測速試驗 的英文怎麼說

中文拼音 [shìyàn]
測速試驗 英文
measured mile trial
  • : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 測速 : logging speed
  • 試驗 : trial; experiment; test
  1. They are jinfo mountain in nanchuan county ( natural protection section ), wuling mountain in qianjiang county ( national emphases forest demonstration county which forest cover rate is beyond 50 % ) and zhongliang mountain in beibei county ( artificial destruction is very grave ). some main land use patterns i. e. woodland, garden, infield, abandon infield, shrub and grassplot are selected in those three sample sites. four aspects on soil fertility index of karst environment under different land use patterns in these three sample sites, are revealed in this paper, by using the field test, indoor measure and analysis, outdoor experiment and field investigation, and the knowledge and technique of soil, ecology, physics and chemistry etc. they are physical characteristic ( effective soil thickness, organic layer thickness, soil texture, water - stable aggregate and soil water etc. ), chemical fertility ( organism, omni - n, omni - p, omni - k, alkali - nitrogen, available p, available k and rapid available k etc. ), soil animalcule ( bacteria, fungi, actinomyces and their grosses ) and soil - seed - pool ( plant community diversity index ) in karst ecosystem

    本研究以重慶市的南川金佛山(自然保護區) 、黔江武陵山(國家重點退耕還林示範縣,森林覆蓋率50以上)和北碚中梁山(遭人為破壞嚴重)典型巖溶區為對象,選擇了幾種重要的利用方式,包括林地、果園、耕地、棄耕地和灌草坡,採用野外巖溶生態調查和室內量分析相結合的方法,以不同土地利用方式巖溶土壤肥力為重點,對不同土地利用方式土壤肥力特徵進行量化分析,找出巖溶土壤肥力差異的主要方面及其根本原因,論文主要從土壤剖面物理退化指標(有效土層厚度、有機質層厚度、質地、團聚體、水分含量等) ,化學肥力退化指標(有機質、全n 、全p 、全k 、堿解n 、效p和效k等) ,樣地土壤微生物指標(細菌、真菌、放線菌數量及總量)以及樣地土壤種子庫植物群落多樣性等4個方面對重慶典型巖溶區的土壤肥力特徵進行了較為詳細的分析研究,為巖溶地區士壤資源的合理利用及結構的調控管理提供依據。
  2. Methods the diagnosis of chronic gastritis accords with updated sydney classification system, rapid urease test, histopathological staining method and ( superscript 13 ) c breath test were used in detection of hp

    方法慢性胃炎診斷標準參照最新悉尼分類系統,幽門螺桿菌檢採用快尿素酶、病理組織學染色及(上標13 ) c呼氣
  3. The method of close water test has been used for a long time, so richer experience has been achieved. however, it not only takes pains and time, but also consumes raw materials during the close water test because of miscellaneous working procedures such as bricklaying in the two ends of pipe, water - repellent layer plastering, maintaining and water offletting, brick - block backouting after the test, especially in the region short of water and some drainage pipe with prop - pipe construction. in order to satisfy the fast development of municipal construction, new detection methods should be developed

    閉水方法因其應用時間較長,目前已積累了較豐富的經,但在閉水時,管道兩端砌築磚堵、抹防水層、養護、灌水浸泡,以及后的放水、磚堵拆除等繁雜工序,不僅費工、費時,而且消耗原材料,尤其是在缺水的地區以及頂管施工的無壓管道,這些矛盾更加突出;因此,為滿足迅發展的市政建設需要,有必要探索新的檢方法,閉氣就是其中一種,但是閉氣目前還不完善,有待于進一步深入研究。
  4. Methods of test for masonry units - determination of water absorption of aggregate concrete, manufactured stone and natural stone masonry units due to capillary action and the initial rate of water absorption of clay masonry units

    圬工砌塊的方法.混凝土人造石和天然石圬工砌塊因毛細作用的吸水率及粘土圬工砌塊吸水初
  5. Methods of test for masonry units - part 11 : determination of water absorption of aggregate concrete, manufactured stone and natural stone masonry units due to capillary action and the initial rate of water absorption of clay masonry units

    圬工單位的方法.第11部分:集料混凝土人造石和天然石圬工單位因毛細作用的吸水率及粘土圬工單位吸水初
  6. It looks upon water resistant as load, simulate every instance of locomotive running and check its every parameter automatically, then collect and dispose these data of parameters, calculate the power of simulating running of locomotive, which is based on the current, and voltage of host dynamotor. afterward, it can be judged from the working state of locomotive. through experiment and adjust each parameter, it can provide important warrant to the components of locomotive whether they can work normally and credibly

    即以水阻作為負載,模擬機車運行,對機車的主發電動機的電流、電壓和柴油機的轉等參數進行檢,並對檢結果進行處理,計算出模擬機車運行時的功率,並以此為依據,對機車的工作狀念進行判斷,通過水阻,調整有關參數,使機車運行時能發揮所要求的功率和滿足規定的工作特性。
  7. The test proves that the caudal fin oscillation frequency, the maximum amplitude of vibration of caudal fin, the caudal fin strikes the water angle influence the fish ’ s speed ; the curve experiment has obtained curve radius of inertia advance curve and static curve ; the ups and downs experiment proves that the pectoral fin on different angle influences the fish to move ups and downs

    加減論證了尾鰭擺動頻率、尾鰭后緣最大擺幅以及尾鰭的最大擊水角度對魚體度的影響;轉彎得了機器魚慣性前進轉彎和靜止轉彎時的轉彎半徑;在機器魚的升潛中論證了胸鰭不同轉角對升潛運動的影響。
  8. Methods of test for production control of concrete - method of rapid test for compressive strength of concrete by warm water curing

    混凝土生產控制方法.熱水養護法定混凝土壓縮強度的快方法
  9. Motorcycles - method of measuring fuel consumption - constant speed test - road measurement method

    機動腳踏車.耗油量的量方法.恆.道路量方法
  10. The efficiency, the runner and axis mode, the water leakage of guide vanes are also tested and used in the paper

    並對5 #機組進行了補氣效果和變,另外還有效率
  11. The mechanical parameters at high temperatures - reduction in area ( ra % ) and tensile strength ( o b ) are measured by means of gleeble - 2000 thermal simulating machine. fracture surfaces are analyzed by scanning electron microscopy and optical microscopy. the segregation of sn is also examined by auger electron spectroscopy

    通過鋼種的高溫力學參數(斷面收縮率ra和抗拉強度_ b ) ,觀察金相顯微組織,分析掃描斷口形貌,第二相析出物和俄歇能譜等方法,研究了殘留元素sn及冷卻率對高溫力學性能的影響。
  12. Through examining the detection results of radiation damage, we validated the character of this analyzer and developed it

    並且利用該儀器通過對輻射損傷性的早期、快結果反饋回來證該儀器的性能,並加以改進。
  13. Cross - country skis. determination of dynamic performance. laboratory measurement method

    度滑雪板.動態性能定.量方法
  14. Waste - silicate glass - test for determination of the initial dissolution velocity on contact with a regularly renewed aqueous solution, regenerated within a closed circuit by evaporation and condensation

    廢品.硅酸鹽玻璃.通過蒸發和濃縮在一封閉環管內重新產生的,不斷更新的含水溶液的接觸中初始溶解度的
  15. It ' s found that the best absolute lateral resolution of the velocity on the hq - 13 profile is about 30 kilometer, while that of the depth parameter on this profile can be smaller than 10 kilometer. both of the velocity and depth parameter points are of 20 kilometers interval on the four profiles in yunnan region, their lateral resolution are also detected by the checker - board - test method

    的結果表明, hq - 13線度地殼度結構橫向變化的最佳絕對分辨應在30km左右,該線上界面形態橫向變化的絕對分辨可以達到10km以內;取度節點間距和界面深度節點間距均為20km的檢表明,雲南地區四條線地殼內界面形態的橫向分辨良好。
  16. Applying virtual instrumentation technology, the author designed the hardware and software of the blower performance testing system. in the hand of hardware, testing data is acquired automatically according to press - difference sensor, press sensor and torch sensor ; blower speed is adjusted automatically according to frequency conversion of transducer and working state is auto controlled according to rotating baffle controlled by the step motor

    硬體上採用壓差傳感器、壓力傳感器和扭矩傳感器檢數據,實現了數據的自動採集;利用變頻調技術控制變頻調器輸出信號的頻率,實現了風機轉的自動調節;通過設置旋轉擋板裝置並用步進電機控制其旋轉角度實現了風機運行工況的自動控制。
  17. Precision of standard method for rapid field test for trace lead in unleaded gasoline

    無鉛汽油中痕量鉛現場快法的精密度
  18. Vitreous and porcelain enamels - determination of thermomechanical properties by means of a rapid test method

    釉瓷和搪瓷.用快定熱機械性能
  19. To explore the dynamic properties of landfills further more ; rayleigh wave tests on landfills are performed by a self - developed rsa system. by means of frequency analysis ; shear wave velocity varied with depth curves of landfills are obtained

    為了解填埋體的動力特性,本文利用自行研製的rsa表面波系統做了填埋場的瑞利波,並用對結果進行了頻譜分析,獲得了填埋場剪切波隨深度的變化。
  20. Blower performance testing is the course of changing working states, measuring testing datas, calculating performance parameters and plotting performance curves which processed under the certain rotate speed. it is important to inspecting finished production and designing new production

    風機性能是在風機轉不變的情況下,改變風機運行工況、數據、計算風機性能參數並繪制性能曲線(流量?全壓曲線、流量?功率曲線、流量?效率曲線)的過程。
分享友人