深潛試驗 的英文怎麼說

中文拼音 [shēnqiánshìyàn]
深潛試驗 英文
deep-diving test
  • 深 : Ⅰ形容詞1 （從上到下或從外到里的距離大） deep 2 （深奧） difficult; profound 3 （深刻; 深入） thor...
  • 潛 : Ⅰ動詞1 （隱在水下） go underwater; hide under water; dive 2 （隱藏） hide3 [書面語]（涉水） wade ...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 深潛 : deep diving深潛船 bathyvessel; deep diving vessel; 深潛救生艇 deep submergence rescue vehicle; 深...
  • 試驗 : trial; experiment; test
  1. On the basis of many related data from abroad, this thesis is an attempt to simulate the hydrodynamic characters of abyssal gravity cages under the action of currents and waves

    本論文正是從這一點出發，根據國外有關抗風浪網箱資料，在試驗室中模擬深水重力式潛網在水流、波浪作用下的受力特性。
  2. Submerged dyke is a common offshore structure, which is widely used for band protecting and silt promoting engineer and etc. however, few research studies are done upon such a problem home and abroad and even the accomplished results are not satisfying, which cannot be used for real projects, and in most cases, they will have to depend on the results of experiment

    然而，目前國內外對潛堤的研究很少，研究的成果也很不成熟，難以應用到實際工程設計中，在很多時候，還需要藉助於物理模型試驗，因此，本文結合勝利油田保灘促淤新技術研究項目，對潛堤波浪力以及透射特性進行了深入系統的研究，力求揭示其內在規律，期望能獲得有實際應用意義的研究成果。
  3. Through the physical model experiment, the wave forces over submerged dyke and transmission coefficient are analyzed under the action of regular wave. in the test of wave forces, the rectangle - type submerged dyke is used as research object, and when analyzing the total wave forces, the effect of water depth before the dyke and that of the wave parameters is considered. based on the test, through the methods of multi - element linear regression, experimental formulae are given to calculate maximum total wave forces in horizontal direction, its relative vertical wave forces and maximum wave forces before and after the dyke, which are compared with the present formulae

    在潛堤波力的研究中，選取矩型潛堤作為研究對象，在分析各個影響因素對潛堤波力影響的基礎上，選取兩個最主要的影響因素，即相對波高和相對水深作為研究重點，在物理模型試驗結果的基礎上，定性地研究分析了潛堤所受的總波力隨相對波高和相對水深的變化規律，並在此基礎上，利用多元線性回歸的方法，分別給出了在本文試驗條件下計算潛堤最大水平總波力及其相對應的垂向總波力的經驗公式以及計算堤前堤后最大總波力的經驗公式，並與已存在的計算公式進行了對比。
  4. The opening stress and the life of crack growth is calculated and compared with the test results and the experience formula. the feasibility of the newman theory of opening stress used in the high strength steel is validated. then through the slice synthesis method, the three dimension surface crack of the weld joint of cone - cylinder is decomposed into many plane through cracks

    本文將基於裂紋閉合現象建立的帶狀屈服模型，用在平面貫穿裂紋中，計算此時的裂紋張開應力和疲勞裂紋擴展壽命，與試驗結果和經驗公式比較，驗證newman裂紋張開應力理論在高強鋼中的可行性；然後，用切片合成法，把潛艇結構凸錐柱結合殼焊縫處的三維表面裂紋分解成平面貫穿裂紋，用帶狀屈服模型的理論來分析平面貫穿裂紋，得到裂紋沿深度方向的擴展速率，進而得到潛艇結構的疲勞壽命。
  5. Diving accessories - depth gauges and combined depth and time measuring devices - functional and safety requirements, test methods

    潛水設備附件.深度儀和深度及時間組合測量設備.功能和安全性要求試驗方法
  6. Combining with taaf test, reliability growth is carried out to expose and fix potential fault modes and mechanisms, normal reliability growth is adopted combining with fault diagnosis, fault diagnosis method based on eta is proposed, optimization search strategy and generalized deep priority search method are studied based on multiple objective optimization decision theory and sequential decision theory, which has great significance to find faults quickly

    結合taaf試驗，對壓塊機進行可靠性增長來暴露和確定潛在的故障模式和機理，採用一般性可靠性增長方法並結合對故障診斷技術進行研究，提出了基於fta的故障診斷方法，以多目標優化決策論、序貫決策論為理論基礎，對系統故障的優化搜索策略、廣義深度優先搜索方法進行了研究，對壓塊機可靠性增長過程中快速排除故障進行了探索。
  7. Then in this paper the author establishes the simulation model of the probability of smashing the submarine when the segregator of the submarine launched missile carrier sinking in the water and uses the monte carlo ( of or relating to a problem - solving technique that uses random samples and other statistical methods for finding solutions to mathematical or physical problems. ) to simulate the whole process. then the author carrier through much simulating computations and gives the smashing probability at different conditions

    在對分離體下沉的各種干擾因素進行了深入的分析后，建立了基於蒙特卡羅方法的潛射導彈運載器分離體砸艇概率的計算模型，並且進行了大量的計算機模擬試驗，分別對運載器採用平面彈道，偏航彈道在不同發射深度，不同發射艇速的情況下的分離體砸艇概率進行了模擬計算，給出了不同情況的砸艇概率。
  8. Model tc308 high pressure crawler type down hole drill rig for open use

    中高風壓潛孔鉆機在中深孔鑿巖中的試驗應用
分享友人
分享到 Line

分享到臉書