溫度反應 的英文怎麼說

中文拼音 [wēndùfǎnyīng]
溫度反應 英文
temperature response
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 溫度 : [物理學] temperature
  1. The factors influencing on the performance of ash - jd such as the moore ratio of monomers, the reaction temperature and time, concentration, the ph value of reaction solution and the drippy speed of formaldehyde were studied carefully. through experiments, the optimum level of those factors was gained

    論文詳細研究了反應單體的摩爾比、反應溫度、時間、濃度、反應溶液的酸堿度及甲醛的滴加速度等對產品ash - jd性能的影響，通過試驗，得到了這些因素的最佳水平。
  2. The reaction is endothermic and takes place at atmospheric pressure and 25 - 37 degree centigrade, and generates methyl or ethyl esters biodiesel and crude glycerin as by - product

    該反應是吸熱反應，在大氣壓力和25 - 37攝氏度氣溫下反應，產生的副產品有甲基乙荃酯生物柴油和天然甘油。
  3. Thirty - one crystals of polyoxometalates ( 1d, 2d, 3d ) were prepared by means of middle hydrothermal technique, molecular design and self - assembly, and characterized structurally by single crystal x - ray diffraction. the thermal stability, activity of catalysis and magnetism of some compounds were systematically studied. the continuous appearance of p - v - o, p - mo - o, v - mo - o, v - o system with novel structure enrich polyoxometalate chemistry, the reaction characterization and the synthesis law of molybdates, tungstates and vanadates under hydrothermal conditions were explored

    由於p - v - o 、 p - mo - o 、 v - mo - o 、 v - o體系新結構不斷出現，豐富了多金屬氧酸鹽化學，探討水熱條件下釩、鉬、鎢物種的反應特性和生成規律，研究原料的選擇、配比、加料順序、濃度、酸度、反應溫度、反應時間等因素對產物的生成及結構的影響，為新的催化劑、導電材料、磁性材料的研製與開發積累經驗。
  4. A new surfactant heavy crude oil sulfonates ( hcos ) was synthesized from daqing heidimiao oil with fuming sulfuric acid

    考察了酸烴比、反應溫度、反應時間對磺化反應的影響。
  5. Copper - nanosized tibi composites were prepared by in - situ process. the microstructure, mechanical and electrical properties, and dry sliding wear behavior and electric sliding wear of cu - nanosized tib _ 2 in - situ composites was investigated ; mostly task as follows : the thermodynamic data for the reactions between b and ti in the molten liquid of copper were analyzed, the copper matrix composites reinforced by in - situ tibi nanoparticles were prepared by reactions of 8263, carbon and titanium in copper - titanium melt, and copper - titanium, copper - boron in alloy melt, respectively, which controlled the reaction temperature, reaction time and solidification process. the rnicrostructure and mechanical and electrical properties of the in - situ composites were investigated by using optics microscope, tem and xrd

    本文採用原位反應法制備了cu -納米tib _ 2原位復合材料，在此基礎上分析了原位復合材料的微結構，進行了干滑動摩擦磨損和電接觸滑動磨損實驗，完成的主要工作如下：從熱力學的角度出發，分析了陶瓷tib _ 2顆粒在銅基體中原位生成的熱力學條件，並用電解銅、工業純鈦、 b _ 2o _ 3 、 c （還原劑）以及cu - ti 、 cu - b等合金為原料，通過控制適當的反應溫度、反應時間和快速凝固等工藝手段，制備了cu -納米tib2原位復合材料。
  6. Results of ethynylation were influenced by factors, such as, reaction temperature, reaction time, variety of solvent, and amount of alkali

    反應溫度、反應時間、溶劑種類和堿用量等因素均對萜烯基丙酮乙炔化反應結果有影響。
  7. In order to find a suitable routine for this synthesis, various different factors were considered such as the category of catalysts, reaction temperature, reaction time, raw material mol ratio

    通過實驗考察酶催化劑的種類、反應溫度、反應時間、反應配比等反應條件對水解及季錢化過程的影響，得到一條切實可行且相對高效的合成路線。
  8. The effect of the mole ratio reactant, reaction temperature, reaction time, catalyzer on the each reaction were studied. the optimum reaction conditions were obtained

    研究反應物配比、反應溫度、反應時間、催化劑用量對各步反應的影響，得到最佳反應條件。
  9. The control algorithms of reaction temperature, reaction pressure, molecule weight and reaction gas composition are discussed. the application of neural network and fuzzy control is stressed

    主要討論了反應溫度、反應壓力、氣體組分、聚合物分子量主要控制參數的控制策略，探索了神經網路、模糊控制等智能控制方法在烯烴合金共聚反應的應用。
  10. Abstract : emphasis is put on the recent development concerning the catalytic oxidation of methane to oxygenates by heterogeneous catalysis and liquid catalysis. for heterogeneous catalysis, the choice of catalysts, reaction temperature and pressure, oxygents, additives, reactors and reaction mechanism are summarized. different research systems of liquid phase oxidation of methane are reviewed

    文摘:本文對甲烷催化氧化制含氧化合物的研究，從多相催化和液相催化兩個方面進行了綜述；對多相催化的研究從催化劑的選擇、反應溫度、反應壓力、氧源、反應添加物、反應器及反應機理等方面進行了總結，液相氧化的研究則對不同的研究體系進行了詳細的綜述。
  11. The flow characteristics, distributions of temperature, potentials, and chemical components in the 3 - d space are obtained by resolving the transport equation set, and coupling the electrochemical kinetics equations

    通過cfd技術求解傳遞方程組，並耦合電化學動力學方程，獲得了電池內的流動、溫度、反應物組分濃度等分佈和電池的極化性能曲線。
  12. This paper firstly synthesized the maltose fatty acid ester by agent - in - water method. the influences of reaction time, temperature, proportion of reactant ect. on synthesis have been observed

    摘要本實驗首次以麥芽糖漿為原料微乳化法合成麥芽糖酯，以酯得率為考察目標，主要探討了反應過程中時間、溫度、反應物配比等因素的影響，並對產品的理化性質作初步分析。
  13. Meanwhile, the reaction conditions for synthesis of propaphos, such as reaction temperature, reaction time, molar ratio of reactant were investigated, and the optimal one were found as the following : molar ratio of 4 - ( methylthio ) phenol, phosphite and sodium hydroxide 1 : 1. 4 : 2. 3, reaction temperature 70, reaction time 2 h

    同時，較系統地考察了高選擇性有機磷殺蟲、殺菌劑丙蟲磷的合成的工藝條件如反應溫度、反應時間、縛酸劑種類以及縛酸劑的用量。
  14. The reaction conditions, such as the ratio and adding order of rectants, reaction temperature, reaction time and displacers, were investigated

    考察了原料摩爾比、加料順序、反應溫度、反應時間、置換劑等對反應結果的影響。
  15. In view of process technology of potassium sulfate by neutralizing potassium hydrogen sulfate with ammonia, the effects of mole ratio of potassium chloride to sulfuric acid, reaction temperature and reaction time on preparation of middle product potassium hydrogen sulfate have been studied in aqueous solution

    針對硫酸氫鉀用氨中和制備硫酸鉀的生產工藝，研究了水溶液中氯化鉀和硫酸反應的原料配比、反應溫度、反應時間等因素對制得的中間產品硫酸氫鉀影響。
  16. In the course of oxidation, reaction temperature should rise step by step, and in the late stage, reduced pressure distillation should follow so that the concertration of glyoxalic acid can rise and production rate of allantoin can rise up to 40 %

    在氧化反應的過程中逐步地提高反應溫度，反應後期進行減壓濃縮，提高了乙醛酸的濃度，縮短了氧化時間，並使尿囊素產率達到40 % 。
  17. In this dissertation, the synthesized conditions, such as the initial concentration of ti4 +, the initial acidity, the reactive temperature and the reactive time, have been studied with their effects on the photochemical activity of the product and the four preparation methods have been compared and optimized

    並分別實驗研究了鈦液起始濃度、反應液起始酸度、反應溫度、反應時間等實驗條件對產品光化活性的影響，並對各制備方法進行實驗條件優化和優劣比較。
  18. The factors that affect on graft ratio are discussed. the factors include reactive temperature, reactive time, the dosage of initiating agent and the dosage of maleic anhydride etc. the optimum reactive condition and the optimum reactive compounding formula are gotten

    在本課題研究過程中，首先制備了pe - mah ，討論了反應溫度、反應時間、引發劑的用量和酸酐用量等對接枝率的影響，得出了最佳反應條件和最佳反應配方。
  19. The factors which may affect the results during degradation are as follows : quality percentage of hydrogen peroxide > reaction temperature > reaction time

    在降解過程中對降解結果產生影響的因素依次為：雙氧水的質量百分比反應溫度反應時間。
  20. The paper describes the synthesis of polyaniline by chemical oxidizing process, and studies the effects of different reaction conditions on the polyaniline properties, including different oxidant, different amounts of oxidant, reaction temperature, reaction time, kinds and concentration of acid

    用化學氧化法合成了聚苯胺，通過實驗系統地研究了氧化劑種類、濃度、反應溫度、反應時間、摻雜酸的種類和濃度等不同因素對聚苯胺性能的影響。
分享友人
分享到 Line

分享到臉書