浸入管 的英文怎麼說
中文拼音 [jìnrùguǎn]
浸入管
英文
immersion pipe-
The method of close water test has been used for a long time, so richer experience has been achieved. however, it not only takes pains and time, but also consumes raw materials during the close water test because of miscellaneous working procedures such as bricklaying in the two ends of pipe, water - repellent layer plastering, maintaining and water offletting, brick - block backouting after the test, especially in the region short of water and some drainage pipe with prop - pipe construction. in order to satisfy the fast development of municipal construction, new detection methods should be developed
閉水試驗方法因其應用時間較長，目前已積累了較豐富的經驗，但在閉水試驗時，管道兩端砌築磚堵、抹防水層、養護、灌水浸泡，以及試驗后的放水、磚堵拆除等繁雜工序，不僅費工、費時，而且消耗原材料，尤其是在缺水的地區以及頂管施工的無壓管道，這些矛盾更加突出；因此，為滿足迅速發展的市政建設需要，有必要探索新的檢測方法，閉氣試驗就是其中一種，但是閉氣試驗目前還不完善，有待于進一步深入研究。Section two the evaluation of biocompatibility of the acellular dermal matrix by the method of cell culture. the new born rat ' s epdermic cells were cultured with the acellular dermal matrix together as experiment group, while the epdermic cell were cultured simply as control. 24 hours later, under the invert microscope, the epidermic cells anchored well and transparent flat cells were observed in both groups. 7 days later, both cultured cells were taked out and fixed in 95 % ethanol, stained with hematoxylin and were observed under light microscope. many cleaved cells were observed in both groups. during cell culture, no pathogenic microganism was observed. so we considered the acellular dermal matrix was aseptic and had good biocompatibility. section three subdermal implantation of the acellular dermal matrix. 24 rats were used in the experiments. a piece of acellular dermal matrix ( 1. 5 x 1. 5cm2 ) was implanted beneath the dorsum skin flaps of each rat, 1 week, 2 weeks, 3 weeks and 4 weeks after implantation, 6 pieces of acellular dermal matrix were harvested and the size of implanted acellular dermal matrix were measured, the sections were used for he staining and observed under light microscope. the result were as folio wing : 1 - 2 weeks after implantation, the acellular dermal matrix began to adhere to the tissue around and turned red gradually ; 3 - 4weeks after implantation, the acellular dermal matrix adhered closely to the tissue around and could be recognized easily, 1 - 3 weeks after implantation, the size of implanted acellular dermal matrix had no statistical difference ( p > 0. 05 ). 4 weeks after implantation implanted acellular dermal matrix contracted ( p < 0. 05 ). under light microscope, l - 2weeks after implantation, the fibroblast cells infiltrated the acellular dermal matrix and a small amount endothelial cells of vessel and lympho - histiocytic cells infiltrated the acellular dermal matrix. 3 - 4 weeks after implantation, infiltrating blood vessels were evident. so we think that the acellular dermal matrix had low immunological reactions and could induce the infiltration of fibroblast macrophage cell and the endothelial cells of vessel
結果如下：皮下包埋卜周者，無細胞真皮基質漸與周圍組織粘附，顏色由蒼白轉紅；皮下包埋3周者，無細胞真皮基質與周圍組織緊密枯附，盾晰葉辯；術后卜周，包埋的基質面積變化較包埋前無統計學差異o川0引，術后4周包埋的無細胞真皮基質面積較包埋前縮小j刃刀5 ） 。光鏡下術后卜周，宿主的淋巳組織細胞、成纖維細胞浸入生長，釉附在膠原纖維上，少量血管內皮細胞浸入基質；術后34周，無細胞真皮基質內較多的血管形成，故可認為無細胞真皮基質免疫原性低，能誘導宿主的成纖維細胞、巨噬細胞浸入生長，為一種新型的真皮替代物。第四部分無細胞真皮基質與自體斷層皮片復合移棺的研究， sd大鼠10隻，在其背部卜方造成全厚皮膚缺損的創面According to the feature that deformation resulted from water absorption and mildew appear mainly on the rabbet surface of ccf, this paper adopts rsst to spray a special waterproof sealant on rabbet surface of ccf, so that the sealant can get into fiberboard to certain extent by means of capillarity and penetration, blockage the holes between fibers and capillary, cut up passage of water and change the properties of soakage and sorption to water in capillarity and fiber. at the same time, solidified sealant can form a compact waterproof pellicle on rabbet surface so as to prevent water and humidity from fiber ' s expansion and mildewing
針對吸水變形、霉變主要發生在地板企口表面的特徵，採用企口表面全封閉法，在復合強化地板企口表面噴塗特殊的防水封閉劑，使其依靠毛細管作用及滲透作用進入板內一定深度，堵塞木纖維之間的空隙及毛細孔通道，截斷水分傳遞的渠道，並改變毛細孔壁及纖維的表面性質以不利於水的浸潤與吸附，同時其固化后能在企口表面形成一層緻密的憎水薄膜，防止水分、濕氣從企口侵入板內引起木纖維膨脹變形、發霉等現象。Standard guide for conducting static, axenic, 14 - day phytotoxicity tests in test tubes with the submersed aquatic macrophyte, myriophyllum sibiricum komarov
在裝有浸入式水生大型植物狐尾藻屬sibiricum蜀試驗管里進行靜態無菌和14日植物毒性試驗的標準指南It has low power and can defrost or heat in the refrigerator and expositing cabinet. both the ends of the heater adopt the imported resin glue and vulcanizate for seal ment and high ni - cr stainless steel as the case. it has good corrosive resisting performance and the insulation resistance is still more than 1000 after immersing in the water and being electrified for a long time
本加熱器的特點為表面功率較小，在冰箱，展示櫃中起加熱化霜作用。電熱管兩端採用進口樹脂膠及硫化橡膠封口，外殼採用高鎳鉻不銹鋼，具有很好的耐腐蝕性能產品經長時間浸入水中通電試驗，其絕緣電阻仍1000m 。The sample should be collected in the same manner that is used to obtain a sample for dissolved oxygen i. e. by using a submerged tube or pipe inlet.
用與分析溶解氧同樣的取樣方法，即用一根浸沒水中的管子或插入導管排除空氣泡。Results there were 3 pathological characteristics in alhe : massive hyperplasia of capillaries in the dermis ; the endothelial cells proliferated and swelled, projecting into vascular cavity like tombstones ; mixed infiltration of lymphocytes and eosinocytes in the vessels
結果伴嗜酸性粒細胞增多性血管淋巴樣增生在病理學上有其特徵，形態學上的改變主要表現在以下3個方面：真皮內大量毛細血管增生；血管內皮細胞增生腫大，似「墓碑」狀突入血管腔；病變處有淋巴細胞、嗜酸性粒細胞混合浸潤。Standard test method for measuring the dip tube length of a mechanical pump dispenser
測定機械泵計量器浸入管長度的標準試驗方法So whatthefuck, whatthefuck yeah ( in the grave will you have time to pray ? )
蒸發的愛漫天覆遘g呼吸侵入散開浸滿血管遍布細胞滲進腦海For now, procuratorial work management system and administration of operating mechanism, make procuratorial work function and procuratorate administrative management functions of the administration of justice are crossed, mixed, cause administrative management function to procuratorial work invasion of function and is it soak to invade, keep to give full play to legal supervision function in check
就目前而言，檢察管理體制和運行機制的行政化，使檢察職能與檢察院內部司法行政管理職能發生交叉、混合，造成了行政管理職能對檢察職能的侵入和侵浸，掣肘了法律監督職能的充分發揮。Abstract : a new method of desulphurisation of hot metal by immersion is developed by immersing the steel tube filled with desulphurisation powder and propellant into molten iron. the desulphurisation powder is injected into molten iron by pressure produced by propellant decomposing when the steel tube is immersed into molten iron. feasibility of the technology of desulphurisation is discussed in theory
文摘:提出用裝有噴吹劑和脫硫劑混合物的鋼管插入鐵水中，利用噴吹劑受熱分解產生氣體形成的壓力將脫硫劑噴射到鐵水中進行鐵水爐外脫硫的一種新方法熱浸鐵水脫硫法，並從理論上對該法進行了可行性分析A new method of desulphurisation of hot metal by immersion is developed by immersing the steel tube filled with desulphurisation powder and propellant into molten iron. the desulphurisation powder is injected into molten iron by pressure produced by propellant decomposing when the steel tube is immersed into molten iron. feasibility of the technology of desulphurisation is discussed in theory
提出用裝有噴吹劑和脫硫劑混合物的鋼管插入鐵水中，利用噴吹劑受熱分解產生氣體形成的壓力將脫硫劑噴射到鐵水中進行鐵水爐外脫硫的一種新方法熱浸鐵水脫硫法，並從理論上對該法進行了可行性分析Test method for adequacy of fusion of extruded poly vinyl chloride pipe and molded fittings by acetone immersion
丙銅浸入擠壓聚氯乙烯管材和模鑄管件熔解充分性試驗方法Through analyzing the scaling mechanism of water injection system in mawangmiao oilfield, applying the measure of scaling prevention, such as improving injection water quality, using glass fiber reinforced plastic materials, changing tubing string structures, and adopting new inhibited acid for acid dipping, the water injection forming scaling in mawangmiao oilfield has been solved, and the water injection development effect has been improved correspondingly in oilfield
通過對馬王廟油田注水系統結垢原理分析，改善注入水水質、使用玻璃鋼材料、改變管柱結構和採用新型緩蝕酸浸泡等防垢措施，較好地解決了馬王廟油田注水系統結垢問題，相應改善了油田注水開發效果。Cathodic protection. external organic coatings for the corrosion protection of buried or immersed steel pipelines used in conjunction with cathodic protection. tapes and shrinkable materials
陰極保護.採用陰極保護的埋沒或浸入的鋼管防腐的外部有機塗層.帶子和可收縮材料Thermal insulating products for building equipment and industrial installations - determination of short term water absorption by partial immersion of preformed pipe insulation ; german version en 13472 : 2001
建築設備和工業設施用隔熱製品.部分浸入法測定預制管Standard test method for determining the dip tube length of a mechanical pump dispenser
測定機械泵計量器浸入管長度的標準試驗方法Abstract : according to the character and actual condition of rh in shanghai baogang, molten steel flow in ladle and its effect on decarburization were studied with a three dimension turbulent flow and concentration modelling. the results show that, within a certain range, the decarburization rate increases not only with the increase of snorkel diameter and ar fluid flow but also with the decrease of the immersed depth of the snorkel
文摘:根據上海寶鋼rh的特點和實際情況，建立了三維流場、濃度場程序，對鋼包內鋼水的流動、處理過程的脫碳進行了研究，並對它們的影響因素進行了分析.結果表明，在一定范圍內增加循環管直徑和吹氣流量、減小浸漬管浸入深度有助於提高脫碳速度Standard test method for the determination of the dip tube retention of a mechanical pump dispenser
測定機械泵計量器浸入管保持力的標準試驗方法Although the surface looks clean after mechanical cleaning, there will be embedding of tiny material on / in the upper surface of the stainless steel
盡管機械清理過后不銹鋼表面看起來已經很平整了，但仍然會有一些微粒浸入表層。分享友人