浸潤作用 的英文怎麼說

中文拼音 [jìnrùnzuòyòng]
浸潤作用 英文
immersional wetting
  • 浸 : Ⅰ動詞1 （泡在液體里） soak; steep; immerse 2 （液體滲入） soak; saturate; steep Ⅱ副詞[書面語] （...
  • 潤 : Ⅰ形容詞（細膩光滑; 滋潤） moist; smooth; sleek Ⅱ動詞1 （加油或水 使不幹枯） moisten; lubricate 2 ...
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 浸潤 : 1. （漸漸滲入） soak; infiltrate 2. [醫學] infiltration; 浸潤灌溉 irrigation by infiltration
  1. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先，對液體介質的靜電霧化機理作了初步的探討，理論上分析了液體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對液體荷電方法進行了研究分析，對于高電導率的液體，場致荷電和接觸荷電可以使其霧化，而對于電導率較低的絕緣液體，需用浸潤電極荷電和感應荷電方法使其充分帶電;最後，根據前面的研究分析，設計和組裝試驗裝置，在同一環境下對煤油、乳化劑、酒精三種不同液體介質進行高壓靜電霧化試驗，並對試驗結果進行分析處理，總結出液體靜電霧化與液體表面張力、電導率和粘度的關系及電壓對液體靜電霧化的影響等，得出高壓靜電場中液體霧化的一般規律。
  2. According to the feature that deformation resulted from water absorption and mildew appear mainly on the rabbet surface of ccf, this paper adopts rsst to spray a special waterproof sealant on rabbet surface of ccf, so that the sealant can get into fiberboard to certain extent by means of capillarity and penetration, blockage the holes between fibers and capillary, cut up passage of water and change the properties of soakage and sorption to water in capillarity and fiber. at the same time, solidified sealant can form a compact waterproof pellicle on rabbet surface so as to prevent water and humidity from fiber ' s expansion and mildewing

    針對吸水變形、霉變主要發生在地板企口表面的特徵，採用企口表面全封閉法，在復合強化地板企口表面噴塗特殊的防水封閉劑，使其依靠毛細管作用及滲透作用進入板內一定深度，堵塞木纖維之間的空隙及毛細孔通道，截斷水分傳遞的渠道，並改變毛細孔壁及纖維的表面性質以不利於水的浸潤與吸附，同時其固化后能在企口表面形成一層緻密的憎水薄膜，防止水分、濕氣從企口侵入板內引起木纖維膨脹變形、發霉等現象。
  3. The interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity

    研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大
  4. Abstract : the interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity

    文摘:研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大
  5. Parafin was emulsion is used to humidify when the fiberglass is produced

    拉制玻璃纖維原紗時採用石蠟乳劑作浸潤劑，其含量不大於2 . 2 % 。
  6. Based on the analysis of external and internal enviroment of cpic " s products. it " s forwarded the differnization through swot under cheap cost should be adopted by chongqing polycomp international corporation for its fiberglass products competion and development strategy. hence cpic should enlarges its production scale gains scale benefit, strengthens its international distribution and construction of domestic sales net, establishs the first class r & d center, wenkens its sizing sales

    在對該公司玻璃纖維產品內外環境分析的基礎上，作者用swot矩陣提出該公司玻璃纖維產品的競爭和發展戰略是應該採取較低成本的差異化戰略，為此，該公司應擴大生產規模以獲取規模效益、加強產品的國際化營銷和國內營銷網路的建設、建立一流的技術研究開發中心、弱化浸潤劑產品的銷售。
  7. In the present thesis, znse, znte and their quantum well ( qw ) structures on si substrates with zno as buffer layer by low pressure metal - organic chemical vapor deposition ( lp - mocvd ) technique were prepared. zno is selected as the buffer layer for it has many similarities with the oxide layer on the surface of si wafer. all important experimental results and conclusions presented in this thesis are summarized as follows : 1

    本文中，我們利用zno與si襯底上氧化層? sio _ x有很好的浸潤性這一特點，採用zno作為緩沖層，用低壓-金屬有機物氣相沉積（ lp - mocvd ）設備在si襯底上生長znse和znte薄膜以及zncdse znse和zncdte znte量子阱結構，並對其發光特性進行了研究，獲得的主要研究結果如下： 1 、在si襯底上獲得了較高質量的zno薄膜。
  8. The presence of the lymphocytic infiltrates in this edematous islet suggests an autoimmune mechanism for this process

    水腫的胰島內出現淋巴細胞浸潤暗示自身免疫作用。
  9. ( 4 ) on the basis of analysed result and the status quo of huxi bank, computing the slope safety and seepage of bank by fem. the result shows that the tarus quo of huxi bank could not satisfy theslope safety on designed flood lever. after the reinforcement of seepage, the method can not only reduced leakage, debace the soggy but also ameliorate stress fields. lt also can reduce horizontal displacement and certical displacemeng which have disadvantages to bank

    進行堤體防滲加固后，不但可以減少滲漏，降低堤身浸潤線，還可以有限度地提高抗滑穩定安全系數，改善堤身及地基的應力場，使在高水位作用下產生的不利於堤體安全的水平位移和豎向位移減小。對在後繼采動中可能造成的防滲材料的破壞進行了校核，結果表明材料是安全的。
  10. Being a kind of adhesion molecules associating cells with extracellular matrix, integrins play a variety of roles in the process of invasion and metastasis in pancreatic adenocarcinoma

    胰腺癌手術切除率低死亡率高的重要原因之一是腫瘤早期即能發生局部浸潤和遠處器官轉移，整合素作為細胞與細胞外基質的黏附分子，在胰腺癌侵襲及轉移過程中發揮多重作用。
  11. The addition of mg reacts with al and sio2 then form mgal2o4 at the interface in the sicp / al composites ; it reacts with sio2 and produce mgo at the interface in sicp / al - si composites, the good metal - ceramic bond is achieved

    當mg含量為1 . 0時，對復合材料的力學性能和微觀組織結構改善程度最大。另外發現mg與空氣中的氮氣反應生成的mgn _ 2對sic顆粒增強復合材料的浸潤性也有改善作用。
分享友人
分享到 Line

分享到臉書