混合物的熱值 的英文怎麼說

中文拼音 [húngěwùderèzhí]
混合物的熱值 英文
heat value of mixture
  • 混 : 混形容詞1. （渾濁） muddy; turbid2. （糊塗; 不明事理） foolish; stupid
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 物 : 名詞1 （東西） thing; matter; object 2 （指自己以外的人或與己相對的環境） other people; the outsi...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 混合物 : mixture; compound; mix; varia; intermixture; hodge poadge; miscellany; impurity; mix up admixture...
  • 混合 : （攙雜在一起） mix; blend; mingle; admix; mixture; mix up; interfusion; commixture; blending; cre...
  1. Besides, scan rate and cycle period also affect the result ; co - deposition of dualistic oxide is a focus of research, as an element in the same group, ir is selected. deposition rate of composition is decreased by the adding of ir composition, and when the proportion of ir exceeded 50 %, composition procession can be ceased. but cooperation of ir and ru oxide can highly increase the specific capacitance of active material ; annealing treatment under a certain temperature can help to change the hydrate ru composition into mixture state ru oxide, accordingly increase the stabilization of active material

    研究表明:電解液的配製過程中，氯化釕濃度、溶液ph值、陳化時間、溶液溫度對電鍍效果均有影響，其中溶液ph值是最主要的影響因素;在儀器的使用條件探索中，理論結合實驗確定了本電鍍液體系循環伏安電勢窗的理想范圍，並發現循環伏安掃描速度和掃描周期對電鍍結果也有較大影響;混合氧化物的共沉澱是目前研究熱點，在此選用與釕同一族的銥作為共沉澱元素，銥的加入會阻礙氧化物的沉積速度，銥的比例超過50 %會使沉積作用停止，但是二元氧化物的協同作用使沉積的活性物質比容量大大提高;一定溫度下退火后處理作用會使水合釕化物轉變成混合價態的氧化釕，從而提高活性物質的穩定性。
  2. Through the research of crosslinking of matrix resin, heating treatment of composite and mixing of different polymer, we draw some conclusions : 1 、 percolation theory can explain the phenomenon of the jump of resistance when the content of cb reach a critical volume ; 2 、 based on ohm conduct theory, abounded to the percolation the wbibull statistical theory and other theory, an adapted theory was obtained to explain the jump of resistance and the other phenomenon ; 3 、 the ntc phenomenon was eliminated by crosslinking the matrix of conductive composite, at the same time the stability of composite was improved

    通過對基體樹脂的交聯、復合材料的熱處理、聚合物共混物的研究得出了如下的結論： 1 、滲濾理論能夠很好的解釋導電粒子含量達到某一值時電導率劇增的問題； 2 、在歐姆導電模型的基礎上，綜合應用了weibull統計理論模型，結合原來的體積膨脹等理論，成功的解釋了ptc復合材料在基體材料熔點附近的跳變問題、 ntc現象以及熱循環穩定性等問題； 3 、有機ptc導電復合材料經硅烷交聯以後能夠消除ntc現象，改善了導電復合材料的穩定性能。
  3. In this article, constituting some the equations which reflect the flow law and building and applying many mathematical models of physical and chemical reactions in the the plasma ignition : applying k - two equations turbulence model to calculate the turbulence parameter supplying simplied reaction systerm model and applying eddy break - up model and p - i thermal radiation model. with these reasonable simplied modles, numerically simulating the flow field in the plasma ignition. during the numerical simulation, applying the body - fitted coordinates for the complex geometry of the computional field ; using the mixing format to disperse the equations ; applying simplec algorithm method to solve the equations ; using above models and methods, it can get flow field distribution ; including temperature, pressure, turbulent kinetic energy and its dissipation rate, turbulent viscosity, velocity, density. these results are significant to design and improve the plasma ignition

    本文旨在通過構造反映等離子點火器內部流動規律的基本方程組，建立描述等離子點火器內部的復雜物理化學過程機制數學模型：模擬等離子發生器內部燃燒的-雙方程湍流流動模型；模擬氣體燃料在燃燒時中化學反應的簡單化學反應系統模型；模擬等離子點火器內部湍流預混燃燒的漩渦破碎模型；模擬等離子點火器高溫燃氣及其壁面的p - i輻射換熱的模型等等，對模型進行一定的合理的簡化，然後數值模擬等離子點火器內部流場的流動。
分享友人
分享到 Line

分享到臉書