液壓管線 的英文怎麼說

中文拼音 [yèyāguǎnxiàn]
液壓管線 英文
hydraulic power line
  • 液 : 名詞（液體） liquid; fluid; juice
  • 壓 : 壓構詞成分。
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 液壓 : hydraulic pressure液壓泵 hydraulic pump; 液壓表 hydraulic pressure gauge; hydraulic pressure indi...
  • 管線 : line pipe; lead-out管線安裝 pipelining; 管線泵 in-line pump; 管線測量 pipeline survey; 管線敷設 pipelining
  1. The pressure at every point along the pipeline, the gas - liquid phase flow rate and the law of the liquid holdup in the pipeline chang ing with time in the process of gas storage and supply at the time of peak shaving are simulatively calculated, and based on this, the problem on peak shaving is thoroughly analyzed by combining with the existing pinghu - shanghai gas pipeline in china

    模擬計算了調峰過程中管道儲氣和供氣過程沿線各點的壓力、氣液相流速和管內持液率隨時間的變化規律，據此結合我國已建成現有的平湖一上海的天然氣管線，對調峰問題作了深入地分析。
  2. It is suitable to be used as the medium to filter the high purity and strong corrosive gas or liquid, the air plug of battery, gasket, seals for medium / low pressure, the waveguide tube pre - heater for boiler, the sealing wash, the cover of big - powered micro - wave antenna, and radar antenna of twt etc

    適用於過濾、高純度、強腐蝕性的氣體液體介質、蓄電池上作氣塞、襯墊、中低壓密封元件、鍋爐波管預熱器、密封圈和軍用微波大功率天線罩，以及行饋網路雷達天線等。
  3. Model and suffix codes e. g. hgssty - 1702m1b3d2e1g2f22 01mpa means : high intelligence mode digital sensor. whith linear indicator, pipe curving bracket, liquid discharge valve down. general cable connector, sensor connector uses the welded pipe connector, construction material all adopts 316 stainless steel, measuring range of 01mpa means the pressure of gauge

    型號選型舉例如下： hgssty - 1702m1b3d2e1g2f22 01mpa ，表示高級智能型全數字傳感器帶線性指示表頭管裝彎支架排液閥在下部，普通電纜接頭傳感器接頭採用焊管接頭結構材料採用316l不銹鋼量程為0 mpa表壓壓力。
  4. In this dissertation, the experimental study of rolling condition on two - phase flow instabilities of the forced - single - tube circulation system was carried out. furthermore, based on the d - partition method and the hypothesis of drift flow model, given some conservative equation, using the perturbation method the response of the pressure drop of the tube to the inlet flow rate perturbation was analyzed both in rolling condition and in normal upright position

    本文主要通過實驗對搖擺條件對單管強迫循環中汽液兩相流動不穩定性的影響，同時在d分區法的前提下，在兩相區基於漂移流模型，一定的守恆條件下，在搖擺和不搖擺工況中用線性小擾動法對實驗段的壓降對入口流速的擾動的響應進行了分析。
  5. High, medium, low - pressure hydraulic brake hoses are made of ternary ethylene propylene rubber and high - quality polyester thread, according to the gb16897 standard

    公司高中壓液壓制動軟管由三元乙丙橡膠和高級聚酯線製成，符合gb16897標準要求。
  6. Line consists of a feeding metal frame, leveler grooving roller, hydraulic notch and punch square machine, hydraulic shearer and folder

    風管生產線是由上料架調平壓筋機沖尖口和沖方口油壓機液壓剪板機液壓折邊機所組成。
  7. Such as operation manual for the machine tool, structure schematic diagram, maintenance manual and necessary drawings for vulnerable parts, electrical manual, programme manual, detailed documents and drawing for maintenance ( include circuit and pipeline schematic diagram of the main mechanical structure and control arrangements inside the product, arrangement plan of the control panel, connecting diagram, hydraulic pipeline connection diagram, assemblage diagrammatic sketch, drawing for vulnerable parts and foundation drawing ), production license, acceptance certificate and etc

    如機床操作使用說明書（操作手冊） 、結構原理手冊、維修保養說明書及必要的易損件圖紙、電氣說明書、編程手冊、詳細維修用的資料和圖紙（應包括產品內部主要機械結構與控制裝置電路、管路原理圖、控制面板布置圖、接線圖、液壓管路連接圖、裝配示意圖、易損件圖、基礎圖） 、生產許可證以及驗收證等。
  8. The assembly shall consist of two positive seating check valves located between two resilient seated shutoffs with a hydraulically balanced bypass line and four test cocks

    這種總成應該由兩個正向密封止回閥，兩邊夾著兩個彈性閥座關閉閥，並配置一個液壓平衡旁路管線和四個測試旋塞構成。
  9. Series 774xdcda contains two independently operating check valves located between two resilient seated shutoffs with four ball valve type test cocks and a hydraulically balanced metered bypass line to detect low flows

    系列774xdcda包含兩個獨立運行的止回閥，位於兩個彈性閥座關閉閥之間，並配置四個球閥型測試旋塞，以及一個液壓平衡儀表旁路管線用於檢測低流量。
  10. Hydraulic fluid power. identification of valve ports, subplates, control devices and solenoids

    液壓流體動力.閥門孔口，底板，控制裝置和螺線管的標識
  11. Busbar bushings up to 1 kv and from 1, 25 ka to 5 ka, for liquid filled transformers ; german version en 50387 : 2002

    液浸式變壓器用1kv及以下且1 . 25 ka至5 ka的母線套管
  12. Rubber hoses and hose assemblies. rubber - covered spiral wire reinforced hydraulic type. specification

    橡膠軟管和軟管組件.橡膠包皮螺旋金屬線增強式液壓型.規范
  13. Reduce hydraulic control manifold pressure to 5200 kpa

    將液壓控制管線壓力減少到5200千帕
  14. Specification for design and qualification testing of clamp blocks for fluid system tube lines having axial alignment - metric series

    軸線調準的液壓系統管道的夾緊裝置的設計和評定試驗規范
  15. Equip along with the weapon continuously creative, the sharp weapon also raises continuously in the quantity and the request on the quantities, processing to produce the mode and productions to process the production request that the equipments have already ca n ' t satisfy the long sail company originally possessed. through the common consultation of the company leadership and all employee, decide to throw in the capital, carry on to the company to reform completely, expand the scale, lead quantity and quantities that controls the production line to raise the production into the number, thus satisfy the competition ability that the productivity request combines to raise the business enterprise continuously. this thesis mainly what to study is the long spring aviation liquid to press to control the limited company number to control the degree of progress that the production line installs the item excellent turn, pass to use the item management of theories resolve the problem within actual application

    長春航空液壓控制有限公司前身是中國航空第二集團下屬第133廠，是一個為飛機配套機載設備的軍工企業，成立於1998年，隨著我軍裝備事業的不斷發展，對武器裝備的需要也越來越迫切，大批量的高精尖武器裝備已經成為打贏高科技精裝備條件下局部戰爭的法寶，因此長春航空液壓控制有限公司針對這一嚴峻形勢，果斷地提出利用項目管理的知識體系，引進數控生產線項目，在保證企業正常生產和安裝質量的前提下，縮短工期，節約成本並通過項目管理知識體系的運用，用系統的管理知識，提高管理效率、管理水平，並運用到其他的項目中，從而最終提高企業的生產力和競爭力。
  16. Rubber hoses and hose assemblies - wire braid reinforced compact type for hydraulic applications - specification

    軟管及軟管部件.液壓用的金屬線編帶增強的抗擠壓類型.規范
  17. Wire reinforced rubber hoses for hydraulic - part 1 : rubber hoses and hose assemblies - wire - reinforced hydraulic type - specification

    液壓用鋼絲增強橡膠軟管.第1部分:橡膠軟管和軟管組件.線增強液壓型.規范
  18. Fluid power ; hydraulic filter elements for inline filters ; envelope dimensions

    流體動力:管線內過濾器用液壓過濾器元件.包洛面尺寸
  19. That is, through analysis of the principle on flow control and " hydraulic transistor ", design and calculation of flow control characteristic as well as main parts in valve inner chamber, a piloted reducing valve will be installed between main valve and pilot valve. after a pressure - difference compensating reducing valve was added in the non - pressure compensating piloted reducing valve of the flow control valve in vlalvistor valve, the calculation on control characteristic emulation and load characteristic emulation has been carried out. the result of the calculation shows that after pressure compensating reducing valve was added, the linearity of the control characteristics has been greatly improved thus eliminating influence upon outlet flow by load pressure - change of the hydraulic system and improving performance characteristics of the hydraulic component

    文章還在對瑞典valvistor閥的插裝比例閥研究的基礎上，提出了一種新的流量控制原理，即：通過對流量控制和「液壓晶體管」原理的分析、流量控制特性及閥內腔主要結構件的設計計算，在主閥和導閥之間增設先導減壓閥，並進一步對valvistor閥的流量控制閥之無壓力補償先導減壓閥、加入壓差補償減壓閥后的控制特性進行了模擬計算和負載特性模擬計算，結果表明：增設壓力補償先導增壓閥后，其控制特性曲線變得非常線性，從而消除了液壓系統負載壓力變化對主閥輸出流量的影響。
  20. Wire reinforced rubber hoses for hydraulic - part 2 : rubber hoses and hose assemblies - rubber - covered, spiral wire reinforced, hydraulic type - specification

    液壓用鋼絲增強橡膠軟管.第2部分:橡膠軟管和軟管組件.橡膠包覆的螺旋線增強液壓型.規范
分享友人
分享到 Line

分享到臉書