流體溫度 的英文怎麼說

中文拼音 [liútǐwēndù]
流體溫度 英文
fluid temperature
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 體 : 體構詞成分。
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 流體 : [物理學] fluid; fluor流體力學 fluid mechanics; hydromechanics; 流體生物學 hydrobiology; 流體運動學 hydrokinematics
  • 溫度 : [物理學] temperature
  1. They can simulate the temperature field of the 2 kw crosscurrent co2 laser, draw some relative function charts and display the laminas of cooling fans in three - dimensions

    分別模擬2kw橫流co _ 2激光器箱體溫度場的分佈情況、繪制若干相關的函數圖象和以三維圖象顯示風機葉輪的幾何形狀。
  2. The paper discusses the methods of multi - objective ecological operation of reservoirs, which covers the establishment of legislation systems ; water demands for the basic ecological functions of downstream river channel ; reservoir discharge patterns simulating natural hydrological regimes ; regulation and control of sedimentation and eutrophication of reservoirs ; mitigation of the influences by water temperature stratification ; the operation techniques in pollution prevention and connectivity reinforcement of water systems

    文中討論了水庫多目標生態調度的方法，包括建立相應法規體系；保證維持下遊河道基本生態功能的需水量；模擬自然水文情勢的水庫泄流方式；進行水庫泥沙調控及水庫富營養化控制；減輕水體溫度分層影響；進行防污調度以及增強水系連通性等方面的調度技術。
  3. These anomalies might be due to the temperature variation of subsurface fluid that caused by transmission of long cycle waves through upper mantle or asthenosphere before the earthquake

    水溫異常出現的原因可能是由於地震前的長周期波通過上地幔或軟流層傳播，間接地導致了地下流體溫度發生了微小的變化。
  4. Main content in simulation is the spatio - temporal evolution of the set of descriptive variables characterizing tectonic mineralization state under coupling of various processes as following : ( 1 ) variables related to forming and property of ore - forming fluid, such as dissolution rate of minerals ( include metal minerals ) in rock, concentration and saturation of aqueous species in fluid, temperature, pressure, and ionic strength etc. ; ( 2 ) variables related to structural deformation and fluid flow, such as stress, deformation rate, fracture network, porosity, fracture permeability ; ( 3 ) variables related to precipitation and mineralization, such as nucleation rate of gangue and metal minerals, accumulation precipitation of various minerals, etc. ; ( 4 ) spatio - temporal coupling relation of various variables above, such as the coupling relationship between spatio - temporal evolution of fracture permeability and flow and focus of fluid and ore - forming

    模擬的主要內容是在各種過程耦合作用下，以下描述構造成礦體系的主要變量的時空演化：與成礦流體的形成和性質有關的變量，如地層中礦物（包括成礦物質）的溶解速率、流體中各組分的濃度與飽和度、流體溫度、壓力、離子強度等；與構造變形和流體運移有關的各變量，如應力與變形速率、巖石孔隙度、構造（斷裂）滲透率等；與沉澱成礦有關的變量，如礦物（金屬礦物和脈石礦物）的成核速率、各礦物的沉澱量等；上述各有關變量間的時空耦合關系，如斷裂滲透率時空演化與流體流動、匯聚和成礦的耦合關系等。
  5. A mixture of three amino acids ( arg, gly, glu ) labeled with fluorescein isothiocyanate ( fitc ) was separated in pdms microfluidic chip, the separation voltage is 200v / cm, the separation time is less than 120 seconds ; according to ccd fluorescence images, two distinct physical processes - stacking and destacking during sample injection were studied qualitatively ; rhodamine b, a kind of temperature - dependent fluorescence dye, was used as probe to develop a temperature - fluorescence intensity equation, then temperature - color map in microchannels was constructed, and temperature trait in microchannels on the pdms microfluidic chip was analysed. according to the results, we conclude that the electric field applied to the pdms microfluidic chip should not exceed 400v / cm

    利用pdms微流控晶元對fitc標記的精氨酸、甘氨酸、谷氨酸混合物進行了電泳分離，分離電壓為200v cm ，分離時間不到120秒；通過拍到的熒光顯微圖像對電泳注樣過程中復雜的樣品分子積聚與解聚現象作定性的分析；以熒光染料rhodamineb為溫度熒光探針，建立了pdms微流控晶元上的溫度-熒光強度的關系公式，並利用matlab圖像處理工具箱構建出微流體溝道內的溫度色圖，對pdms微流控晶元的微流道溫度特性進行了分析，根據實驗結果，我們認為對于pdms微流控晶元來說，在進行需要外加電場作用的試驗時，外加電場不應超過400v cm 。
  6. Analysis is done on the change rules of liquid " s temperature along with the pipeline " s distance. the paper points out the defects of the const pressure wave velocity method and do some improvements on it : rebuilding the expressions of the pressure wave velocity in accordance with the simpson ' s rule

    分析了管道內的流體溫度隨傳輸距離而變化的規律，並指出了此規律對管道負內壓力波傳播速度的影響。指出了常負壓力波波速定位方法的局限性，並採用改進的負壓力波定位技術，將管道內的負壓力波速公式採用復化辛普森公式進行了改造。
  7. This program can predict the wall temperature 、 internal wall heat tranfer coefficient 、 fluid temperature and entropy profile along the water wall. all of these provide an important foundation for designing this type of water wall structure to ensure the safety of the boiler operation. this hydrodynamic calculation program and the results can be used to analyze operation reliability and structure design of water wall system

    利用所開發的程序對設計的超臨界cfb進行了計算，給出不同負荷下，水冷壁出口工質溫度分佈，水冷壁受熱面不同位置處的金屬壁溫、內壁放熱系數、流體溫度焓值分佈，以及不同管子的流動壓降等結果，為分析鍋爐工作可靠性及水冷壁系統的結構設計提供了重要依據。
  8. Theoretical analysis of temperature changing rule of parallel and counter flow

    順流及逆流流體溫度沿程變化規律的理論研究
  9. After the 60 ’ s, the effect inclines to steady that farming production changes to the area of the lake. river basin temperature and rainfall changes fluctuate to the surface of the lake, and the effect coming into being sensitively displays out

    60年代以後，人類的農業活動對湖面變化的影響趨向穩定，流域溫度、降水變化對湖面波動所產生的效應敏感地體現出來。
  10. On the basis of the study on ore deposit geology, the paper discussed thedistribution of temperature field of ore body through mineral inclusion thermometry. combining with mineralizing elements distribution condition and the zoning feature of orefabrics, flowing direction of ore - forming fluid was also inferred in the paper

    在研究礦床地質的基礎上，使用礦物包裹體測溫方法，研究礦體溫度場的分佈，配合礦化元素的分佈狀態和礦石組構分帶特徵，推斷成礦流體的噴口位置和運移方向。
  11. 7 the investigation of the thermoeconomic performance of an existing facility used for thermal fatigue experiments of aircraft canopy reveals the possibility and practicability of taking measures to improve it significantly. a piping system with alternative variation of flow temperature exists in this facility

    對一現行的飛機座艙蓋熱疲勞試驗系統? ?即流體溫度升降交替變化的管路系統，進行了熱經濟行為的研究，揭示出它具有潛在與可行的重大改進方向和途徑。
  12. On the basis of vitrinite reflectance, organic inclusions and organic geochemical study, we can built the tectonic basin - mountain formation system, analyze the uniformed temperature - pressure field and tectonic stress field of undergroud fluid, and therefore recover the process of basin - range coupling

    藉助盆地中有機質的鏡質體反射率、有機流體包裹體、有機地球化學指標等參數可分析建立盆山構造地層體系和統一的地下流體溫度、壓力場及構造應力場，最終反演整個盆山的耦合歷程。
  13. Although the phere will normally dissolve in a few hours, the dissolving rate is a function of fluid temperature, fluid movement, friction, and absorbability of the crude

    盡管正常情況下清管器會在幾個小時內溶解，但溶解率是關于流體溫度、流體移動、摩擦和原油吸收力的一個函數。
  14. Analyzing of the heat transfer in microchannel heat sinks, finite element method is used to calculate the surface temperature, fluid temperature and the total thermal resistance of microchannel heat sinks with arbitrary base heat flux distribution

    在對微管道散熱器進行傳熱分析時，本文利用有限元法在微管道底壁熱量任意分佈的情況下，計算了微管道的壁面溫度和流體溫度分佈，最終得到了總熱阻值。
  15. Theoretical research for improving temperature distribution of fluid in wellbore using heat pipe

    熱管改善油井井筒流體溫度分佈的理論研究
  16. Establishment and application of a model for predicting fluid flowing temperature distribution in the multiphase flow pipeline

    多相管流流體溫度分佈計算公式的推導與應用
  17. Nanofluids exhibit superior heat transfer performance to conventional heat transfer fluids. one of reasons is that the suspended nanoparticles remarkably increase the thermal conductivity of the nanofluids. in this paper, the transient hot - wire instrument for measuring the thermal conductivity of sample nanofluids is developed

    研製了一套瞬態熱線實驗系統，測定了幾種納米流體的導熱系數，分析了納米粒子屬性、份額、形狀、尺度及納米流體溫度等因素對納米流體導熱系數的影響，探討納米流體強化導熱系數的機理。
  18. Temperature measurement techniques for microfluids

    微流體溫度測量技術
  19. If the fluid temperature is too high or contains the erosive substance, it would break the hoses

    流體溫度過高或流體帶腐蝕性成份，可能會令軟管破裂。
  20. In the past, piezoelectricity transducer was adopted usually in the ultrasonic flowmeter development, so in higher temperature, for example, exceeds 150 " c, the measurement was not carried out

    以往的超聲流量計均採用壓電超聲換能器進行測量，這樣在被測流體溫度較高，超過150的情況下，就無法進行測量了。
分享友人
分享到 Line

分享到臉書