溫差電池 的英文怎麼說

中文拼音 [wēnchādiànchí]
溫差電池 英文
thermal battery
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 池 : 名詞1 （池塘） pool; pond 2 （旁邊高中間窪的地方） an enclosed space with raised sides 3 （舊指劇...
  • 溫差 : [物理學] difference in temperature; range of temperature
  • 電池 : [電學] cell; battery; element; electric battery
  1. In the mean time, i test the separator ’ s performance, including the rate of hole 、 the performance of absorbing electrolyte and the conductance eletrochemical steady range 、 machine intensity test, and then make bettery to test its cycle performance. the test result show that, the spreading separator get better performance, when dbp ’ s percentum reach 50 %, and dry temperature reach 90, after ultraviolet radiation disposal. the test show that, the separator has high conductance reach 6. 1 10 - 3s / cm ( 25 ), and the machine intensity can reach 3. 92 mpa, this separator can meet the need of making bettery, the bettery capability will go down after 30 cycle. and the bettery show worse performance under high temperature, under 70, the bettery will get fire. making the intensified seprator, i find that when dbp % : pvdf % = 40 % : 60 %, dbp % + pvdf % : sio2 % = 70 % : 30 %, the separator get

    但用其制備的電池循環30周期后容量發生衰減，並且電池高溫性能差， 70下電池燃燒;強化聚合物膜的最佳制備配比條件為: dbp : pvdf為40mass % : 60mass % ， dbp含量與pvdf含量之和與納米sio2含量比值為70mass % : 30mass % ;強化電解質隔膜的室溫離子電導率也可達4 10 - 3s / cm左右，完全能滿足聚合物鋰離子電池的使用需要;機械強度遠遠大於流延法制得的隔膜，達到108 . 84mpa 。
  2. Spinel limn2o4 is regarded as the most promising cathode material for lithium - ion cells because of its low cost and environmental friendly nature over licoo2. however its poor cyclabiliry greatly prevented it from wide application, especially at high temperature

    Limn _ 2o _ 4尖晶石型化合物作為鋰離子電池的正極材料之一，被認為是最有希望替代licoo _ 2的綠色電源材料，但其較差的循環性能（特別是在高溫條件下）嚴重地阻礙了它的應用。
  3. The intermediate - temperature sofc ( solid oxide fuel cell ) ’ s electrolyte with perovskite - type lsgm ( la _ ( 0. 9 ) sr _ ( 0. 1 ) ga _ ( 0. 8 ) mg _ ( 0. 2 ) o _ ( 3 - ) ) was synthesized using advanced pechini method and solidification method. the thermal and electrical properties of the sintered samples ( synthesized by two different methods ) were measured and compared by thermal expansion and ac impedance spectroscopy ; the phase transformation process and inner structure were measured and compared by xrd, dta - tg and ac impedance spectroscopy. the research results show that the electrolyte synthesized by advanced pechini method has several advantages, such as fine pre - powders, low sintering temperature, reduced or eliminated impurity phases and high conductivity etc. so, the apm is ideal method to synthesize lsgm

    採用改進的檸檬酸法（以檸檬酸和edta乙二氨四乙酸為復合絡和劑，檸檬酸為燃料）和固相法分別制備了具有鈣鈦礦結構的中溫固體氧化物燃料電池的電解質材料lsgm （ la _ （ 0 . 9 ） sr _ （ 0 . 1 ） ga _ （ 0 . 8 ） mg _ （ 0 . 2 ） o _ （ 3 - ） ） ，用差熱?熱重分析（ dta / tg ） 、 x光衍射分析（ xrd ） 、交流阻抗譜技術（ ac - impedancespectra ） 、比表面積分析（ bet ）和燒結收縮率曲線等手段對產物的熱分解過程、物相轉變和內部結構等進行了表徵，並對由這些粉體燒結而成的固體氧化物燃料電池的電解質材料的電導率進行了檢測。
分享友人
分享到 Line

分享到臉書