混合流 的英文怎麼說

中文拼音 [húnliú]
混合流 英文
combined flow
  • : 混形容詞1. (渾濁) muddy; turbid2. (糊塗; 不明事理) foolish; stupid
  • : 合量詞(容量單位) ge, a unit of dry measure for grain (=1 decilitre)
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • 混合 : (攙雜在一起) mix; blend; mingle; admix; mixture; mix up; interfusion; commixture; blending; cre...
  1. According to different flow patterns, a new transferring rule for oil - water two phases system flowing model in pipes is built in including the stability rule for stratified flow patterns and transferring border and anti - phase border for deconcentrating patterns and mixture patterns

    根據管內油、水兩相型特徵,建立了新的油、水兩相管型的轉換準則。它包括:分層型的穩定性準則、分散型和混合流型的轉換邊界及反相界線。
  2. Theory calculation and derivation demonstrate that the heat conduction of membrane exerts little influence on performance. the characteristics of mass transfer through membrane are mixed flow including knudsen flow and poiseuille flow, which moreover, vary with operational variables

    理論推導與計算表明:膜的導熱性對真空膜蒸餾過程的影響可以忽略,膜蒸餾過程膜內質量傳輸機制是努森與粘性共同作用的混合流機制。
  3. The following new knowledge are acquired : a ) the cu background of stratum and jinningian alkali basite is abnormal high, which could be liberated from those rocks during alteration. cu et al. minerogenetic elements, which main came from magmatic rock, some from stratum ( yinmin formation and luoxue formation ) and its basement rocks

    礦床中cu等成礦物質來源復雜,以深源為主,部分來源於地層(因民組紫色層和落雪組白雲巖)及基底地層;礦區內的退色蝕變作用可能是混合流體堿質交代改造作用的結果,對銅礦形成影響明顯,是銅礦化的標志; 2
  4. Except for types of stationary phase, components of mobile phase and types of detectors, other prescribed conditions under each type, such as internal radius and length of chromatographic column, brand of stationary phase, carrier granularity, flow speed of mobile phase, as well as proportion, column temperature, volume of incoming samples of different components of mixed mobile phase and sensitivity of detector can be appropriately changed to accommodate different chromatographic system and reach requirements for applicable test of the system

    各品種項下規定的條件除固定相種類、動相組成、檢測器類型不得任意改變外,其餘如色譜柱內徑、長度、固定相牌號、載體粒度、動相速、混合流動相各組成的比例、柱溫、迸樣量、檢測器的靈敏度等,均可適當改變,以適應具體的色譜系統並達到系統適用性試驗的要求。
  5. At the mean time, the state council also promulgated the order of coin issuance for the convenience of circulation. the new coins 1 fen, 2 fen, and 5 fen aka fen coins were issued on 12 1 1957, and would be circulated concurrently with the fen banknotes

    同時,為便於通,國務院發布發行金屬分幣的命令,自1957年12月1日起發行1分2分5分三種金屬分幣簡稱硬分幣,與紙分幣等值,混合流通。
  6. At the mean time, the state council also promulgated the order of coin issuance for the convenience of circulation. the new coins 1 fen, 2 fen, and 5 fen ( aka fen coins ) were issued on 121 1957, and would be circulated concurrently with the fen banknotes

    同時,為便於通,國務院發布發行金屬分幣的命令,自1957年12月1日起發行1分、 2分、 5分三種金屬分幣(簡稱硬分幣) ,與紙分幣等值,混合流通。
  7. The co - evolution algorithm is applied to the optimization problem, and a new optimization system and algorithm frame of designing of mixed model flow manufacturing is established

    混合流水生產系統優化設計中引入協同進化演算法,建立了一種新的混合流水生產系統的優化體系與演算法框架。
  8. Based on the optimization system and algorithm frame, the co - evolution optimization model of minimization of makespan, minimization of workload variation, leveling of the material flow and u - line is established, and some instances is given also

    在多目標協同優化體系和演算法框架的基礎上,本文分別建立了混合流水生產系統的基於製造周期、負荷、物和u型布局等多目標協同優化模型,並給出了優化實例。
  9. Four models under the combination two type of work station with two type of hypotheses, and an instance is given. in model of the optimization of u - line, according to the characteristic of u - line, a model of optimization on the workload is set up, the optimization methods is given. moreover, a method of workstation breaking is put forward, thus, the problem of optimization of u - line can be transferred into straight - line problem and the two problems are unified through the method

    在基於u型布局的混合流水生產系統的多目標協同優化模型中,針對u型水線的特點,建立了針對負荷均衡的u型水線的協同優化模型,給出了具體的演算法,並且提出工作站分解的方法,將u型水系統的優化轉化為直線型水系統的優化,把u型水生產線的優化與直線型水生產線的優化統一起來。
  10. In addition, according to difference between the top - level materials and the low - level materials, the model of leveling the mat erial flow is set up separately. furthermore, the model of leveling the material flow with constrain of resource supplying limit. in the model of optimization on the workload, the mutual effect of line balancing and scheduling is analyzed by an instance ; the factors of line balancing, scheduling, and system parameters, such as workstation length, the launch rate are taken into considered

    在基於負荷的多目標協同優化模型中,通過實例分析了平衡設計與排產設計對系統目標的交互影響,綜水線的平衡設計和排產設計與工作站長度、產品投放速率等系統參數對系統的影響來優化混合流水生產系統設計,建立了在2種工作站類型與2種假設情形構成的4種組下的優化模型,給出了一個優化實例。
  11. In the algorithm frame, the co - evolution algorithm combing with the niche technique, the selection mode of face - to - rank and pareto classifier, makes the solution of system be global optimal, not local optimal ; and the single objective optimal solution is extended to multiple objective pareto optimal solution

    在演算法框架中,協同優化演算法結了小生境技術、面向排序的選擇模型以及pareto過濾器,使系統設計目標從局部最優進化到全局最優,同時把混合流水生產系統的優化從單一目標最優解擴展到多目標的pareto最優解。
  12. Based on result of the multiple objective optimization, this dissertation investigates the multiple objective decision of mixed - model flow m anufacturing system. in allusion to the pareto frontier, in terms to the assistant information of decision schemes, the preference of objectives, the preference of decision schemes, individual decision - making and group decision - making are gained through the measure function, 0 - 1 programming and relative entropy combining with subjective and objective factors

    在多目標優化的基礎上,研究了混合流水生產系統的多目標決策問題,針對多目標協同優化得到的pareto前端,依據決策方案的輔助信息、對指標有偏好的信息以及對決策方案有偏好的信息等,採用測度函數、 0 - 1規劃方法以及相對熵的方法,結主客觀因素進行多目標個體決策和群體決策,把多目標優化與多目標決策聯系起來。
  13. This dissertation mainly investigates the problem of multi - objective cooperative optimization on the design of the mixed - model flow manufacturing. based on the cooperation design ideology, the cooperative and mutual effect of balancing and scheduling of mixed - model flow line is taken into consideration in the design, thus, the design is balancing - to - scheduling and scheduling - to - balancing

    本文主要研究混合流水生產系統設計中的多目標協同優化問題,基於協同設計的思想,綜混合流水生產系統中平衡設計與排產設計兩個方面的協同和交互效應,進行面向排產的平衡設計和面向平衡的排產設計。
  14. When makespan1 is greater than makespan2, we can decrease the makespan just by improving the algorithms for no - wait hybrid flowshop problems

    當makespan1大於makespan2時,除了去改進不允許等待的混合流水車間問題的演算法外,我們無能為力去減小makespan 。
  15. Reduction in a mixed fluidized bed with iron ore and coal

    礦煤混合流化床還原反應
  16. Formation and recommendations of control method in urban traffic mixed flow

    城市交通混合流的成因及其管制策略建議
  17. This thesis studys several distribution network reconfiguration algorithms detailedly, mostly concluding branch - exchange method, optimal flow pattern method, recursive fictitious flow method and hybrid flow pattern method. it analyzes theoretical basis of all algorithms, modified process and basic steps at length. besides it simptylniroduce other distribution reconfiguration algorithms and its development, compares the characters of all algorithms and puts forward a simplied recursive fictitious flow method, then according to a example proves the effect of some algorithms

    本論文詳細研究了多種配電網路重構演算法,主要包括支路交換法、最優模式法、遞歸虛擬法和混合流模式法,詳細分析了各種演算法的理論依據、改進過程和基本步驟,簡述了其它相關重構演算法的思路及其發展,比較了各種演算法的各類特性,提出了一種簡化遞歸虛擬演算法,並通過實例證明了幾種重構演算法的有效性。
  18. Abstract : a tube reactor mixed by an axial continuous flow and four side jets as the dispersed flow is studied. the concentration distribution of the dispers ed flow was measured by means of the laser light scattering. the different flow patterns revealed the special construction of concentration distributions in relation with the velocity ratio of side flow and axial flow

    文摘:研究了圓管反應器中四束側向對撞射與軸向形成的混合流動.應用激光粒子散射成像測量了側向分散相在混合流中的濃度場分佈,得到了不同的濃度分布圖形隨側向與軸向速比關系,揭示了內在有規律的獨特的濃度分佈結構
  19. On the basis of above theoretical derivation and analysis on experimental results, by correlating solvent ( water ) transfer with solute ( salt ) transfer on hot side and correlating mass transfer with heat transfer during vmd and introducing a contribution coefficient which can reflect the characteristics of mass transfer through membrane, a new model of mixed flow is presented

    在上述理論推導及實驗分析的基礎上,本文將熱側溶劑傳輸與溶質傳輸、膜蒸餾過程熱量傳輸與質量傳輸相關聯,並引入一個能夠反映膜內質量傳輸特徵的「貢獻系數」 ,將努森模型與粘性模型結起來,從而提出了新的混合流模型。
  20. For dual - phase flow such as steam - water mixtures

    對于雙相體,如蒸汽-水混合流體。
分享友人