浸漬比 的英文怎麼說

中文拼音 [jìn]
浸漬比 英文
immersion ratio
  • : Ⅰ動詞1 (泡在液體里) soak; steep; immerse 2 (液體滲入) soak; saturate; steep Ⅱ副詞[書面語] (...
  • : Ⅰ名詞1 (地面的積水) floodwater on low lying land 2 [方言] (積在物體上難以除去的油泥等) stain;...
  • : Ⅰ動詞1 (比較; 較量高下、 長短、距離、好壞等) compare; compete; contrast; match; emulate 2 (比...
  1. Different factors influencing the effect of antibiosis finishing for knitted socks are experimented ; including concentration of finishing agent, dipping temperature, dipping time, baking temperature, baking time and bath ratio

    摘要通過實驗確定整理劑濃度、浴溫度、時間、焙烘溫度和焙烘時間對滌棉針織襪抗菌防臭整理效果的影響。
  2. The results showed that : there were five stages in the rising process of the internal temperature of untreated, fire - retardant solution soaked, and fire - proof paint coated wood during the fire ; the carbonization rate of wood decreased by 21. 1 % ~ 35. 6 % and the rising speed of internal temperature also declined greatly when wood was soaked in fire - retardant solution or coated with fireproof paint ; the carbonization rate of white pine was 8. 5 % ~ 17. 4 % higher than that of the northeast china ash ; for untreated wood, the carbonization rate in tangential direction was 5. 8 % ~ 10. 5 % higher than that in radial direction ; the internal temperature of wood varies with the developing direction of combustion

    結果表明:火災發生過程中未處理木材、阻燃處理和塗刷防火徐料木材內部溫度上升過程出現5個階段;經過阻燃處理和塗刷防火塗料后,木材的燃燒炭化速度降低了21 . 1 % ~ 35 . 6 % ,內部溫度上升速度大幅度下降;白皮松木材的燃燒炭化速度水曲柳木材的燃燒炭化速度快8 . 5 % ~ 17 . 4 % ;未處理木材沿弦向的燃燒炭化速度徑向快5 . 8 % ~ 10 . 5 % ;木材內部的溫度變化沿燃燒推進方向不同而不同。
  3. For 2h, the osc and special surface area decreased sharply, meaning a bad thermal stability. the osc and special surface area of the samples prepared by precipitation keep very well after aged, exhibiting a promising thermal resistance. while the samples prepared by dipping method have a much more stable osc at different temperature, that is, they have a good thermal stability

    研究表明,採用溶膠?凝膠法制備的樣品在老化前具有最大的儲氧量和表面積,但經高溫老化后,其儲氧量急劇下降,表現出很差的抗高溫老化性能;採用沉澱法制備的樣品在老化前後,其儲氧量和表面積降幅最小,有良好的高溫熱穩定性能;採用法制備的樣品不管老化與否,其儲氧量並不隨著儲氧溫度的改變而大起大落,表現出較好的熱穩定性。
  4. The graphitized cathode block samples have been trial - produced using high quality eca ( electrically calcined anthracite ) rationed petroleum coke and pitch coke and quantitative pitch used as raw materials by the conventional carbon technics concluding moulding, baking, high pressure impregmating, after - baking and graphitization

    摘要選取優質電煅無煙煤,分別配以一定例的石油焦和瀝青焦作為骨料,與煤瀝青混合后按照模壓成型、焙燒、高壓、二次焙燒和石墨化等常規炭素製品生產工藝流程制備石墨化陰極材料試樣。
  5. Testing of carbon materials - determination of density with liquid pycnometer - binding and impregnating materials

    炭素材料檢驗.用液體重計測定密度.粘結劑與
  6. Here is a loving portrait of a man who lived for fishing, who had “ the bay of biscay breaking in his eyes ”, who “ spread the black honeycomb of his nets wide on the waters, filled them with the salt sweetness of the sea, lifted them dripping with moonlight and fish

    這是一幅以漁為生的男人溫情的肖像描畫: 「斯開灣闖入他的眼簾」 , 「在海面上,他遍撒下黑色蜂窩狀漁網,將其于海水咸津的香甜之中,隨後起網,便捕獲到滿兜的魚兒連同月光。
  7. The oxidizing kinetics equations of different dipping time of dipping two kinds of phosphate saturable solution were determined. the influences of dipping time of dipping two kinds of phosphate saturable solution on antioxygen properties of sic kiln furniture were also studied. the effect of dipping two kinds of phosphate saturable solution were compared. both of their best dipping time were determined

    探討兩種磷酸鹽飽和溶液次數對窯具材料結構和性能的影響,確定兩種磷酸鹽飽和溶液不同次數的氧化動力學方程,分析其對sic窯具材料抗氧化性的影響,較兩種磷酸鹽飽和溶液的效果,並確定各自的最佳次數。
  8. The honeycomb board impregnated absorbant can reach less reflection within wider frequency band and better mechanical performance and very little density. all these characteristics make it as an material to fabricate some parts of the aircraft

    吸收劑的蜂窩板可以在寬頻帶范圍內達到較小的反射、有很好的力學性能和很小的重,這些特點成為製造飛行器吸波結構的最重要的材料。
  9. Plastics - methods for determining the density of non - cellular plastics - immersion method, liquid pyknometer method and titration method

    塑料.非泡沫塑料的密度測定方法.法液體重瓶法和滴定法
  10. Plastics - methods for determining the density of non - cellular plastics - part 1 : immersion method, liquid pyknometer and titration method

    塑料.非泡沫塑料的密度測定方法.第1部分:法液體重瓶測量和滴定法
  11. After dipped in amino trimethylene phosphonic acid ( atmp ) solution, anodic oxide films are annealed in pipe stove. the influences of concentration and temperature of atmp solution and annealing temperature on rising time, withstanding voltage and specific capacitance of anodic oxide films are studied. after hydration, anodic oxide films treated with atmp or not are analyzed by ft - ir

    2 .將化成箔在氨基三甲叉膦酸( atmp )溶液中,取出烘乾后再進行熱處理,研究了atmp溶液濃度、溫度和熱處理溫度對氧化膜升壓時間、容、耐電壓的影響,找到其最佳耐水合處理工藝;採用ft - ir對水合作用后的atmp處理氧化膜和未經耐水合處理氧化膜進行了分析。
  12. The optimum concentration and temperature of dtpmp solution and optimum annealing temperature are discussed. in addition, hydration resistant effect of anodic oxide films treated with adp, atmp and dtpmp respectively is discussed through ft - ir, xps, afm and i - v characteristics testing

    探討了dtpmp溶液濃度、溫度和熱處理溫度對氧化膜升壓時間、容、耐電壓的影響,並找到其最佳耐水合處理工藝;同時採用ft - ir 、 xps 、 afm和i - v特性測試對adp 、 atmp 、 dtpmp三種試劑對氧化膜的耐水合處理效果進行了對研究。
分享友人