溫差電的 的英文怎麼說

中文拼音 [wēnchādiànde]
溫差電的 英文
thermaoelectric
  • : Ⅰ形容詞(不冷不熱) warm; lukewarm; hot; gentle; mild Ⅱ名詞1 (溫度) temperature 2 (瘟) acute ...
  • : 差Ⅰ名詞1 (不相同; 不相合) difference; dissimilarity 2 (差錯) mistake 3 [數學] (差數) differ...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 4次方是 The fourth power of 2 is direction
  • 溫差 : [物理學] difference in temperature; range of temperature
  1. Hourly values of global solar radiation are measured at king s park by a thermoelectric pyranometer sealed thermo - pile dome solarimeter together with an integrating counter. a bimetallic actinograph is used as a back - up

    利用一具熱總日射表球形罩封密堆總日射表連同累積計數器,天文臺可以量度每小時太陽總輻射數量。
  2. Hourly values of global solar radiation are measured at king s park by a thermoelectric pyranometer ( sealed thermo - pile dome solarimeter ) together with an integrating counter. a bimetallic actinograph is used as a back - up

    利用一具熱總日射表(球形罩封密堆總日射表)連同累積計數器,天文臺可以量度每小時太陽總輻射數量。
  3. The voltage may provides an analog representation of the temperature difference.

    壓可以成為模擬表示。
  4. Outlook and application of thermoelectric generation

    技術應用和展望
  5. It shows that the injection quantity and the difference of temperature distribute as a parabola which is at the same load, and the minimum of the parabola corresponds to the optimum quantity of injection ( g ). under the condition that the quantity of injected mass, the air speed and the heat quantity is respectively g, v and q, the research demonstrates that the pentium iv chip ' s temperature variation can be controlled under 40c and work normally when the wind speed overpass 1. 5m / s and the power dissipation of the chip is 60w. otherwise this paper calculates the flooding limit of thermosiphon with several different methods

    對其充灌量、散熱量、子元件( cpu模擬晶元)表面與環境度之及通風、流速影響進行了系統測試,發現充液量與關系在負荷不變時呈拋物線分佈,其極小值點對應充液量是最佳充液量g 。在充液量為g時,對風速v 、散熱量q進行研究表明,當風速超過1 . 5m / s后,奔騰晶元在60w發熱條件下晶元度小於40 ,能滿足長期正常工作。
  6. Standard specification for magnesium oxide and aluminum oxide powder and crushable insulators used in the manufacture of metal - sheathed platinum resistance thermometers, base metal thermocouples, and noble metal thermocouples

    金屬外殼度表基金屬熱耦和貴金屬偶製造中使用氧化鎂和氧化鋁粉末及壓扁絕緣子標準規范
  7. Test and analysis for the stator bars temperature in gezhouba power plant show that, by different transposition, temperature distribution in bars is different. the reason is in skin effect and circulating current among different layers

    究其原因,各股線流不等,股線間存在較大環流,造成各股線間可高達30 40 。
  8. The main reasons causing increased chilling tendency of nodular iron are as follows : using metal charge containing trace and alloy elements which can increase chilling tendency ; molten iron being holded at high temperature too long ; abnormal nodularizing and / or inoculation treatment, as well as abnormal composition control

    摘要引起球鐵白口傾向大主要原因是:爐料穩定性爐保、球化處理及鐵液成分控制和孕育處理出現異常。
  9. As the microbolometer which is voltage biased express some characters different from other infrared detectors under the effect of electric heat and infrared radiation together, the computing method of parameters, such as responsivity, noise, noise equivalent temperature different ( netd ), noise equivalent power ( nep ), optical gain, detectivity and so on is given in this paper. some of these parameters are particular compared with other detectors, and some have difference between microbolometer and other detectors

    由於微測輻射熱計在施加偏置情況下,熱效應與紅外輻射共同作用使它表現出與其他紅外探測器完全不同一些特徵,文中給出了響應率、噪聲、噪聲等效功率、噪聲等效、光學增益、探測率等參數計算方法,這些參數中部分是微測輻射熱計獨有,或者與其他紅外探測器同一參數有所區別。
  10. The system follows carnot cycle principle. driven by electricity, its working substance absorbs the latent heat in the air or other low - temperature heat source, and waste heat let out of living or industry, compresses it to heat by compressor, exchange, exchange heat with water to higher the water temperature ( 55 warm ). it a new water heating apparatus, used in home heating, and influenced by environment runoff and the heat exchang of working substance. this system is more used in southem china

    根據逆卡諾循環原理,採用能驅動,通過工質吸收空氣中或其他低熱源中無法被利用太陽能潛熱、生活及工業排放廢熱,通過壓縮機壓縮升,再與水換熱,使水升高,獲得( 55 )熱水,是一種新型熱水製造設備,應用於家庭和熱水系統,受到環境和工質換熱影響,熱泵熱水器/熱水系統更多適合南方地區應用。
  11. Sheathed thermocouple as temperature sensor consist oftwo dissimilar and qualified conductor or semiconductor welded together at both ends one terminal as measaring junction, another as reference junction, temperature can be measured depend upon

    由兩種不同但符合一定導體或半導體熱極,將其一端焊接作為測量端,另一端為參考端,利用兩端與熱
  12. Microstructure of the composite layer was analyzed with help of optical microscope, scanning electronic microscope ( sem ), electronic probe microanalysis ( epma ) and x - ray diffraction ( xrd ). the compacting of the billet and the forming mechanism of the carbide reinforcement were studied based on thermodynamics and kinetics of reaction, sintering theory and the result of dta. at the same time, the wear - resistance of the composite layer was studied under condition of dry sliding friction

    利用光學顯微鏡、掃描子顯微鏡、子探針以及x -射線衍射儀,分析了表面復合層基體組織結構;運用反應熱力學、動力學、粉末燒結理論和燃燒合成理論,結合熱分析結果,探討了表面復合層壓坯燒結緻密化原理和碳化物增強相形成機理;利用坯塊在真空燒結爐不同度下燒結出來顯微組織分析,模擬出坯塊燒結過程中化學反應過程。
  13. Abstract : according to the characterestic of resistance furnace temperature control, temperature rising one - way control, large time delay and time - variation of parameter, using method of fuzzy compositional rule of inference establish fuzzy model and design fuzzy cntroler. in order to increase control system precision, it gives a fuzzy variable k, and sets parameter self - adjusting fuzzy control system. this system can on line self - adjusting controller parameters according to the error and variations of the error. it makes the system steady precision improved

    文摘:根據阻爐控制特點,即只有升單向控制、滯后較大且具有參數時變性,利用模糊推理合成法建立模糊模型並進行模糊控制器設計,為提高模糊控制精度,引入模糊變量k ,構成參數自調整模糊控制系統.該系統可根據誤和誤變化在線自動調整控制器參數,使系統穩態精度得到改善
  14. Evaporative cooling has been regarded as a new cooling technology on hydro - generator, and it not only could increase the ratio of material utilization and reduce the difficulties of making large - scale hydro - generators, the running difference in temperature, the stress of the generator ' s stator and the possibilities of the incidental occurrences, but also has better performance than internal water cooling

    蒸發冷卻作為水輪發一種新型冷卻技術,不僅可以提高材料利用率,減小特大型發機製造難度,降低發機定子繞組運行和發機定子應力,減少事故隱患,更重要是蒸發冷卻比水內冷具有更好優越性。
  15. The paper delineates the general principles, the state of art and development tendencies of power generation by making use of oceanic temperature differences, wave rocking energy and tidal energy

    闡述了海洋、海洋波浪發及潮汐潮流發原理、現狀及發展趨勢。
  16. The experimental models not only can be introduced into low temperature waste - heat power generation, but also can be available in the geothermal, solar and ocean thermal gradient power generation

    該項研究實驗模型不僅可以利用在低余熱發系統,而且對地熱、太陽能及海洋均有參考價值。
  17. Testing method for fine ceramics thermoelectric materials part 1 : thermoelectric power

    細陶瓷熱材料試驗方法.第1部分:勢率
  18. With the annealing temperature increasing, the average optical transmittance increases and the absorption edge of the transmission curve of the films moves toward short wavelength

    Azo薄膜塞貝克效應結果表明: azo薄膜具有明顯塞貝克效應,動勢隨著( ? t )增大而呈線性增大。
  19. According to the characterestic of resistance furnace temperature control, temperature rising one - way control, large time delay and time - variation of parameter, using method of fuzzy compositional rule of inference establish fuzzy model and design fuzzy cntroler. in order to increase control system precision, it gives a fuzzy variable k, and sets parameter self - adjusting fuzzy control system. this system can on line self - adjusting controller parameters according to the error and variations of the error. it makes the system steady precision improved

    根據阻爐控制特點,即只有升單向控制、滯后較大且具有參數時變性,利用模糊推理合成法建立模糊模型並進行模糊控制器設計,為提高模糊控制精度,引入模糊變量k ,構成參數自調整模糊控制系統.該系統可根據誤和誤變化在線自動調整控制器參數,使系統穩態精度得到改善
  20. On the basis of the analysis of fundamental principle of thermoelectric refrigeration, the steady state mathematical model of the thermoelectric system was founded. according to the model, the theoretical analysis and calculation are made on various working conditions, and analyzed theoretically the effects on thermoelectric system which caused by hot and cold temperature difference, the device ’ s effective system figure of merit, the properties of the heat changers, which established theoretical basic for the opening up and design of the thermoelectric system and its performance test

    在分析熱製冷基本原理基礎上,建立了熱裝置穩態系統數學模型,並依據該模型對熱裝置系統進行了不同工作狀態下熱力分析計算,並就熱裝置冷熱端堆片優值系數、散熱器散熱性能與熱熱泵裝置性能影響進行了理論分析,為熱裝置開發設計和現有熱裝置性能測試建立計算理論基礎。
分享友人