深蝕試驗 的英文怎麼說

中文拼音 [shēnshíshìyàn]
深蝕試驗 英文
deep etch test
  • 深 : Ⅰ形容詞1 （從上到下或從外到里的距離大） deep 2 （深奧） difficult; profound 3 （深刻; 深入） thor...
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. In this thesis hydraulic experimental studies and theoretical analyses on the vortex - flow drop shaft were conduced and the following results were accomplished : ( 1 ) in the model test some hydraulic characteristics including the shape of air core in the center of the drop shaft, the radial distribution of water flow velocity and the distribution of pressure on the wall of the drop shaft were measured under the condition of high water head above 250m and large discharge above 1400m3 / s. ( 2 ) a kind of computational method for the spiral water flow in the air core region of drop shaft was discussed and applied and the results agree the experimental data well. ( 3 ) the total ratio of energy dissipation in the drop shaft can reach 90 % and the energy dissipation in every region was discussed quantitatively

    本文通過試驗研究與理論分析對旋流式豎井泄洪洞應用於高水頭、大泄流量情況時存在的一些水力學問題進行了研究和探討，取得以下主要成果：一、結合小灣工程導流洞改建，對高水頭（ 252m ） 、大泄流量（ 1400m ~ 3 s ）條件下旋流式豎井中的水流運動特徵進行了比較全面的測量，包括空腔形態、徑向流速分佈及井壁壓強等；二、提出了豎井空腔段螺旋水流水力計算方法，其計算結果與實測值吻合良好；三、利用試驗與計算結果，對旋流式豎井的消能機理進行了探討，對豎井各部分的消能能力有了總體認識；四、對豎井下部消力井的合理井深進行了優化試驗研究，發現消力井合理深度為0 . 9d左右；五、通過試驗研究，歸納出豎井水流總摻氣量估算方法，為導流洞排氣方案的設計提供了參考依據；六、在高水頭、大流量條件下，豎井空腔段下部流速很高，盡管水流螺旋運動引起的離心力可以確保井壁壓強保持正壓，但空化數依然較低，因此豎井的空化空蝕始終是工程界關注的重大問題。
  2. Deep etch test

    深腐蝕試驗
  3. The processes include the deposition of the waveguide film, the design and fabrication of the mask pattern, the lithography, the metal coating with a magnetic sputtering, the lift - off process for the metal mask, the dry deep etching by icp, the slicing of the wafer, the polishing of the cutting edge, the fiber - to - waveguide alignment and at last, the performance testing. some edg chip samples are fabricated

    對設計好的集成波導器件，本論文設計並試驗了器件的製作的全部工藝，包括波導薄膜的沉積，掩模的設計製作，光刻，濺射金屬薄膜，剝離法製作金屬掩模，干法深刻蝕，矽片切割，端面磨拋，波導對準和性能測試。
  4. In order to make integration of theory with practice, a lot of experiments have been done. mask - making technology, photoetching and wet - etching processes have been optimized. the author also presents the application and commercial value of silicon v - groove arrays

    在實踐上，對製作工藝積極探索，提出新的制備硅掩蔽膜的工藝方案，對影響光刻質量的因素深入分析，試驗摸索出適用於v型槽的各向異性濕法腐蝕的腐蝕液配方，獨立優化設計了製作硅v型槽的相關工藝，製作出高質量的硅v型槽。
  5. Through many comparative experiments, the chemical polishing corrosion method was explored in order to showing nitriding depth, by which can increase the measuring accuracy and be cost - effective

    筆者進行了大量的對比試驗，採用化學拋光腐蝕的方法，改善了氮化層深度的顯示效果，提高了檢測精度，節約了資金。
  6. For example, frp reinforced concrete is used to support or surround magnetic resonance imaging ( mri ) medical equipment, and frp is also used for the constructions of some seawalls, industrial roof decks, base pads for electrical and reactor equipment, anchor in rock and ground engineering and concrete floor slabs in aggressive chemical environments in order to promote the wide usage of frp and frp reinforced concrete structures, financed cooperatively by nationa l natural science foundation ( item : the research on mechanical performance of frp reinforced concrete beam reinforced ; number : 59978046 ) and henan illustrious youth science foundation, connected with the analysis methods of modern steel reinforced concrete structure, the thesis further studies the flexural performance of frp reinforced concrete beam through the systematic study on experimental data got from this kind of beams, systematically establishes the theoretical calculating system of the flexural performance of frp reinforced concrete beam in cooperation with the up - to - date analytical methods for reinforced concrete, which suits the properties of frp

    例如，纖維增強塑料筋應用於支撐和圍繞磁共振成像醫療設備的混凝土中及海堤、工業頂棚、電設備、反應設備的基座、巖土工程中的錨桿、侵蝕性環境的混凝土結構等海洋工程、橋梁工程、路面工程、巖土工程、醫療及化工工程的建設。為了推動纖維增強塑料筋及其混凝土結構在工程中的廣泛應用，本文在國家自然科學基金（項目名稱：纖維增強塑料筋混凝土梁力學性能的研究；編號： 59978046 ）和河南省傑出青年基金的資助下，通過對纖維增強塑料筋混凝土梁正截面受彎性能試驗數據的系統分析，結合現代鋼筋混凝土結構學的分析方法，對纖維增強塑料筋混凝土梁正截面受彎性能進行了深入的研究，較系統的建立了適合於纖維增強塑料筋特點的纖維增強塑料筋混凝土梁正截面受彎性能的理論計算體系。
  7. By placing different rare earth elements ( ree ) in different soil depth and different section across one slope in an indoor plot, one simulated rainfall was applied to study the spatial - temporal process both of depth and section erosion across one slope plot simultaneously

    摘要室內交叉布設不同的稀土氧化物，通過人工模擬次降雨，在同一試驗條件下，對坡面侵蝕沿順坡方向和深度方向的演變過程同時展開研究。
  8. In this dissertation, rainfall infiltration, runoff, and soil water redistribution on a hillslope were studied by simulated rainfall experiments, and soil water cycling was investigated by site observation and soil sampling methods. moreover, the reasons for the desiccation of deep soil layer were analyzed, and its assessment indexes and standards were presented. the main results are as follows : ( 1 ) rainfall infiltration into a planar hillslope with a homogeneous isotropic soil could be simply regarded as one - dimensional infiltration process, if soil erosion was prevented

    針對當前該區植被恢復重建中存在的科學問題，以植被建設的關鍵性限制因素?土壤水分為出發點，通過室內外模擬降雨試驗，研究了坡地降雨入滲、產流及土壤水分再分佈規律，同時採用定位觀測和采樣分析相結合的方法，分析了坡地土壤水分的循環與轉化特徵，並初步建立了深層土壤乾燥化程度的評價標準，取得的主要結論如下： （ 1 ）在防止土壤侵蝕的條件下，均質坡地的降雨入滲過程可以簡化為一維。
  9. The theory analysis and experimental result of oil barrel rust cleaned by high pressure water jet show that after the steel container is cleaned by water jet, its deep level structure rust does not affect the oil quality really, and does not product new mechanical impurities, and this clean way can clean various oil container in high quality

    摘要對經過高壓水射流清洗后的鋼油桶銹蝕進行了理論分析和試驗檢測，結果表明，鋼容器經過高壓水射流清洗后，深層次銹蝕對油品質量沒有實質影響，也不會產生新的機械雜質，該清洗方法能保證可靠的清洗質量。
  10. By means of prototype observation, analysis with materials and theories, and laboratory test, the author deeply analyzed the causes and procedure of canal cross section erosion, and obtained eight causes which resulted the canal deform including flow, seepage, runoff, collapse of bank, dry effect, human activity, wave flush, frozen, and then stressed to discuss the frozen process

    本文通過原型觀測、資料分析、理論分析、室內試驗對北引渠道變形的成因和發生機理進行了較為深入的分析研究，給出了造成北引渠道變形的八大原因：流水引起的變形、滲透引起的沖刷、地表徑流引起的沖刷、滑坡變形、乾燥作用、人類和動物活動的影響、風浪引起的沖刷、凍融侵蝕，並著重闡述了凍融侵蝕的機理。
  11. On the basis of consulting a large number of literatures domestic and aboard, the present situation and latest development of hydrodynamic characteristics of overland flow and slope erosion dynamic process were reviewed. aiming at revealing the effect of rainfall splash intensity on hydrodynamic features of sheet flow and slope erosion, with a combination of runoff experiment and simulated rainfall experiment with a fixed intensity, applying hydrodynamic and erosive theory, the effect of rainfall on overland flow velocity and the influence of rainfall splash intensity on hydrodynamic features ( such as velocity, flow depth, flow patterns, resistance ) of sheet flow on slope and the influence of rainfall splash intensity on the overland flow sediment contain was researched

    本文在查閱了大量國內外文獻資料，全面了解了坡面流水動力學特性及坡面侵蝕動力過程等方面的研究現狀及最新進展的基礎上，以揭示雨滴打擊動能對坡面薄層水流水動力學特性及坡面侵蝕的影響為目標，採用水槽放水試驗和定雨強模擬試驗相結合的方法，運用水動力學與侵蝕理論，研究了降雨對坡面薄層水流流速的影響，雨滴打擊強度對坡面薄層水流流速、水深、流態、阻力等水動力學參數的影響，雨滴擊濺作用對坡面流泥沙含量的影響。
分享友人
分享到 Line

分享到臉書