浮載作用 的英文怎麼說

中文拼音 [fúzǎizuòyòng]
浮載作用 英文
rafting
  • 浮 : Ⅰ動詞1 （漂在液體表面） float; drift 2 [方言] （在水裡游） swim Ⅱ形容詞1 （在表面上的） superfici...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  1. About the load, consider the vertical load, when under the action of water, consider the horizontal still water press, the press which erects to the surface of slide, and consider the effect of hydrodynamic load and earthquake. ( 3 ) the software about the frame design, apply the stiffening bar method and elastic foundation method to account the endogen

    對于荷載（或工況） ，考慮了外加垂直荷載；在有水作用的情況下，考慮了水平靜水壓力，垂直滑面的靜水壓力（也叫浮托力） ；考慮動水壓力的影響；同時也考慮了地震的影響。
  2. Abstract : experiments were made on a ultrasonic machining tool with work - piece adhered to ultrasonic transducer head, to machine micro - holes on hard and brittle materials such as soda glass and si, to study the effects of tool materials ， work - piece materials ， amplitude ， machining load ， slurry concentration ， tool length and the size of work - piece on machining rate and wear ratio. in this experiment, the micro - tool was made through wedg

    文摘:通過以wedg放電加工手段製作微細超聲加工用工具，在採用工件加振方式的微細超聲加工機上對碳酸玻璃、半導體硅等硬脆材料試件進行微孔加工的實驗，來探討在某一特定加工條件下工具材料、工件材料、工件的振幅、加工靜載荷、磨料懸浮液濃度、工具長度及工件尺寸等重要因素對加工速度、工具損耗率的影響，為微細超聲加工技術的實用化提供參考依據。
  3. The software adopts three kind of control mode to start up the data acquisition system, it ensures reliability of the acquisition system. the control system communicates with the shipborne support system adopting broadcast when down and timing when up, and requires return for the remote instructions, so it ensures the communications of the five bouys with the control and acoustic emission vessel. this software is based on assemble language of mcs51, it is held in the eprom in mcu

    控制和通信軟體採用設定採集時間表、外推採集與啟動採集三種方式控制採集系統，可靠地保證了遠程、無人值守浮標在長時間、連續工作情況下數據採集的很高的可靠性；控制和通信軟體採用下行廣播、上行時分的工作哈爾濱工程大學碩士學位論文方式實現各浮標與船載分系統間的通信，且無線電遙控指令執行反饋，可靠地保證了浮標與船載分系統間的通信。
  4. The authour investigate the dosing conditions and effect of the pac to the huanghe water - source, which includes the following four parts : the selection of the pac ; the confirmation of dosing scheme and effect of the pac ; the research of application of potassium permanganate in combination with pac ; the research of the pac ' s modification and the modified effectiveness. the experiment is mainly carried out on the pilot system in the jieyuan water plan of tianjin. the results of the reseach include the following : l ) the pac from zunhua plant is selected as the better carbon for the source water of tianjin through the experiment ; 2 ) through the pilot experiment we conclude that the pac ' s best adding point is the mixing tank and the better dose is 10mg / l, on which the codmn of filtered water can be decreased to 40 % and the effluent have no problem of odour and color ; 3the adsorbing experiment show that pac mainly adsorb the organic matters which molecular wt., distribution between 500 and 3000, and can adsorb organic matters whose molecular wt., distribution are bigger than 6000 if the dose of it is adequent ; 4 ) pac together with potassium permanganate can remove the organic matter more effectively than each of them alone, and reduce the rising trend of turbidity of the flotation ' s effluent due to adding pac ; 5 ) the thesis made a research on the surface properties and the adsorbing capability of the modified carbon by oxidizer : the modified carbon with 20 % h2o2 can remove more organic pollutants than the untreated one by 12 % when we add a higher dose of coagulant ; 6 ) the modification of reduction and loading metal ions are also sttldied, and drow the following conclusions : the modified carbon with 5 % ammonia can enhance the organic matter ' s removal effectiveness by 10 % to the tianjin source water than the untreated one, and the modified one with loading metal ion remove the organic matters from the tianjin source water better ( 8 % ) than the untreated one due to the strong affinity betwween the humic acid and copper ion

    本文的實驗主要是在天津芥園水廠的中試系統上完成的，論文的成果和結論主要包括： 1 ）通過靜態實驗選定河北遵化活性炭廠生產的煤質炭為適合天津原水的炭種； 2 ）中試實驗確定粉末活性炭的較佳投加點為混合池投加，較佳投加量為10mg l ，此時可使濾后水的cod _ （ mn ）降低40 ，且可較好地控制濾后水的嗅味和色度； 3 ）初步確定粉末活性炭對原水中有機物的吸附主要集中在分子量在500 - 3000范圍內，投量增大時可吸附部分分子量大於6000的有機物4 ）中試實驗表明：粉末活性炭與高錳酸鉀聯用可取得較兩者單獨應用時對有機物更好的去除效果，且對因投加粉末活性炭而造成的氣浮出水濁度升高有一定的改善作用； 5 ）研究並初步確定氧化改性對粉末活性炭表面性質和有機物的去除效果的影響：粉末活性炭的氧化改性會使其表面的酸性官能團大量增強，表面極性增加；經20的過氧化氫改性的活性炭在增大混凝劑投加量（ fecl _ 3投量為15mg l ）時對有機物的總體去除效果較原活性炭提高12 ， 1次氯酸鈉改性活性炭對有機物的去除效果較原活性炭提高6 ； 6 ）研究並初步確定還原改性、負載金屬離子對原水中有機物的去除效果的影響：經5氨水改性的活性炭可提高天津源水中有機物的去除率達到10 ；負載銅離子后的活性炭可提高對腐殖酸類物質的去除能力，一般可提高8左右。
  5. We obtained our transgenic material, the rice suspension cells, by inducing embryonic rice callus. then we constructed the expression vector pca - ced9, and transferred ced - 9 gene into the rice callus and embryogenic suspension cells. the work of using hygromycin selective medium to obtain regenerated plants is still going

    構建了用於水稻中表達的載體pca - ced9 ，通過農桿菌eha105轉化導入水稻愈傷組織和水稻懸浮細胞，經潮黴素（ hym ）篩選，以期望獲得抗性植株，目前該工作仍在進行中。
  6. A model experiment is made on an actual floating slab track, and the vibration transfer property of this track under three different frequencies of impact load is mainly tested

    對浮置板進行了1 ： 1模型試驗，主要測試了浮置板在3種不同頻率沖擊載荷作用下的振動傳遞特性。
  7. We have finished the semi - phsical simulation on the single axis turfing platform, which included on board prototype computer, optic fiber gyro and reocaon wheel which saturation chamaeristic has been taken into account

    本文採用瞬時歐拉軸控制演算法，在星載計算機原理樣機的基礎上，考慮反作用飛輪的飽和特性，根據所選擇的反作用飛輪和光纖陀螺，在單軸氣浮轉臺上進行半實物模擬驗證。
  8. Catalytic converter is one of the main countermeasures in controlling the automotive exhaust emission in the world. most of the gasoline engine of car and light duty truck have been installed the catalytic converter in the u. s., japan and europe. from the review and analysis of a great number of foreign literatures, a set of evaluation technique and test method for reliability of automotive catalytic assembly has been set up

    通過分析催化轉化器載體和墊層的特性，提出了懸浮式墊層封裝技術；並在在用車及新車催化轉化器的開發中提出了用金屬網催化轉化器作為預起燃裝置，同時採用陶瓷催化轉化器的復合型結構設計，殼體採用懸浮式封裝結構形式，催化劑採用稀土和貴金屬復合型，臺架試驗及實車試驗結果表明設計方案達到設計要求。
  9. Based on optimal control theory and equivalent optimal control theory, the optimal control method of elastic floating raft under shock and stochastic load is studied and the optimal control method and optimal parameter design method of the nonautonomous rigid - elastic coupling floating raft system are established

    摘要在理想最優控制理論和準最優控制理論的基礎上，對沖擊和隨機荷載聯合作用下，彈性浮筏系統的最優控制方法進行研究，建立了剛彈耦合非自治浮筏系統的最優控制方法和最優參數設計方法。
  10. The first step is to get the floating value by integrating the integer ambiguity of gps carrier signal as a state variable with ins. the second step is to get the fix value by integral filter algorithm. thirdly, the methods for detecting and compensating the cycle slip are researched

    其次研究了載波信號整周模糊度求解演算法問題，提出了一種新的求解方法，即把整周模糊度作為狀態變量通過與慣導的組合得到模糊度的浮動解，然後利用組合濾波器快速演算法來實現整周模糊度的求解。
  11. Basic structural parameters of magnetic bearings are analyzed and principles of selecting these parameters are introduced. basic characters of magnetic bearings are analyzed, including static working point, the largest magnetic force and power losses etc. assigning maximal magnetic force as objective function, the optimal design of radial magnetic bearing in magnetic levitated hard disk drive is completed, and the results of optimal design are presented

    對磁力軸承的基本結構參數進行了分析，闡述了這些參數的選用原則；對磁力軸承的幾個基本特性進行了分析，包括靜態工作點、最大承載力、功率損耗等；以最大承載力為目標對磁懸浮硬盤的徑向軸承進行了結構優化設計，並對優化結果進行了分析。
分享友人
分享到 Line

分享到臉書