流體靜力試驗 的英文怎麼說

中文拼音 [liútǐjìnglìshìyàn]
流體靜力試驗 英文
hydrostatics test
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 體 : 體構詞成分。
  • 靜 : Ⅰ形容詞1. （安定不動; 平靜） still; calm; motionless 2. （沒有聲響; 清靜） silent; quiet Ⅱ名詞（姓氏） a surname
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 流體 : [物理學] fluid; fluor流體力學 fluid mechanics; hydromechanics; 流體生物學 hydrobiology; 流體運動學 hydrokinematics
  • 試驗 : trial; experiment; test
  1. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。
  2. Electric connectors - hydrostatic test procedure

    電連接器.流體靜力學試驗程序
  3. Thermoplastics piping systems. non - end - load - bearing elastomeric sealing ring type joints between pressure pipes and moulded fittings. test method for leakightness under internal hydrostatic pressure without end thrust

    熱塑料管道系統.壓力管和模塑配件的合成橡膠密封環型接合.在無軸向推力時內部流體靜力學壓力下密封性試驗方法
  4. Power electronics for electrical transmission and distribution systems - testing of thyristors valves for static var compensators

    電力輸送和配電系統用功率電子設備.靜態var補償器用閘流晶體管試驗
  5. Plastics piping systems - elastomeric sealing ring type joints and mechanical joints for thermoplastics pressure piping - test method for leaktightness under external hydrostatic pressure

    塑料管道系統.熱塑塑料壓力管道用的彈性密封環型接頭和機械接頭.外部流體靜壓條件下防漏密封試驗方法
  6. The experimental results show that, with the increase of three parameters the diameters of the droplets will all decrease

    試驗結果表明：隨著液體壓力、液體流量及靜電電壓的增加，噴霧霧滴粒徑都變小且分佈都會更均勻。
  7. And then in detail the paper explains the main technique in sliding construction, which includes jacking scheme, plan layout, assembly, transport and stacking of component, setting of sliding system, setting of track, conformation of falsework, traction facility etc. third, the paper researches on se veral key points which are sum - up about technics flow of sliding construction, the select of falsework by bearing capacity which was calculated through three methods, the theoretic discuss on auto - control, dynamic or static inspect and adjust

    然後對其中的重點問題作進一步的討論，包括滑移法工藝流程的總結；對胎架的選型參考腳手架的計算，運用規范、軟體程序等三種方法進行受力特徵分析，與已有腳手架試驗結果進行比較分析，得出較為符合實際的胎架承載力值；對滑移過程中的自動控制及動、靜態控制監測等做出了應用分析和理論上的探討。
  8. Aimed at the practical performance of soft clay, the static equilibrium equations taking consideration of effect of mass change, with the introduction of soil configuration, soil convection formula and mass conservation theory in soil, are derived, which reveal the phenomenon of coupling of total stress and seepage in equilibrium equations. then, some advisable experimental means are explored to determine the effect of mass change during consolidation. objective stress and strain should be used in large strain analysis

    針對軟粘土大變形固結的實際性狀，文中引入了土體構形的概念，土體傳運公式和土體質量守恆定律，並由此導出了考慮變質量效應的大變形固結靜力平衡方程，揭示了平衡方程中存在的總應力與滲流相互耦合的效應，並考慮了固液兩相的可壓縮性，進一步探索了測試變質量效應的試驗方法。
  9. Put up the cold experiment of the three - phase fluidized bed with multiple orifice balls, research on the influence of the superficial gas velocity, the filler static height and the liquid density on the resistance character and the desulfurized efficiency, summarize the virtue of multiple orifice balls

    摘要對多孔球為填料的三相流化床進行冷態試驗研究，研究不同工況下氣體空塔流速、填料靜止高度、噴淋密度等因素對流化床阻力特性和脫硫效率的影響。
  10. Thermoplastics piping systems - non - end - load - bearing elastomeric sealing ring type joints between pressure pipes and moulded fittings - test method for leaktightness under internal hydrostatic pressure without end thrust

    熱塑管道系統.壓力管和模塑管件的無端負荷彈性密封環型連接件.在無軸向推力時內部流體靜壓力下密封性的試驗方法
  11. The test results demonstrate that this prototype has excellent comprehensive performances such as small bulk, lower weight, high efficiency, high steady precision, fast dynamic response, wide range input voltage, good output waveforms, strong over - load and short - circuit ability, and strong function with different nature load and three - phase unbalanced load

    試驗結果表明，該變流器具有體積重量小、變換效率高、靜態精度高、動態響應快、輸入電壓變化范圍寬、輸出波形質量高、過載與短路能力強、帶不同性質負載和帶三相不平衡負載的能力強等優良的綜合性能。
  12. Three alterable experimental parameters were chosen : liquid pressure, flux and electrostatic voltage

    試驗選擇了3個可變操作條件：液體壓力、液體流量及靜電電壓情況下。
  13. Power electronics for electrical transmission and distribution and systems - testing of thyristor valves for static var compensators

    輸電和配電系統用電力電子設備.靜態無功功率補償裝置用閘流晶體管的試驗
  14. Abstract : the present paper deals with the design principle of the iron - nitride magnetic static sealing device, analyzes the bearingpressure ability and experiment, and states the success of the magnetic fluid safety valve for sealing and the testing results of thefunctional parameters

    文摘:敘述了氮化鐵磁性流體靜態密封裝置的設計原理、磁性流體靜態密封承壓能力分析和實驗驗證，成功地研製出"氮化鐵磁性流體密封安全閥" ，並取得磁性流體密封安全閥各種功能參數的測試結果
  15. In this paper, a shear mode mr elastomer damper was designed and manufactured ; the pulse responses of a one - disk cantilever rotor supported on the mr elastomer damper were experimented in the stationary state ; and the mechanical properties of the system were analyzed

    設計製作了一種剪切式磁流變彈性體阻尼器，試驗研究了支承在該阻尼器上的單盤懸臂轉子系統在靜止狀態下的脈沖激振響應，並分析了系統的力學特性。
分享友人
分享到 Line

分享到臉書