流體潤滑 的英文怎麼說

中文拼音 [liútǐrùngǔ]
流體潤滑 英文
fluid lubrication
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 體 : 體構詞成分。
  • 潤 : Ⅰ形容詞（細膩光滑; 滋潤） moist; smooth; sleek Ⅱ動詞1 （加油或水 使不幹枯） moisten; lubricate 2 ...
  • 滑 : Ⅰ形容詞1 （光滑; 滑溜） slippery; smooth 2 （油滑; 狡詐） cunning; crafty; slippery Ⅱ動詞（貼著物...
  • 流體 : [物理學] fluid; fluor流體力學 fluid mechanics; hydromechanics; 流體生物學 hydrobiology; 流體運動學 hydrokinematics
  • 潤滑 : [機械工程] lubricating; lubrication; lubricate
  1. The best optimum mathematical model is constituted. scalar factor of structural parameter on loop rectangular negative pressure and adsorption slide is calculated. structural parameter, air gas source pressure carrying capacity and thickness of air cell are made sure by hydrodynamics and the theory of gas lubrication

    詳細論述了導軌副的設計過程，運用數學上的拉格朗日條件極值求解法，建立最優化數學模型，求出環矩形負壓吸附導軌的結構參數的比例情況，並運用流體力學和氣體潤滑理論確定了環矩形負壓吸附導軌的結構參數、氣源氣壓、承載能力和氣膜厚度的確定性結論。
  2. 2. sritable for revolve aport and swing sport when under heavy weight and slow speed, aswell the ccoasion that not form fluid impetus lubrication because of frequently open and closed in the course of loading

    2適用於高載低速下的旋轉運動搖擺運動及經常在超負荷下啟閉頻繁而不易形成流體動力潤滑的場合。
  3. In metal lubrication two distinct regions are recognized: boundary and hydrodynamic.

    在金屬的潤滑作用中存在兩個不同區段：邊界和流體區。
  4. Based on hydrodynamic lubrication theory, a rectangular tire tread model for simulating the viscous hydroplaning of tire is set up, taking into consideration the effects of hydrodynamic action, squeeze action and road roughness with numerical solutions obtained

    摘要根據流體動力潤滑理論，將輪胎貓性滑水問題模擬為胎面單元與路面之間的動壓、擠壓膜問題，同時考慮了路面粗糙度的影響，建立了輪胎胎面單元黏性滑水問題的數學模型，並進行數值求解。
  5. Some of the quantities involved in elastohydrodynamic lubrication may be mentioned.

    下面提供一些與彈性流體動力潤滑有關的量。
  6. Slightly dab your face, instantly making the dry and hard skin soft and smooth, become more clean and fresh. supercritical hydro - extraction technology, enhanced absorption, fully moistening your skin from inside out

    輕拍于面部，瞬間使乾燥發硬的肌膚變得柔軟嫩滑，笑容也生動起來；超臨界流體萃取技術，增強吸收效果，肌膚從內到外充分潤澤。
  7. Requirement : bachelor degree or above in fluids power transmission and control or mechanical engineering ; at least 3 years ‘ working experience in fluids engineering. ( preferably in design institute ) ; good knowledge of hydraulic and lubrication control system ; working experience in installation and commissioning of hydraulic and lubrication systems ; proficient in autocad and solidworks ; good english communication skills ( spoken and written ), team spirit

    要求：大學本科以上學歷，液壓傳動及控制專業；三年以上液壓潤滑系統設計工作經驗（有設計院工作經歷者優先） ；具有豐富的流體控制系統的知識；具有液壓和潤滑設備的安裝和調試經驗；熟練使用autocad ， solidworks等繪圖設計工具；有較強的英語口語和寫作能力，有團隊合作精神。
  8. Cw the feature of cw magnetic - driving vortex pumps is little capacity, high - head, it can convey the fluid containing 20 percent of gas and non - lubricative, also can be used to the occasion where npsh is low

    Cw型磁傳動旋渦泵，是小流量高揚程應用最理想的選擇;可輸送含有20 %氣體的介質，可應用於非潤滑性流體和汽蝕余量很低的場合。
  9. You are correct about the - 40c miscibility problems. the oil has to have a low pour point in order to flow and still have sufficient viscosity for the compressor lubrication

    你談到油在40度的溶解性的問題是正確的。油不得不具有有一個很低的流動點（流（動）點：油或其他液體在規定條件下流動的最低溫度） ，還需要有足夠的粘度作為壓縮機的潤滑作用。
  10. Pneumatic fluid power - compressed air lubricators - test methods to determine the main characteristics to be included in supplier ' s literature

    氣動流體動力.壓縮空氣潤滑器.供貨商文件包括主要特性測定的試驗方法
  11. Comparison of numerical methods for performances of journal bearing lubricated with couple stress fluids

    應力偶流體潤滑軸承性能計算方法的比較
  12. Performance of dynamically loaded journal bearings lubricated with micro - polar fluids

    基於微極性流體潤滑的有限長動載軸承特性研究
  13. Investigation on the change of the surface topographic featuresunder the liquid - solid two - phase fluid lubrication

    液固二相流體潤滑狀態下表面形貌特性的變化
  14. So studies on the liquid - solid lubrication not only have great significance to lubrication theory, but also have great value in application

    因此，研究液-固二相流體潤滑不僅對潤滑理論的發展具有重要的意義，而且也具有重要的應用價值。
  15. Based on an experiment performed on the piston ring - cylinder bore wear tester, liquid - solid lubrication is investigated in this thesis. the wear of the samples under different lubrication conditions ( the solid concentrations are 0 %, 0. 02 % and 0. 1 % by weight ) are discussed. the variations of the surface topography, especially the statistical parameters and functional parameters are studied, and the reasons that cause the variations are analysed

    本研究基於活塞環-缸套摩擦磨損臺架實驗研究了液-固二相流體潤滑的問題，探討了潤滑油中不含固體顆粒、含有0 . 02和0 . 1納米顆粒三種潤滑狀態下的磨損情況，並進一步研究了液-固二相流體潤滑狀態下試件表面形貌特性的變化，主要是統計參數和功能參數的變化，並探討了引起變化的原因，為更深入的液-固二相流體潤滑問題的研究以及表面形貌設計提供理論上的參考。
  16. Automotive fluid lubricants - determination of low - temperature viscosity - brookfield viscometer method

    車用流體潤滑劑低溫粘度測定法
  17. Most instrument ball bearing applications introduce a lubricating fluid to the contacts with the ideal goal of achieving complete surface asperity separation

    絕大多數的滾珠軸承應用流體潤滑劑來實現完全隔離表面粗暴接觸（摩擦）的理想目標。
  18. A general reynolds equation based on er fluid model is obtained, which can be easily extended to other non - newtonian fluids and this equation can provide theoretical basis for the hydrodynamic analysis of er journal bearings

    首次推導了基於電流變流體的潤滑問題廣義雷諾方程，並可擴展到其他非牛頓流體的潤滑問題，為進行基於電流變流體的滑動軸承流體動力潤滑分析提供了理論依據。
  19. Standard test method for evaluating thin film fluid lubricants in a drain and dry mode using a pin and vee block test machine

    使用銷釘和v形塊試驗機以排水和乾燥方式評定薄膜流體潤滑油的標準試驗方法
  20. Lubricants ; selection for lubricants for gears ; semi - fluid lubricants

    潤滑劑.齒輪傳動用潤滑劑的選擇.第2部分:半流體潤滑
分享友人
分享到 Line

分享到臉書