 90, 120 ; rib height - to - width ratio h / e : 1. 0 and 2. 0 ; film hole location : middle of ribs. upstream of ribs and downstream of ribs ). based on the abundant experimental data and figures, rules of discharge coefficients and pressure coefficients in dependence of geometric and aerodynamic parameters were given out

    根據實驗課題的要求，在寬高比分別為1 . 0 、 2 . 0和0 . 5的內流冷卻通道里，在不同的氣動和幾何參數（雷諾數re分別為20000 、 40000 、 60000 、 80000 ，出流比sr為0 . 3 、 0 . 45和0 . 6 ，肋角分別為45 、 60 、 90 、 120 ，肋高h e分別為1 . 0和2 . 0 ，孔位分別為肋中間、肋下游和肋上游）的情況下，對流量系數和壓力系數以及流場進行了實驗研究，獲得了大量的實驗數據和圖形，較為詳細地給出了流量系數和壓力系數隨不同氣動參數和幾何參數而變化的規律。
  13. On the other hand, the hydraulic performance of the hole, including flow rate coefficient and uniformity of flow rate, have been tested as standards to evaluate the quality of holes punched by laser drilling machine with much better results than that punched by mechanical drilling machine. the shape of holes taken by a microscope photograph can also give detail and well explanations for this test results

    對噴孔水力學性能的試驗研究表明，本文提出的用噴孔水力學性能指標（流量系數和流量變異系數）來評價微噴帶激光打孔機質量的方法是可行的，並證明微噴帶激光打孔機的質量明顯優于機械打孔的質量，用顯微鏡觀察噴孔的形狀的照片也同樣證明了這一點。
  14. Time, the paper studies rheology of rockfillwith yin zongze model, of two yield surface and rheological relation of negative exponential, and some formulas are obtained it is difficult to determine the rheological parameters, of rock fills through laboratory test for the limited specimen, dimension, short duration and particle, constituents

    本文採用殷宗澤雙屈服面模型與堆石流變的負指數變化關系式，研究堆石的應力與流變關系，並推導了相應公式。在流變參數確定方面，由於室內試驗的試樣尺寸、時間比尺和顆粒破碎很難模擬現場條件，根據室內試驗直接確定堆石的流變參數是困難的。
  15. However aquaporin deletion did not significantly affect aqueous fluid outflow, volume or [ cl ' j, or anterior chamber compliance

    05 ） 。但房水排出流暢系數、房水間隙順應性、房水容積和氯離子濃度無明顯變化。
  16. Loading grads is another non - structure coefficient influencing loading characteristics except loading frequency. the low grads characteristics are analyzed deeply by simulation, and found that applying structure invariance principle with acceleration compensation can reduce loading grads effectively. the dissertation also simulates and compares the systems with connect hole of different size, and founds that the size of connect hole has an optimized value

    加載梯度是除了加載頻率之外另一個影響加載性能的非結構上的參數，論文作了大量的模擬分析來研究小梯度加載特性，得出了具有加速度補償的結構不變性原理可以有效的降低小加載梯度時的多餘力矩的影響;通過對具有不同的總壓力流量系數的系統的模擬比較，得出了連通孔的大小在不同工況下存在一個最優的值，其開度需要合理的選擇。
  17. The change of sound velocity with pressure, dryness degree, void - fraction, and phase - transition coefficient are analyzed. some important conclusions are derived

    分析了兩相流體中音速隨壓力、干度、汽隙率、相變系數等的變化關系，並從中得出了一些重要的結論。
  18. Because there are obviously multi - dimensional feature at the cleaning valve, we adopt the three - dimensional viscous flow field and the spalart - allmaras model to calculate the flow coefficient, to raise the solution of setting the boundary condition, to study the flow properties and corresponding parameter varying

    清洗液閥門具有明顯的多維流動特性，用三維流場計算其流量系數，採用spalart - allmaras湍流模型（簡稱s - a模型） ，提出了邊界條件的設定方法，來研究清洗液閥門的流量特性以及相應的參數變化規律。
  19. The osmotic pressure test was developed to determine the unknown, finite strain consolidation coefficient and convection coefficient in the mathematical model. the two coefficients both varied with effective stress and depth and were functions of initial void ratio, compressibility, permeability and permeability derivative along depth. a precise time step integration method was proposed to solve the finite strain osmotic consolidation equation with varied coefficients

    設計滲壓固結試驗確定理論模型中的待定系數有限應變固結系數和有限應變固結對流項系數，這兩個系數均為隨有效應力和土層深度變化的量，並且體現軟土初始孔隙比，壓縮性、滲透性及其沿深度變化等因素的綜合影響。
  20. The explicit method is widely used for its simpleness and little memory consumed with local time step and variable coefficients implicit residual smooth to accelerate the convergence procedure. according to yoon and jameson ' s ideas, an efficient implicit lu - sgs algorithm is carefully constructed by combing the advantages of lu factorization and symmetric - gauss - seidel technique in such a way to make use the l and u operators scalar diagonal matrices, thus the numeric algorithm requires only scalar inversion. the computational efficiency is greatly improved with this scheme

    顯式方法具有簡單，消耗內存小等優點，並採用當地時間步長、變系數隱式殘值光順等加速收斂措施，在定常流動的模擬中得到了廣泛的應用;根據yoon和jameson提出的簡化正、負矩陣分裂，構造的l 、 u運算元只需進行標量對角陣求逆，極大提高了流場數值求解過程的計算效率;採用newton類型的偽時間子迭代技術使時間推進精度提高至二階。
分享友人
分享到 Line

分享到臉書