流量系數 的英文怎麼說

中文拼音 [liúliángxìshǔ]
流量系數 英文
coefficient of discharge
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 流量 : rate of flow; flow; runoff; discharge; throughput; （flow） rate; quantity （of flow）; flux
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. Improvement of the orifice discharge coefficient may not result in stability improvement as illustrated in one test series.

    由一系列的試驗說明，噴孔流量系數的改善並沒有導致穩定性的改進。
  2. The paper described the building process of model that can identify the shock - absorber parameter of landing gear and at the same times optimize performance of system. in this paper, there are also some debate, it include identifying parameter which can not be measured, such as the air polytropic exponent and the orifice discharge coefficient of shock - absorber

    本文利用復合形優化演算法建立了起落架緩沖系統參數識別與系統優化模型，對緩沖器空氣壓縮多變指數和油孔流量系數等不可測參數的識別和著陸、滑跑載荷多目標優化問題進行了討論。
  3. Many factors have effect on irrigation uniformity. with the growing of pressure, how is irrigation uniformity of trickle irrigation varying on different condition of the diameter of drip line, the distance of emitters, the length of drip line, the style of emitters, the flux ratio of emitters and the face gradient of little irrigation district. the consequence shows that pressure has puny effect on irrigation uniformity

    滴灌系統的灌水均勻度受眾多因素的影響，本文通過毛管的管徑、滴頭間距、毛管的管長、灌水器的類型和灌水器的流量系數不同的情況下，灌水均勻度隨壓力水頭變化模擬結果顯示，壓力水頭對灌水均勻度影響非常小。
  4. The results showed that the discharge coefficient of film cooling hole was greatly increased with the increase of blow ratio when the blow ratio m is lower, buta it had a little increase with the increase of m when m is larger

    實驗結果表明，在吹風比較小時，隨吹風比的增加流量系數大幅度增加，當吹風比較大時，隨吹風比的增加流量系數增幅減小。
  5. Calcuated nornal folw coefficient

    正常計算流量系數
  6. Eev should be selected for various refrigeration systems according to the thermal properties of refrigerants ; the discharge coefficient of eev is sensitive to the aperture and impulse quantity of eev ; when the eev structure is made, the discharge coefficient goes up with the lowering of evaporation temperature or goes down with the hoisting of the condensation temperature. it is le

    對于不同工質的冷藏集裝箱製冷系統，電子膨脹閥應該根據具體製冷劑的熱力性質選取；電子膨脹閥流量系數對孔徑和脈沖數比較敏感；在結構固定時，流量系數隨蒸發溫度的降低而升高，隨冷凝溫度的增加而增大，受過冷度變化的影響較小；電子膨脹閥的容量受孔徑影響最大。
  7. On the basis of these results, the relations of total - pressure recovery coefficient or flow coefficient and flight mach number, angle of attack and the second movable wedge angle of the inlet have been founded by hypersurface fitting, then the mathematical model of the inlet is established

    根據流場計算結果並利用超曲面擬合方法建立了進氣道總壓恢復系數、流量系數與飛行馬赫數、進氣道攻角及二級可調斜板角度之間的關系，由此得到了二元混壓式超聲速進氣道數學模型。
  8. Some conclusions can be drawn from the experiment. first, the discharge coefficient of liquid is almost constant when the pressure before injecting is high enough, but the discharge coefficient of gas fluctuates because of the influence of liquid flowing. second, when the total pressure of gas is low, under the same total pressure, increasing the pressure before injecting or under the same the pressure before injecting, lowing the total pressure of gas make the mean diameter smaller

    流量特性試驗表明，在液體噴注壓降較高時，液體的流量系數基本不變，但是氣體的流量系數受液體流動的影響較大;霧化特性試驗表明，在同一氣體總壓條件下，增大液體噴注壓降或者在相同液體噴注壓降條件下，減小氣體總壓對液滴霧化有利。
  9. ( 2 ) on the leading edge, the film cooling effectiveness at the zone immediately downstream of the cooling holes is affected by blowing ratio and mainstream reynolds number, while the effects are not important in the downstream zone far from the cooling holes. ( 3 ) on the front half of pressure surface, the effectiveness increases with decreasing blowing ratio at the downstream near the cooling row and it is contrary at the downstream far from the cooling row. ( 4 ) on the rear pare of the pressure surface, the effectiveness decreases with increasing blowing ratio and does not vary so much downstream in the cases of higher blowing ratio

    研究結果表明葉片吸力面端壁附近區域壓力系數分佈呈現出較強的三維特性，動葉吸力面尤其明顯；氣膜孔流量系數隨吹風比的增加而增大，在高吹風比情況下，流量系數逐漸趨于常數；在不同型面區域，冷卻效率分佈有較大的差異，而且吹風比與主流雷諾數的影響程度也不盡相同；低吹風比下，孔出口下游附近可以得到較好的冷卻，中、高吹風比下，冷氣射流在加速流動主流的作用下返回壁面進行二次冷卻，孔下游較遠區域可以得到較好的冷氣覆蓋。
  10. Then the thermal visualizations of jet impingement cooling with single or double row holes inside semi - enclosed ribbed channel are measured by using infrared camera and the effects of flow and geometry parameters on convective heat coefficients are obtained. the results show that : the impingement cooling effectiveness of ribbed surface is affected greatly by the jet - to - surface spacing, and the best effectiveness is achieved under the jet - to - surface spacing equals to 1. the correlation formulas of impingement heat transfer characteristics to the parameters are finally concluded and in good agree with the experiment data

    最後，對單排、雙排沖擊孔試驗板在半封閉通道展開了流量系數的研究，在變化各種幾何因素及流動因素的情況下由實驗得出了沖擊孔流量系數值，討論並分析了各種因素對流量系數的影響程度，建立了沖擊孔流量系數的準則關系式，與實驗結果對比表明:該準則關系式與實驗實測數據吻合較好，精度較高，有較高的工程應用價值。
  11. Analysis on measuring discharge coefficient on the bridge of hydrology station in huma bridge

    呼瑪橋水文站橋測流量系數分析
  12. Deposits of foreign materials will change the sharp contours which govern its coefficient of discharge.

    雜質的淤積會改變決定流量系數的輪廓形狀。
  13. At the same time, when the thickness - diameter ratio was larger than 1, it has little influence on the discharge coefficient for the hole configuration, but when the thickness - diameter ratio was less than 1, the discharge coefficient of the hole with across arrangement is higher than that with sequence arrangement

    同時，在氣膜孔厚徑比大於1時，氣膜孔的排列形式對流量系數的影響不大，當厚徑比小於1時，叉排氣膜孔的流量系數要高於順排氣膜孔的流量系數。
  14. The result show that the position of free surface is higher because of frusta of brake, especial obvious in the head of frusta of brake ; flux coefficient and pressure on dam are quite influenced by type of frusta and 3 a type frusta of brake relative to 2 type frusta of brake has bigger flux coefficient and smaller pressure on dam ; obvious influence of ability of discharge flow for different ratio of thickness of frusta and breadth of brake and pressure on dam reduces with increasing ration of thickness of frusta and breadth of brake, while bigger flux coefficient is obtained when tlb = 0. 2

    結果表明，閘墩河海大學博士論文的存在抬高了水面線的位置，其中在閘墩頭部尤其明顯;墩型對流量系數和壩面壓力影響較大， 3a型閘墩相對於2型閘墩具有更大的流量系數和更小的壩面壓力:不同的墩厚閘寬比t / b對泄流能力也將產生顯著的影響，隨著墩厚閘寬比的增加，壩面壓力降低，而當t / b二0 . 2時溢流壩具有更大的流量系數。
  15. Using compressed air and transformer oil as working substance, this paper studied the pressure characteristic of internal - mixing nozzle and acquired the experimental relation on the pressure in the mixing chamber of internal - mixing nozzle against the operation parameters and structure parameters according to the method of step by step regression

    摘要以壓縮空氣和變壓器油為工質對內混式介質霧化油噴嘴的流量特性進行實驗研究，並通過逐步回歸分析的方法獲得了內混式介質霧化噴嘴油、氣流量系數與運行及結構參數的實驗關系式，可供設計使用部門參考。
  16. The measurements of discharge coefficients and pressure coefficients along the models with aspect ratios of 0. 5, 1. 0 and 2. 0 were carried out under various aerodynamic and geometric parameters ( reynolds numbers : 20000, 40000, 60000, 80000 ; suction rates : 0. 3, 0. 45 and 0. 6 ; rib angles : 45, 60, 90, 120 ; rib height - to - width ratio h / e : 1. 0 and 2. 0 ; film hole location : middle of ribs. upstream of ribs and downstream of ribs ). based on the abundant experimental data and figures, rules of discharge coefficients and pressure coefficients in dependence of geometric and aerodynamic parameters were given out

    根據實驗課題的要求，在寬高比分別為1 . 0 、 2 . 0和0 . 5的內流冷卻通道里，在不同的氣動和幾何參數（雷諾數re分別為20000 、 40000 、 60000 、 80000 ，出流比sr為0 . 3 、 0 . 45和0 . 6 ，肋角分別為45 、 60 、 90 、 120 ，肋高h e分別為1 . 0和2 . 0 ，孔位分別為肋中間、肋下游和肋上游）的情況下，對流量系數和壓力系數以及流場進行了實驗研究，獲得了大量的實驗數據和圖形，較為詳細地給出了流量系數和壓力系數隨不同氣動參數和幾何參數而變化的規律。
  17. On the other hand, the hydraulic performance of the hole, including flow rate coefficient and uniformity of flow rate, have been tested as standards to evaluate the quality of holes punched by laser drilling machine with much better results than that punched by mechanical drilling machine. the shape of holes taken by a microscope photograph can also give detail and well explanations for this test results

    對噴孔水力學性能的試驗研究表明，本文提出的用噴孔水力學性能指標（流量系數和流量變異系數）來評價微噴帶激光打孔機質量的方法是可行的，並證明微噴帶激光打孔機的質量明顯優于機械打孔的質量，用顯微鏡觀察噴孔的形狀的照片也同樣證明了這一點。
  18. Accurate calculation of flow coefficient of indirect diesel engine

    非直噴式柴油機瞬態流量系數的精確計算
  19. Cfd is also used to get the data of performance parameters of the nozzle at different nozzle pressure ratio, different nozzle area ratio and different geometric defected angle. the theory of function approximation is used to establish the transient model of thrust vectoring with the data calculated

    本文通過cfd計算獲得矢量噴管的性能參數，如流量系數、推力系數以及有效推力矢量角等與矢量噴管壓比、面積比以及幾何偏轉角之間的關系數據，並利用函數逼近理論建立了矢量噴管的動態數學模型。
  20. It is found in the experiments that film hole reynolds number and rib angle have great influence on film hole discharge coefficients

    實驗中發現氣膜孔雷諾數和肋角對流量系數有較大的影響。
分享友人
分享到 Line

分享到臉書