源電路 的英文怎麼說

中文拼音 [yuándiànlù]
源電路 英文
source circuit
  • 源 : 名詞1. （水流起頭的地方） source （of a river）; fountainhead 2. （來源） source; cause 3. （姓氏） a surname
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. The electrical connector of an active circuit component

    有源電路元件的電接頭。
  2. Under simple development, it could be applied on active - matrix oled directly. finally we design power circuit, through the design of a stable current circuit, we solve the disaffiliate luminance in oled

    另外，還設計了後端的功率電路，通過對恆流源電路的設計很好的解決了顯示屏亮度不均勻的問題。
  3. Protective devices in the on - site power source circuits at the generator shall allow instantaneous pick - up of the full pump room load

    發電機現場電源電路中的保護裝置應能瞬時獲得全泵房負荷？
  4. Chapter 5 is about the design of millimeter wave solid circuit included frequency multiplier, low noise amplifier, medium power amplifier, mixer, if amplifier lastly, based on the work above, a millimeter wave t / r module is developed and the analysis of the result is also introduced

    第五章毫米波固態電路，詳細分析了毫米波倍頻器、低噪聲放大器、毫米波放大器、混頻器的理論，製作了毫米波混頻器、毫米波放大器、中頻放大器、倍頻器等有源電路。最後，在上述基礎上製作了毫米波t / r組件。
  5. By comparing and analyzing the advantages and disadvantages of three kinds of voltage reference circuits, type of current density ratio compensation 、 weak inversion type and type of poly gate work function, a cascode structure of type of current density ratio compensation is chosen to form the core of voltage reference circuit designed in this paper. applying the negative feedback technology, an output buffer and multiply by - 2 - circuits are designed, which improve the current driving capability

    然後通過比較和分析電流密度比補償型、弱反型工作型和多晶硅柵功函數差型三種帶隙電壓基準源電路結構的優缺點，確定了電流密度比補償型共源共柵結構作為本設計核心電路結構，運用負反饋技術設計了基準輸出緩沖電路、輸出電壓倍乘電路，改善了核心電路的帶負載能力和電流驅動能力。
  6. Eddy - current sensor conversion circuit consist amplification circuit, band - pass filter circuit, demodulation circuit, differentiation phase and data sampling circuit. these circuits are used to convert the test signal of eddy - current sensor to discrete signal tend to process. the microprocessor system that formed of dsp chip is used to data fitting of test system, data displaying and data communicating with personal computer, etc. the interference questions of hardware design and the measure of eliminating interference signal in the subject are introduced in the last of this chapter

    硬體電路的設計主要分三大部分來實現：激勵源電路部分，由分頻電路和頻率合成電路組成，產生頻率穩定的激勵信號以確保檢測任務的正常進行；傳感器變換電路部分，由放大電路、濾波電路、檢波電路、鑒相電路和數據採集電路組成，主要將電渦流傳感器檢測線圈檢測到的信號變換成只含有被測信息的離散信號，易於后續電路處理；由dsp晶元構成的微處理系統，主要完成檢測系統的數據擬合、顯示及與主機通信等功能。
  7. In this thesis, the structur principle tal the systein project of coodess ic card were investigated and the reader was also designed. the main researches are as follows :. firstly, an equvalent circuit model of the indution power sapply of contatless ic card was presented by anaiyzing its work principle

    本論文研究非接觸ic卡原理，設計讀寫器具，提供系統方案，主要進行了以下幾個方面的工作：首先，通過分析非接觸ic卡感應電源天線近區場和電磁感應原理工作原理，建立了非接觸ic卡感應電源的等效電路模型，用ewb軟體進行了電路模擬，與實際測試結果比較，證明了建立的感應電源電路模型是正確的。
  8. Chapter 2 introduces the principle theory of lna, harmonic mixer, multiplier, spdt, vco and the basic design flows of the ads examples ( x - band ), the power combine technology, the millimeter - wave power amplifier mmics ’ trends nowadays

    第三章介紹了毫米波前端中無源電路的設計，包括毫米波窄帶濾波器的設計、微波和中頻濾波器的設計、波導到微帶的過渡、微波信號的層間過渡。
  9. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中，作者介紹了直流電機的工作原理和數學模型、脈寬調制（ pwm ）控制原理、 h橋電路基本原理和h橋功率驅動電路的兩種控制模式，設計了驅動電路的總體結構，給出了電路的功能模塊，確定了設計的可行性，然後在子電路模塊中，重點分析設計了基準源電路、振蕩器電路、高端功率管柵驅動電路（電荷泵及自舉電路） 、低端功率管柵驅動電路和死區時間產生電路。
  10. The thesis discussed a parameter extraction program for the mosfet level1 model. in the analysis and design of circuit, at first, the thesis described the system function of the new dc - dc switching converter. then several sub - circuits of converter ic such as oscillator, over - temperature shutdown circuit, auto - restart counter circuit and control circuit were completely discussed

    在電路設計中，本文首先分析了開關電源電路的基本拓撲結構和psm調制模式，接著對開關電源變換器進行了系統的原理分析並設計了總體框圖，然後詳細設計了振蕩器電路，熱保護電路，自動重啟計數器電路和主控門邏輯等子電路並進行了功能模擬。
  11. These passive circuit elements, as they are often called, are of three main types.

    通常所說的無源電路元件有三種主要類型。
  12. Chapter five discusses the passive circuit correlated our text

    第五章的內容是與本課題相關的無源電路。
  13. If the network contains no energy sources, such as batteries or electrical generators, it is known as a passive network

    如果在網路中沒有電源，例如電池或者發電機，則稱為無源電路。
  14. The utilization of the modal analysis in computer aided analysis ( caa ) of microwave and millimeter - wave waveguide passive circuits is studied in this dissertation

    本論文主要研究了模式分析法在波導無源電路計算機輔助分析中的應用。
  15. The dissertation is mainly on the theory and design of the frequency doubler - power amplifier sets of ka - band. in the passive circuit, we analyzed the characteristic of microstrip and coupled microstrip

    在無源電路部分，我們首先對微帶線、耦合微帶線的傳輸特性和微帶-波導過渡的基本原理進行了分析。
  16. In passive section, above all, i introduce theory about microstrip line. millimeter - wave band - pass filter and wave guide - to - microstrip transition. designing two type of coverer by image - reject mixer and hmc329

    無源電路部分，我們首先對傳輸線的種類，耦合微帶線的傳輸特性和微帶波導過渡的基本原理進行了分析。
  17. In the passive circuit part, according to the theories of microstrip line and coupled microstripwe, the characteristic of microstrip and coupled microstrip was analyzed, the x band filter and dc block circuit of amplifier have been designed by hp - ads software

    為毫米波設備提供本振源。在無源電路部分，我們首先對微帶線、耦合線等基本理論作了簡單的介紹。
  18. This system consists of a full bridge pwm ( pulse width modulation ) regenerative rectifier or so - called vsc ( voltage source converter ) that connected to pcc ( point of common connection ) at the power utility grid through a passive interface circuitry

    這種系統包括一個pwm全橋可逆整流器或者所謂的電壓源變換器，通過無源電路介面與電網的pcc點（公共連接點）相連。
  19. In active section, the fundamentals of fet and hemt that are used as multipliers were analyzed

    在有源電路部分，我們分析了fet 、 hemt作為倍頻器的基本原理。
  20. So the passive lc network is used as a prototype for building a corresponding active network by leap - frog method

    因此，以無源lc網路為原型，利用跳耦法設計對應的有源電路。
分享友人
分享到 Line

分享到臉書