混頻電位器 的英文怎麼說

中文拼音 [húnbīndiànwèi]
混頻電位器 英文
fader
  • : 混形容詞1. (渾濁) muddy; turbid2. (糊塗; 不明事理) foolish; stupid
  • : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ名詞1 (所在或所佔的地方) place; location 2 (職位; 地位) position; post; status 3 (特指皇帝...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  1. The field of video signal processing is now undergoing a digital reform. the digital processing technique is clearly expatiated in this paper, such as a / d convert, anti - alias filter, clamp control, gain control, pll, synchronization circuit, color decoder, comb filters

    本文詳細敘述了視圖像的數字處理方法,重點介紹了視信號數字化技術、抗疊濾波、箝、增益控制、鎖相技術、同步時鐘產生、視信號亮色分離、彩色解碼等技術,這些關鍵技術為視信號的數字化處理提供了重要的基礎。
  2. Supported by heilongjiang province natural science foundation projects " research on the errors mechanism of time division a. c. power measurement " ( no. e9719 ), " research on theory of analog digital mixed sampling power energy measurement " ( no. e01 - 15 ) and foundation for university key teacher by the ministry of education " the research on the low audio frequency a. c. power measurement smart instrument " ( no. 1087 ), in this dissertation it is made that a systematic and deep study on power measurement model errors and instrument errors about analog sampling, digital sampling and mixed sampling measurement, and fully experiments about mixed sampling measurement

    本學論文在黑龍江省自然科學基金資助項目「時分割交流功率測量原理誤差產生機理的理論研究」 (編號: e9719 ) , 「模擬數字合採樣功率與能測量的理論研究」 (編號: e01 - 15 )和教育部高等學校骨幹教師資助計劃項目「中功率測量智能儀的研製」 (編號: 1087 )的資助下,以功率模擬采樣測量、數字采樣測量和合採樣測量方法為對象,對功率測量的原理誤差和儀誤差進行了系統和深入的理論研究和有關的實驗研究。
  3. In former, image - reject mixer uses phasing to differentiate between two single - balance mixers. it ' s four diode is type of dmk - 2606 by made alphar corporation, module of mixer ' s integrated circuit is simulate by senerade 8. 0 and ads software

    然後介紹了的基本原理,設計了鏡像抑制和上變放大路,鏡像抑制是利用兩個單平衡的相差對鏡進行抑制,其中四個二極體採用alphar公司dmk - 2606型。
  4. In practical studies, finally, a hybrid active power filter based on the digital signal processor ( dsp ) and intelligent power module ( ipm ) was set up, including a cycloconverter acem. based on the experimental set - up, plenty of experimental studies were conducted. the experimental results demonstrate that the self - adaptive technique, the topology of series connected hybrid power filter and the corresponding significant technologies described above are feasible and practical

    最後,實際研製了一套以dsp (高速數字信號處理)和ipm (智能功率模塊)為核心的小功率合型有源濾波裝置,在交交變acem實驗平臺上進行了全面的實驗研究,充分驗證了本文所提出的自適應同步相關濾波技術、優化合型濾波拓撲結構和有關的關鍵性技術的正確性和實用性,從而從理論到實踐全方、成功地實現了對交流勵磁發機輸出力諧波抑制的研究。
  5. The system is based on chopper constant current drive technique, according to the top level design idea, adopting advanced specical subdivision control integrate circuit and powerful function 80c196kc to organize the system frame, desiging the minimum system of single - chip microcomputer, multifunction i / o interface circuit, relay switch circuit, keyboard and display circuit, multifunction digital setting interface circuit and so on, utilizing the hso and hsi interface circuit which are owned by this single - chip microcomputer exclusively and its powerful command system to realize dual - degree switch control, automation orientation, automatically searching zero position, locking machine when stopping, frequency to set digitally, automatically adjusting speed through changing frequency, swithing subdivision or squarewave control, on the basis of above, the system also have the function of running according to the setting steps and the frequency, voltage and current to display through the led, etc

    系統基於斬波恆流驅動技術,按照頂層設計思想,採用先進的專用細分控制路和功能強大的80c196kc單片機來組建系統構架,設計了單片機最小系統、多功能i o介面路、繼切換路、鍵盤顯示路和多功能數字設定介面路等,利用該單片機獨有的hso和hsi介面及其強大的指令系統,實現了雙余度合式步進動機的余度切換控制、自動定、零自動搜索、停機鎖定、數字化率設定、自動調變速控制、細分方波切換控制,在此基礎上,該系統還設有按預置步運行、 led壓相流顯示等功能。
  6. At the same time, the method of disposal phase shift of ct by compensation is introduced. then the analysis and statistic of electrical power quality, the control scheme and compensating amount of capacitor for reactive power compensation are analyzed respectively. and in the paper, the control with a / y and the switch with ac contactor and solid state switch is valid measure not only for improving operate level economically and amending electrical power quality but also for avoiding of replacing switch frequently and decrease economic loss

    然後對現有的演算法進行了詳細的分析、比較,篩選出既能滿足硬體要求又可降低投資、保證精度、簡化軟體的方案,確定了準同步采樣的方案,並通過對準同步采樣誤差的分析,提出了一種從45開始采樣,從而提高精度的采樣數據處理辦法,同時,對于流互感漂移提出了一種補償辦法,接著對裝置中能質量分析與統計以及無功補償中的補償量、投切原則也作了相應分析,其中對于無功補償採用y合接線,並利用交流接觸和固態開關共同投切容,不但提高了經濟運行水平、改善了能質量,而且有效的避免了繁更換開關,減少了經濟損失;最後,設計了裝置的硬體路並繪制了相應的軟體流程圖。
  7. In the paper, the design of the real - time test system for crystal parameters is presented. the signal generator of sweep frequency based on dds device ad9852, the signal measuring circuit based on gain and phase detector ad8302, and the real - time control and deal circuit based on tms320vc5416 and the design of high - speed printed digital & analog circuit board are discussed in details

    本文闡述了晶振實時測量系統的設計,介紹了以dds晶元ad9852為核心的掃信號源路,以增益相檢測ad8302為核心的信號檢測路,以dsp晶元tms320vc5416為核心的實時控制與運算路,以及高速數模路板的設計方法。
  8. Using the phase conjugation mixer the compact wire antenna with two isolated ports presented in chapter 2 is simulated, and the results show that the antenna can follow the incoming signal with the main beam and has 4 - 8db gain improve against the standard monopole in the incoming signal direction

    對本文第二章提出的兩饋埠的高隔離度線天線的模擬表明,利用相共軛子科技大學博士論文,天線系統能以主波束在0 』一360 』的范圍內跟蹤入射波方向,具有一定的方向回溯能力。
分享友人