流體流量控制 的英文怎麼說

中文拼音 [liútǐliúliángkòngzhì]
流體流量控制 英文
fluid flow control
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 體 : 體構詞成分。
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 流體 : [物理學] fluid; fluor流體力學 fluid mechanics; hydromechanics; 流體生物學 hydrobiology; 流體運動學 hydrokinematics
  • 流量 : rate of flow; flow; runoff; discharge; throughput; （flow） rate; quantity （of flow）; flux
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. The argos regulator is an extremely versatile flow control device for gas applications where pressure reduction is required excellent in performance and easy maintenance are beneficial

    Argos減壓閥是一非常多用途的流量控制裝置，對瓦斯氣體要求精確減壓控制與維護簡單的使用尤其具效益。
  2. The cf4, gas was fed through a mks mass flow controller

    Cf4氣體通過mks的質量流量控制器流入。
  3. The two principles to reduce the electric current are ( i ) to minimise the potential difference between the conductive objects simultaneously touched by the person, ( ii ) to insulate as far as practicable all other metal parts that could be touched by the person

    而要減低電流額，理論上有兩個方法。其一是將人體可接觸到的導體電壓控制到最低或達致大致相等。而其二是令人體可接觸到的其他金屬部分盡量絕緣。
  4. In this thesis, based on a digital signal processor tms320f240, a controller for pmsm is researched an designed. we analyzes the mathematics model of pmsm, researchs vector control of pmsm and space vector pwm, discusses the controller of position, speed and current, designs the mrfas position controller, pid speed controller and pid current controller, sets up pmsm ac servo control system, designs dsp controller, and develop the corresponding sofeware. at last, the designed controller is simulated under matlab / simulink, and the results are gived

    分析了水磁同步電機的數學模型，研究了永磁同步電機的矢量控制方法和空間矢量脈寬調制原理，討論了位置環、速度環和電流環的控制方法，設計了模型參考模糊自適應位置控制器、 pi速度器和pi電流控制器，組建了永磁同步電機交流伺服控制系統，設計dsp控制器，並開發了相應的軟體。最後在matlab simulink環境下對系統進行了動態模擬，並給出了模擬結果。
  5. Secondly, to achieve the independent regulation of active and reactive power output from the generator side which is designed for the purpose of tracing the maximum wind - energy capturing. the paper has analyzed the mathematic model of the ac excited doubly - fed machine and the stator field orientation control strategy of the motor as vscf wind power generator. thirdly, it has put forward and designed the dual pwm converter with the capacity of energy flowing bidirectional aimed at the demand of rotor energy bidirectional flow. the author constructed reliable and integrated experimental system and did a series of experimental study including no - load, cutting - in network and power generation at, below and above the synchronous speed

    論文首先分析了風機運行特性及其最佳風能利用原理，通過模擬及實驗驗證了採用直流電機的輸出特性模擬風力機的最大輸出功率曲線的可行性，並給出了模擬系統的硬體結構；然後為了實現交流勵磁發電機有功、無功功率獨立調節機理，分析了交流勵磁雙饋發電機的數學模型和在追蹤最大風能捕獲變速恆頻風力發電時必需的定子磁鏈定向矢量控制策略；針對雙饋發電機轉子能量雙向流動的要求，提出並設計了具有能量雙向流動能力的雙pwm交流勵磁用變頻器；最後為實現從理論到實踐的全面研究，研製出了一套小功率完整的雙pwm變頻器交流勵磁的雙饋風力發電機實驗系統，進行了空載、並網、同步速及上、下的發電運行等一系列的運行實驗；所完成的模擬和實驗研究均驗證了理論、模型和控制策略的正確性、可行性。
  6. After these discussions, we ' ll focus on the implementation of traffic control on the linux operating system, including the new queue processing, new packet classify processing, the interface to the traffic control, the modification of network adapter driver. this thesis consists of five chapters. the first chapter analyzes the rapid development and the traffic control requirements of the distributed parallel firewall system, and points out the necessity for the implementation of load balance in distributed parallel firewall system

    為了解決以上問題，本文首先描述了整個分散式并行系統的邏輯結構，然後分析了現階段的linux自身的流量控制機制和流量分發技術;接著重點描述了分散式并行防火墻系統的流量控制和分發機制的整體設計以及相關的關鍵技術的研究和實現，主要包括下面的內容: linux自身的流量控制機制的改進、整個系統流量負載均衡的實現、網卡驅動程序的修改等。
  7. As the key of the sample injection, a digital control instrument of mass flow controller ( mfc ), which can work in online and offline mode, was designed. it can give 4 flow signals accurately at the same time. the concentration and flux of the sample gas can be set by the instrument software

    進樣裝置的核心是自行設計開發的新型流量控制儀，該儀器採用數字介面，可以以聯機和脫機方式工作，能夠同時快速準確地輸出4路流量控制信號，對測試氣體的流量和濃度進行設定。
  8. Chapter five include the content of the software flow chart of with - sensor vector - controlled induction motor driver system, the characteristic of data processing, and a novel debug method with modularization and incremental system build method

    第五章給出了帶速度傳感器矢量控制系統軟體實現的流程圖、數據處理的特點和一種新穎的模塊化的編程思路和分級遞增的調試方法。
  9. Can be used for both on - off and throttling control of fluid flow

    可用作流體流量的啟閉和節流控制。
  10. We implement : ( 1 ) communication flow control mechanism

    具體實現：通信流量控制機制；優先級調整機制。
  11. Organic bentonite - yh - 958 introduction : yh - 958 organic bentonite is the self - active organic bentonite. it can be added in every step of compounding paint, it no needs pre - gel or polar activator, it has perfect rheological, anti - settling and sag prevention. besides the characters of the other yh bentonite, yh - 958 function well in high gravity, low viscosity pigment solvent system

    Yh - 958和978產品是國內首創的自活化有機膨潤土，可在調漆的任何階段加入，無需預凝膠和極性活化劑，分散細度可在20um以下，可用於面漆和底漆，提供油漆體系理想的流變性能，控制沉降和流掛，除具備同類產品的特點以外， yh - 958在較少添加量，低粘度的高比重顏料體系中形成微弱的絮凝結構，防止顏料沉結
  12. Then, the influence of several hydraulic factors on the bedload transport is discussed. it is concluded that the amount of bedload transport is dominated by the runoff discharge in the datong station, and partially influenced by the range of tide

    文章進一步分析了各個水力要素對推移質輸沙的影響，發現長江口推移質輸沙總體上受大通流量控制，潮差對于推移質輸沙的影響只有在洪季才變得明顯。
  13. Study on the gas flow control of plasma nitriding system

    等離子體滲氮流量控制系統的研究
  14. 0. 58. 5 kgf cm2 oilless compressed - air pass through depressure, pressure stabilizing valve to keep its pressure constant, indicate by pressure meter, its pressure magnitude about 1 kgf cm2 then via flow control valve control flow, gas flowrator can indicate its gas valve generally at 60 standard liter hour

    0 . 5 8 . 5 kgf cm2無油壓縮空氣經減壓穩壓閥保持其壓力為恆定，由壓力表指示，其壓力大小約為1kgf cm2再經流量控制閥控制其流量大小，氣體轉子流量表可指示其氣量值一般在60標準升小時。
  15. In this paper, the on - off procedure and drive mode of high - speed on - off valves are introduced, the principle of pwm most in use recently is introduced. based on the forming method of pwm signal with software, the conclusion is drawn that the occupancy of pwm signal is only in relation to the control value calculated and the mean flowrate is linear to the control value when the carrier wave ( cycle and amplitude ) is chosen

    論文介紹了高速開關閥的開關過程和閥的驅動方式。介紹了目前最常用的流體脈沖控制方法?脈寬調制的機理。介紹了pwm信號的軟體生成方法，並由此證明，高速開關閥可以實現流量與控制量成正比的模擬控制所能實現的伺服控制功能。
  16. Application of plc in the technique for controlling gas flux

    在氣體流量控制技術上的應用
  17. And the relative knowledge on water engineering theory is embedded in these agents in the system, so it can do the flow - control for the pipeline network with the multi - agent system

    並且將給水工程理論的有關知識嵌入到這些主體中，從而實現了用多主體系統對自來水管網進行流量控制。
  18. That is, through analysis of the principle on flow control and " hydraulic transistor ", design and calculation of flow control characteristic as well as main parts in valve inner chamber, a piloted reducing valve will be installed between main valve and pilot valve. after a pressure - difference compensating reducing valve was added in the non - pressure compensating piloted reducing valve of the flow control valve in vlalvistor valve, the calculation on control characteristic emulation and load characteristic emulation has been carried out. the result of the calculation shows that after pressure compensating reducing valve was added, the linearity of the control characteristics has been greatly improved thus eliminating influence upon outlet flow by load pressure - change of the hydraulic system and improving performance characteristics of the hydraulic component

    文章還在對瑞典valvistor閥的插裝比例閥研究的基礎上，提出了一種新的流量控制原理，即：通過對流量控制和「液壓晶體管」原理的分析、流量控制特性及閥內腔主要結構件的設計計算，在主閥和導閥之間增設先導減壓閥，並進一步對valvistor閥的流量控制閥之無壓力補償先導減壓閥、加入壓差補償減壓閥后的控制特性進行了模擬計算和負載特性模擬計算，結果表明：增設壓力補償先導增壓閥后，其控制特性曲線變得非常線性，從而消除了液壓系統負載壓力變化對主閥輸出流量的影響。
  19. Wan standards typically describe both physical layer delivery methods and data link layer requirements, including physical addressing, flow control, and encapsulation

    廣域網路標準典型地描述實體層的傳送方法和資料鏈結層的需求，包括實體層定址，流量控制和封裝。
  20. 3. implementing the serial communication between the cms and lms. putting forward two rules for software flow control and data transmission, as well as implementing the relevant design for command frame, return frame and data frame of them

    （ 3 ）解決了cms與lms之間的串口無線通信問題，提出了一種軟體流量控制規程與數據傳輸規程，並設計了相應的命令幀、回應幀及數據幀的結構。
分享友人
分享到 Line

分享到臉書