溫度極限 的英文怎麼說

中文拼音 [wēnxiàn]
溫度極限 英文
temperature extremes
  • : Ⅰ形容詞(不冷不熱) warm; lukewarm; hot; gentle; mild Ⅱ名詞1 (溫度) temperature 2 (瘟) acute ...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • : i 名詞1 (頂點; 盡頭) the utmost point; extreme 2 (地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • : Ⅰ名詞(指定的范圍; 限度) limit; bounds Ⅱ動詞(指定范圍, 不許超過) set a limit; limit; restrict
  • 溫度 : [物理學] temperature
  • 極限 : 1 (最高的限度) the limit; the maximum; the ultimate limit; limitation; extremity; tipping point...
  1. This last advance permitted a very close approach to the limiting temperature of absolute zero.

    最後的這步使能非常接近,即絕對零
  2. The variation of ultimate tensile strength with length for amosite crocidolite, chrysotile is shown in table 2. 10.

    鐵石棉,青石棉和石棉的抗拉強隨長的變化情況見表210
  3. The variation of ultimate tensile strength with length for amosite crocidolite, chrysotile is shown in table 2. 10

    鐵石棉,青石棉和石棉的抗拉強隨長的變化情況見表2 10
  4. The endurance limit is reduced for temperatures above room temperature.

    高於室,持久則降低。
  5. This thesis used aerodynamics equation and mechanics of materials knowledge analyzed the high pressure caused by overloading in terms of theory. by compared the increment of pressure in a not full container with the full one and combined with the igc - code, this thesis put forward a method of calculating safe loading capacity under different temperature

    本文應用了氣體力學方程和材料力學理論知識,對充裝過量導致過高的液貨艙壓力進行了理論分析,對比保留有氣枕時的液貨艙的壓力增量和充裝過量時造成滿液的壓力增量,並結合igc規則對充裝的規定,提出了不同下的安全貨液充裝量的計算方法。
  6. Safety of machinery. temperatures of touchable surfaces. ergonomics data to establish temperatur limit values for hot surfaces

    機械的安全性.可觸摸表面的.確定熱表面溫度極限值的人機工效學數據
  7. 4. the thrust measurement device was calibrated, and the accuracy was 2 % fs. at the same time the signal of thrust measurement was input to the computer. e - type chromel - constantan thermocouple was used to measure the temperature of mpt, and the accuracy was 5 % fs. the vacuum measurement was realized by using zdf - 5427m vacuometer, and the accuracy was 3 % fs

    ( 4 )對推力測量系統進行了標定並實現了計算機採集,推力測量系統最大相對誤差為2 fs ;測量目前還只於對mpt諧振腔壁的測量,使用e型鎳鉻?康銅熱電偶即可較容易實現,其測量精為5 fs ;真空測量採用zdf - 5427m微機型復合真空計,其由熱偶計和熱陰電離計復合而成,該真空計測量控制精為3 fs 。
  8. So, for example, 27c is equal to 300k

    絕對零是低,沒有任何物體可以更冷。
  9. Determination of time - temperature limits for plasties after prolonged exposure to heat

    塑料長期熱暴露后時間-溫度極限的測定
  10. Plastics - determination of time - temperature limits after prolonged exposure to heat

    塑料製品.熱力長期幅照后時間溫度極限的測定
  11. Plastics. determination of time - temperature limits after prolonged exposure to heat

    塑料製品.長時間受熱后時間-溫度極限值的測定
  12. Plastics - determination of the time - temperature limits after prolonged exposure to heat

    塑料.長期暴露于熱作用后時間和溫度極限值的測定
  13. General principles for temperature limits in the rating of electric equipment and for the evaluation of electrical insulation

    電子設備額定值中溫度極限和電絕緣評定的一般原則
  14. General principles for temperature limits in the rating of electrical equipment and for the evaluation of electrical insulation

    電子設備額定值中溫度極限和電絕緣評定的一般原則
  15. The limit using temperature of mc nylon is 120, the gear can t work correctly if the temperature exceeds 120

    Mc尼的使用溫度極限約120 ,當摩擦熱引起的上升超過此時,輪將無
  16. Temperature and pressure limitations for piping systems manufactured from 20 % nickel 2 % chromium spheroidal graphite austenitic cast iron '

    鎳和鉻奧氏體球墨合金鑄鐵制管道系統的壓力和溫度極限
  17. Integrated circuits require less power and lower voltages than the equivalent macroscopic circuits, consequently they operate at lower temperatures, and individual components may be closed together without exceeding the operating temperature limit

    參考譯文:集成電路比等效的分離元件電路功率小,工作電壓低,因而可以在較低的下工作,電路中包含的單個元件可以緊靠在一起而不超過工作溫度極限
  18. Ltd. a coupled vibration method on suspended free poles is employed to determine the initial young ' s modulus at elevated temperatures, also the thermal expansion coefficients of fire - resistant steel

    通過高下的恆加載拉伸試驗,得到不同下耐火鋼的屈服強、延伸率、面縮率和應力應變關系,並測定高下耐火鋼的熱膨脹系數,採用懸絲耦合共振法測定高下耐火鋼的初始彈性模量。
  19. When the case of heated hastily or extremely low temperature appears, the classical fourier law of heat conduction has limitations

    當快速加熱或低時,經典的傅里葉導熱定律具有局性。
  20. Experimental research of ultimate bearing capacity of high - strength bolt at high temperature

    高強螺栓連接在高承載力的試驗研究
分享友人