浸蝕腐蝕 的英文怎麼說

中文拼音 [jìnshífǔshí]
浸蝕腐蝕 英文
erosion corrosion
  • 浸 : Ⅰ動詞1 （泡在液體里） soak; steep; immerse 2 （液體滲入） soak; saturate; steep Ⅱ副詞[書面語] （...
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  1. Ferrous sulphate treatment improves the erosion rate of the alubrass. the corrosion rates observed are however higher than that obtained with mexel 432

    硫酸亞鐵處理改善鋁黃銅的浸蝕率，然而其腐蝕率仍高於m . 432處理。
  2. Fuhong class a inorganic dampproof fireproof board adopt natural minerals, featuring good performance in water, sunshine, acid rain, and frosted condition, its lifespan can last as long as more than 20 years, it keeps room warmer in winter and cooler in summer, damp - resistant, wet - resistant, it is applicable to island climate, and wont generate halogenation like ordinary fireproof board

    福宏a級無機防潮防火板：為天然礦物研製而成，具備了礦物應有的特性，長期水浸日曬酸雨寒凍也不脫層變質或腐蝕，使用壽命更可達20年以上且冬暖夏涼，又能抗濕抗潮，更能適合海島型氣候，絕不會有一般防火板材的反鹵現象。
  3. They immersed a lead object first in copper acetate ( a compound made by letting vinegar corrode copper ), and then in a silver solution created by dissolving silver chloride in dilute ammonia ( which ancient chemists made from urine )

    它們首先把鉛製品浸沒在醋酸銅（通過醋酸腐蝕銅而制得的化合物）中，然後放在銀溶液中，銀溶液是通過把氯化銀溶解在稀釋的氨水（古代化學家從尿中制得）中而制得的。
  4. The control system of mould level is crucial to improve the slab quality in the continuous casting process, pid controller is used in the traditional mould level control, and it has some defaults, such as : at the start - up or finishing period of casting or during the changeover of tundish, pid control has a bad effect, its overshoot is large and its transient time is long ; the erosion of the tundish stopper and the submersed nozzles lead to the accuracy of control become bad ; the abrupt falloff of block in the submersed nozzles makes the level acutely fluctuate, and pid control can not overcome the disturbances resulted from the change of casting speed

    結晶器液位控制系統是提高連鑄產品質量的關鍵環節，傳統的連鑄機液位控制方法採用常規的pid控制，存在如下不足：開始、結束澆注和換中間罐澆注時，控制效果差，超調量大，過渡時間長；塞棒頭和浸入式水口被腐蝕后引起控制精度差；浸入式水口堵塞物的突然脫落所引起的液位劇烈波動；無法克服拉速波動引起的擾動。
  5. It has low power and can defrost or heat in the refrigerator and expositing cabinet. both the ends of the heater adopt the imported resin glue and vulcanizate for seal ment and high ni - cr stainless steel as the case. it has good corrosive resisting performance and the insulation resistance is still more than 1000 after immersing in the water and being electrified for a long time

    本加熱器的特點為表面功率較小，在冰箱，展示櫃中起加熱化霜作用。電熱管兩端採用進口樹脂膠及硫化橡膠封口，外殼採用高鎳鉻不銹鋼，具有很好的耐腐蝕性能產品經長時間浸入水中通電試驗，其絕緣電阻仍1000m 。
  6. Acidoresistant : without corrorde in 2. 5 % hydrochoric acid solution at 24 hour

    耐酸性:在2 . 5 %鹽酸溶液中浸24小時無明顯腐蝕現象
  7. This paper introduces the hemp, the degumed hemp, ramie and flax treated with seawater, and compares the effects of decay resistance

    摘要採用海水對大麻原麻、脫膠大麻、苎麻和亞麻進行浸泡處理，比較麻纖維的耐海水腐蝕性能。
  8. A tio2 layer prepared by dipping in the stable tio2 sol was deposited on the surface of etched aluminum foils. after heat treatment, the composite oxide films were prepared by a normal formation

    將鋁腐蝕箔在此穩定的溶膠中浸漬處理，高溫熱處理后將其陽極氧化，得到復合氧化膜。
  9. Electrical insulating materials - method to evaluate the resistance to tracking and erosion - rotating wheel dip test

    電氣絕緣材料.耐牽引和腐蝕性的評估方法.回轉輪浸漬試驗
  10. As a long time protective coating for steel plate in severely corrosive environment, i. e. the submerged areas, e. g. ship - bottom, holds for crude of fuel oil, ballast tanks, etc

    作為長效保護塗料，用在嚴重腐蝕環境中的鋼板及浸在水中的部位，如船底、原油或燃油艙、壓載水艙等。
  11. Aerospace series. paints and varnishes. corrosion test by alternate immersion in a buffered sodium cloride solution

    航空航天系列.塗料和清漆.用交替浸漬在含有緩沖劑的氯化納溶劑中進行腐蝕試驗
  12. Corrosion - proof and oil - immersed type power transformer

    防腐蝕型油浸式電力變壓器
  13. Hr - p196 is general purpose resins suitable for all kinds of glass reinforced moldings, it can be easily processed by hand lay - up with excellent impregnation of glass fibres and good mechanical strength

    Hr - p196耐腐蝕擠拉用樹脂hr p196是拉擠成型用間苯型聚酯樹脂，與玻纖浸潤性好。
  14. This paper analysis the low using rate are armada ' s environment spectrum. for most warcraft calculate the placement spectrum is enough. the placement spectrum is composed of moist heat atmosphere, dry heat atmosphere and water solution corrode mediator soak environment

    本文對使用率較低機群的使用環境譜進行分析，總結出大多數軍用飛機使用環境譜僅需考慮停放環境譜，停放環境譜主要由大氣濕熱環境、乾熱環境和水溶液腐蝕介質浸泡環境（或鹽霧環境等）三種介質環境所組成。
  15. Standard test method for total immersion corrosion test for soak tank metal cleaners

    浸槽式金屬除垢劑的全浸腐蝕試驗的標準試驗方法
  16. Because of the place obstruction of corrosion products in the surface of the alloys, while corrosion time is at 120 minutes above, the corrosion rate descends to the stable value in 48 hours

    當腐蝕浸泡的時間大於120分鐘后，腐蝕產物在鋁合金表面產生了明顯的位阻作用，從而使腐蝕速率逐漸下降，直至48小時后，腐蝕速率趨於一相對穩定的數值。
  17. Oxidation erosion, liquid aluminum erosion and the erosion mechanism of grey cast iron crucible for aluminum melting were described in detail. the methods such as alloying of as - cast surface for improving oxidation resistance of the grey cast iron crucible and both composition adjustment and infiltration protection for improving liquid aluminum erosion resistance of the crucible were introduced. the corrosion resistance and service life of grey cast iron crucible were improved effectively with these methods through decreasing various channels of erosion developing from the surface to the inner of crucible

    詳細論述了熔鋁灰鐵坩堝的氧化腐蝕、鋁液腐蝕及其腐蝕機制，介紹了能夠提高灰鐵坩堝抗高溫氧化能力的鑄態表面合金化法和能夠提高灰鐵坩堝抗鋁液腐蝕能力的調整成分法與浸滲保護法，這些方法通過減少腐蝕由坩堝表面向基體內部發展的各種「通道」 ，有效地改善了灰鐵坩堝抗腐蝕性能，提高了坩堝使用壽命。
  18. Laboratory immersion corrosion testing of metals

    金屬的實驗室浸漬腐蝕試驗
  19. Practice evaluation of inhibitor for hydrochloric acid and immersion corrosion testing of method

    鹽酸酸洗緩蝕劑應用性能評價指標及浸泡腐蝕試驗方法
  20. Standard test method for total immersion corrosion test for aircraft maintenance chemicals

    飛行器保養用化學藥品的完全浸沒腐蝕試驗方法
分享友人
分享到 Line

分享到臉書