液流壓頭 的英文怎麼說
中文拼音 [yèliúyātóu]
液流壓頭
英文
fluid head-
This ultrafilter adopts dissymmetrical semipermeable film which is made from macromolecule material with special process, the raw liquid flows under pressure, inside or out side the film, the macromolecule substance and colloid particles in the raw liquid are clogged at the film suface and are brought away by circulating raw liquid. then the raw liquid becomes inspissated, and further more, the substance in liquid is separated
本設備是以高分子材料採用特殊工藝製成的不對稱頭透膜，在壓力作用下，原液在膜內或膜外流動，其中的高分子物質，以及膠體粒子則被阻止在膜面，被循環流動的原料帶走而成為濃縮液，從而達到了物料的分離濃縮和提純的目的。This ultrafilter adopts dissymmetrieal semipermeable film which is made from macromolecule material with special process the raw liquid fiows under pressure ， inside or out side the film the mscromolecule substance and colloid particles in the raw liquid are clogged at the film suface and are brought away by circulating raw liquid then the raw liquid becomes inspissated ， and further more ， the subtance in liquid is seperated
本設備是以高分子材料採用特殊工藝製成的不對稱頭透膜，在壓力作用下，原液在膜內或膜外流動，其中的高分子物質，以及膠體粒子則被阻止在膜面，被縮和提純的目的。This ultrafilter adopts dissymmetrieal semipermeable film which is made from macromolecule material with special process. the raw liquid flows under pressure, inside out side the film suface and are brought away by circulating raw liquid. then the raw liquid becomes inspissated, and further more, the subtance in liquid is seperated
本設備是以高分子材料採用特殊工藝製成的不對稱頭透膜，在壓力作用下，原頁在膜內或膜外流動，其中的高分子物質，以及膠體粒子則被阻止在膜面，被循環流動的原料帶走而成為濃縮液，從而達到了物料的分離濃縮和提純的目的。Connections for fluid power and general use - hydraulic couplings for diagnostic purposes - coupling with m16 x 2 end for connection under pressure
流體動力和通用連接器.診斷用液壓聯軸器.加壓連接用m16 2端頭Promptly shift oil / nls in the overflowed tank to an available empty of slack tank to relieve pressure in the overflowed tank
將溢流艙內的油或有毒液體物質轉移到空艙，以降低溢流艙內的壓頭。Aimed at some problems such as short spraying distance, electricity - leaking and reverse ionization among electrostatic nozzles existing in the country, a induction charging and pneumatic energy electrostatic nozzle was designed. the basic designing theories, structure and working process of this nozzles were theoretically specified in the paper. and then the atomization quality and charge performances of this nozzle and its affecting factors were studied by carrying out performance experiment and statistic analysis. result of the studies indicate : ( 1 ) some progress were made in solving the problems list above ; ( 2 ) from this nozzle, droplet were minute and uniform, and higher charge - mass ratio can be obtained under lower electrostatic voltage, thus the atomization quality and charge performance of this nozzle were both better ; ( 3 ) within the experiment extend, air pressure at 0. 2mpa, electrostatic voltage at 2400v were the most suitable parameters for the nozzle ; ( 4 ) the regression equations for describing droplet size, intensity of spray current and charge - mass ratio of this nozzle obtained from the experiment data had higher forecast precision ; ( 5 ) cross - effect of all factors were not significant, the atomization quality and charge performance were relative dependency affected by the factors
諸試驗因素中，充電電壓和噴孔直徑對霧滴荷質比均有極顯著的影響；氣體壓力和液體流量對霧滴荷質比的影響均不顯著；影響霧滴荷質比的主要因素依次為充電電壓和噴孔直徑; （ 8 ）在300v 、 600v 、 1200y 、 1800y 、 2400v 、 3000v六種充電電壓t ，霧滴荷質比先隨充電電壓的增加而增大， 2400v后荷質比減小，推測:對于所研製的噴頭可能存在一個最佳充電電壓; （ 9 ）由充電電壓和噴孔直徑的不同搭配所得霧滴荷質比不同這一結果，可看出，較大充電電壓需配備較大噴孔直徑以增強霧滴荷電效果; （ 10 ） td3 . 6和td3 . 4兩噴頭的霧滴荷質比曲線趨于重合，說明噴孔直徑大於滬3Among them the flow pulse is more standing - out, which is the main reason of its not more widely used. because high flow pulse will lead to the worse of the smooth movement of hydraulic motor and pipe, also cause pressure pulse which lead to a high noise, and give the destructive damage to the axial, bearing, valve, the connect of pipe etc. how to make the flow pulse low has become the research of scholars of many country
其中流量脈動問題顯得尤其突出，它嚴重製約著齒輪泵的應用，因為泵的流量脈動大，不僅會使液壓缸運動的平穩性、液壓馬達回轉的均勻性性變差，而且會引起壓力脈動，進而使管道、閥門乃至整個系統振動（特別是在共振時） ，並發出很強的噪聲，這對軸、軸承、管接頭及密封都有破壞性影響。Connections for fluid power and general use - hydraulic couplings for diagnostic purposes - part 1 : coupling not for connection under pressure iso 15171 - 1 : 1999
流體傳動和一般用途管接頭.診斷用液壓管接頭.第1部分Connections for fluid power and general use - hydraulic couplings for diagnostic purposes - part 2 : couplings with m 16 2 end for connection under pressure iso 15171 - 2 : 2000
流體傳動和一般用途管接頭.診斷用液壓管接頭.第2部分分享友人