測輻射熱器 的英文怎麼說

中文拼音 [cèfúshèrèqì]
測輻射熱器 英文
bolometer
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 輻 : 名詞（車輪中車轂和輪圈的連接物） spoke
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 輻射 : radiation; exposure; radio; beaming
  1. Bolometers and pyroelectric detectors are the most common thermal detectores in uncooled ir sensors technolgy

    非製冷熱成像探測器目前以微測輻射熱計和熱釋電探測器為主流。
  2. Abstract : this paper describes the classical mathematic model of bolometer, the effect of thermal isolation and noise on detector performance are also discussed

    文摘:總結了非製冷測輻射熱計的經典數學模型，並分析了探測器熱絕緣結構和噪聲對性能的影響，指出了性能改進和優化的基本途徑。
  3. V2o5 and vo2 thin films are a kind of outstanding chromogenics, and have a large potential for various applications, such as display devices, light storage devices, optical switch, bolometer, smart - windows and so on

    主要應用於顯示器件、光學開關、光存儲、激光保護、輻射測熱裝置等，特別是在智能窗材料方面的應用已成為研究的熱點。
  4. As one of the most important applications, cmr bolometer is fabricated using the lacamno3 films, which has a metal - insulator transition temperature at 300k. the archetypal bolometer is fabricated after the film is photolithographed, evaporated au electrodes and fixed

    以製作室溫超巨磁電阻測輻射熱儀為目標，將t _ （ mt ） 300k ， tcr 5的薄膜進行光刻、電極製作、封裝等處理製作測輻射熱儀原型器件。
  5. Plastics - simple heat release test using a conical radiant heater and a thermopile detector

    塑料.用錐形輻射加熱器和熱電堆探測器進行簡單熱釋放試驗
  6. Noise, nedt, nep, and detectivity of microbolometer arrays are also considered. the work will provide the insight necessary to understand the optimum design and practical operating requirements of microblolmeter arrays. this paper provides a low cost and more practical software tool for predicting and evaluating parameters of the detector

    對微測輻射熱計性能進行了計算模擬，為非致冷微測輻射熱計紅外探測器性能預測和評估提供一種準確、快速、低成本的方法，並且開發了一整套對測輻射熱計探測器進行計算機優化設計的模擬軟體。
  7. As the microbolometer which is voltage biased express some characters different from other infrared detectors under the effect of electric heat and infrared radiation together, the computing method of parameters, such as responsivity, noise, noise equivalent temperature different ( netd ), noise equivalent power ( nep ), optical gain, detectivity and so on is given in this paper. some of these parameters are particular compared with other detectors, and some have difference between microbolometer and other detectors

    由於微測輻射熱計在施加偏置電壓的情況下，電熱效應與紅外輻射的共同作用使它表現出與其他紅外探測器完全不同的一些特徵，文中給出了響應率、噪聲、噪聲等效功率、噪聲等效溫差、光學增益、探測率等參數的計算方法，這些參數中的部分是微測輻射熱計獨有的，或者與其他的紅外探測器的同一參數有所區別。
  8. Measuring method for normal total emittance of infrared heater

    紅外輻射加熱器全法向發射率測量方法
  9. Measuring method for normal spectral emittance of infrared heater

    紅外輻射加熱器光譜法向發射率測量方法
  10. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等；改進了水冷壁布置使換熱效果更好，減少輻射換熱損失；改進對流段結構，更充分的利用爐膛出口煙氣余熱，提高熱效率；並且進行了煙氣阻力計算、熱效率計算和能量平衡測試，對改進后的稠油燃料和改進前進行了對比，燃燒狀況和熱效率有明顯改善。
  11. The resistivity of the films drops compared with the as - grown films, but the temperature of maximum magnetoresistance reaches 287k, very close to the room temperature. therefore it is not only an important improvement to fabricate the cmr bolometer which can work near room temperature, but also a prospective research for other applications such as magnetic - sensors, spintronics devices and infrared detectors

    同時，退火后薄膜的電阻率明顯下降，外加5t磁場時，最大磁電阻率溫度點上升到287k ，接近於室溫，這不僅為製作室溫超巨磁電阻測輻射熱儀打下了堅實的基礎，也為其它許多器件的應用提供了可能。
  12. This text draws the basic principle of infrared diagnoses based on the primary knowledge of infrared radiation, and analyse the imaging principle of infrared devices ; from the view of infrared diagnostic technology we discuss the fault models and the principium of infrared diagnosis on electrical equipments ; then this paper research the diagnosis of electrical equipments fault by using infrared devices, obtain the hot picture atlas of equipment fault and analysis the hot picture atlas ; the text analyse the various kinds of possible factor which might effect the results of infrared diagnosing in electrical equipments, and propose correspondingly countermeasure against these factor in order to improve the accuracy of measurement ; finally, by using infrared diagnosing techniques analyse and diagnose the interior or exterior fault in part of transformers and arresters in electric network of si chuan, and the results obtained from the text accord with practice

    本文在紅外輻射的基礎知識上引出紅外診斷的基本原理，分析了紅外成像儀的成像原理；並從紅外診斷的角度研究了電氣設備的故障模式及其診斷的機理；研究了利用紅外熱像儀對電氣設備的故障進行診斷，獲取設備故障熱像圖譜並進行熱像圖譜的分析；對影響電氣設備紅外技術診斷結果的各種可能因素進行了分析探討，並針對這些干擾因數，提出了相應的對策，以提高檢測的準確性；論文最後應用紅外熱成像技術對四川電網中的部分變壓器和避雷器典型的內外部故障進行了診斷分析，得到與實際相符的結果。
  13. Method for measurement of mass loss and ignitability for screening purposes using a conical radiant heater

    使用圓錐輻射加熱器測量屏蔽用質量損耗和可燃性的方法
  14. Measuring method for normal spectral emittence of infrared heater

    紅外輻射加熱器光譜法向發射率測量方法
  15. Plastics - simple heat release test using a conical radiant heater and a thermopile detector iso 13927 : 2001 ; german version en iso 13927 : 2003

    塑料.用錐形輻射加熱器和熱電堆探測器進行簡單熱釋放
  16. This project is focused on microbolometer fpa. this program includes the development design and simulation tools, material research, fabrication process development, and detector and readout circuitry design, fabrication and characterization. the work done in this paper is described as follows : the theory of microbolometer fpa is expounded

    課題的重點放在非致冷微測輻射熱計焦平面陣列，這種非致冷紅外產品的設計研製工作包括：設計和模擬工具的研究、材料選擇和器件製作工藝的研究、探測器和讀出電路的設計研究、真空封裝和性能表徵的研究等。
  17. The new device consists of paint - drying box, heat carrier boiler, heating pipe, expansion tank, gas separator and oil tank, etc. the data of two applied examples shows that heat carrier paint drying method is able to make painting - drying cost drop by 88 %, compared with the conventional one, that it has some advantages such as uniform temperature field, good appearance and lower costs, compared with conventional hot air convection mode

    該裝置主要由熱載體烤漆爐、輻射加熱管，熱載體爐、膨脹器、油氣分離器和儲油槽等組成。應用實例的測試數據表明，與傳統的遠紅外電加熱鋼瓶烤漆方式相比較，鋼瓶熱載體烤漆節能和降低能耗費用十分顯著，能耗費用降幅達到88 。與熱風爐對流烤漆方式相比較，熱載體烤漆方法不僅節能，而且烤漆爐溫度場均勻穩定，同時烤漆的外觀質量也得到了明顯提高。
  18. As umbirfpa is a new type of infrared detecting device, its work principle is complex and its performance is affected by many factors. in the initial stage of developing, the design experiment and theoretical understanding are little interiorly. furthermore, the problems such as sensitivity reduced, dynamic range shortened, nonuniformity increased come forth if umbirfpa is not designed properly

    Umbirfpa是一種新型的紅外探測器件，微測輻射熱計的工作原理復雜，其性能受到很多因素的影響，目前國內尚處于發展初期，缺少實際的設計經驗和理論認識，同時umbirfpa又是在集成電路工藝線上生產的，投資大、周期長，如果設計不當，不僅可能導致靈敏< wp = 13 >度降低、動態范圍縮小、噪聲增大、非均勻性增大等問題，更可能的是根本就不能用於成像，從而造成很大損失。
  19. Using simple model of a microbolometer biased by pulse, useful practical equations and numerical estimates for the responsivity are derived

    本文為開發一整套微測輻射熱計探測器計算機優化設計和模擬軟體打下了堅實的基礎。
  20. The main work is focused on the establishment of mathematic model for a microbolometer detector, in order to simulate the structure characteristic and the optical and electrical characteristics

    對微測輻射熱計陣列的探測器像元建立了數學模型，對其結構特性和光電特性進行計算機模擬模擬和優化設計。
分享友人
分享到 Line

分享到臉書