溫度檢層 的英文怎麼說

中文拼音 [wēndùjiǎncéng]
溫度檢層 英文
temperature logging
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 溫度 : [物理學] temperature
  1. According to the m1l - std - 883c standard of thermal cycle loading, the delamination propagation rates at the interface between chip and underfill were studied experimentally by using c - mode scanning acoustic microscope ( c - sam ) for two types of flip chip packages with different states of solder joint

    採用mil - std - 883c標準，通過溫度循環實驗，使用高頻超聲顯微鏡（ c - sam ）無損檢測技術，測量了在不同焊點狀態下， b型和d型兩種實際倒裝焊封裝晶元與底充膠界面分層裂縫傳播速率。
  2. By means of laboratory and field experimentation of typical semi - rigid base materials, the relationships among laboratory experimental values, field maintain values, field core values and construction criteria are put forward. and the relationships between different test methods are established. using time - temperature conversion principle, it processes the intensity assessment of field cores, then offers the method of determining the test deflection of pavement surface

    通過典型半剛性基層材料的室內外試驗，研究主要設計參數的室內試驗值、野外養生值、現場取芯值及施工指標間的關系，建立了不同試驗方法間的相關關系，運用時溫換演算法則，對現場芯樣進行強度評定，並提出了路表彎沉檢測標準的確定方法。
  3. At fixed time intervals, the gts data are decoded by the hko main computer and quality control checks are applied. objective analyses are then carried out for data at various standard pressure levels to produce grid point values. charts showing flight level winds, temperatures and other information are made available at the airport meteorological office ( amo ) for the provision of flight documentation and airway winds

    天文臺的主電腦定時對接收到的資料進行譯碼及質量控制檢查，跟著對各個標準氣壓層面的資料進行客觀分析，計出各網格點的數值，從而製作各巡航高度的風、溫度及其他資料的天氣圖，讓機場氣象所用來編制飛行氣象文件和航道風。
  4. At fixed time intervals, the gts data are decoded by the hko main computer and quality control checks are applied. objective analyses are then carried out for data at various standard pressure levels to produce grid point values. charts showing flight level winds, temperatures and other information are made available at the airport meteorological office for the provision of flight documentation and airway winds

    天文臺的主電腦定時對接收到的資料進行譯碼及質量控制檢查，跟著對各個標準氣壓層面的資料進行客觀分析，計出各網格點的數值，從而製作各巡航高度的風溫度及其他資料的天氣圖，讓機場氣象所用來編制飛行氣象文件和航道風。
  5. The recombinant vectors were transformed into e. coli m15 respectively and the expression was induced based on the optimal values of the iptg concentration incubation temperature and induction time determined in the previous section

    根據優化確定的iptg誘導濃度、誘導溫度和時間進行誘導表達。 5的積層膠， 15的分離膠，變性聚丙烯酰胺凝膠電泳（ sds - page ）檢查表達情況。
  6. The pretreatment, effect of bath compositions and operation conditions such as temperature, currenty and time on compactness of the zinc and cu / ni / cr coatings have been investigated. the relationship of operation conditions to thickness of the coatings was studied by weight method. the specimens have been pickled in nacl or sulfate acid solution to evaluate the porosity of the coating

    研究了鎂合金電鍍前處理工藝，電鍍鋅、電鍍銅/鎳/鉻工藝配方及其施鍍溫度、電流密度和時間對鍍層緻密性的影響;採用稱重法研究施鍍工藝與鍍層厚度的關系，利用nacl溶液和硫酸溶液浸泡試樣來考察鍍層孔隙率，採用劃痕試驗和熱震試驗檢驗鍍層的結合力，採用金相顯微鏡和掃描電子顯微鏡觀察鍍層表面形貌。
  7. By the essential control of the initial stage of - material growth, the high - quality crystal films can be obtained. by using mocvd technology, studies of some kinds of methods such as hydrogen - terminated, nitridation, plasma - assisted, growth of two stages and sputtering buffer layers have been conducted. by measuring of xrd, pl, sem and tem, and analysis of spectra of xrd, raman scatting, oa, and pl at different temperatures, we observed that the crystal quality has been improved markedly

    本文利用mocvd技術，採用各種對si襯底處理的方法，如氫終止法、氮化法、等離子體轟擊方法、兩步生長法、濺射緩沖層法等進行了試驗與研究，通過x射線衍射技術（ xrd ） 、光致發光技術（ pl ） 、掃描電子顯微術（ sem ） 、透射電子顯微術（ tem ）等檢測，並對其x射線衍射光譜、拉譜光譜、吸收光譜及不同溫度下的光致發光光譜分析，發現外延晶體的生長質量得到了明顯提高。
  8. In this paper, a image processing method has been presented, with this method mean temperature of testing object can be arrived at from infrared picture and the interior temperature gradient of the test pieces in the situation of transient heat transfer can be got. unsteady - state heat transfer mechanism of wall has also been studied in this paper. on the basis of theoretical analysis and experimental study we can get such conclusions : infrared testing of energy conservation of buildings is rapider and more accurate than heat - flow meter method which is popular at present ; heat transfer mechanism in the situation of unsteady - state heat transfer has been analyzed through experiment ; the interior layers ’ temperature of the test pieces ascent in company with

    本文在理論分析和試驗研究的基礎上得出以下結論:本文研究的紅外檢測建築節能的方法比目前存在的熱流計法更快速、更準確;用試驗分析了墻體在非穩態傳熱情況下的傳熱機理;試件各層溫度隨著受熱面環境溫度的上升而上升，只是上升的程度不同，響應時間不同，這是由於試件內部有一個蓄熱過程;通過傳熱理論和建築熱工計算推導出了非穩態傳熱情況下的傳熱系數的計算公式;本文用matlab進行紅外圖片的處理，進而得到被測物的平均溫度;用數據處理軟體擬合溫度熱流。
  9. It possess many of the physical properties such as high atomic number ( z ), large enough band gap, high resistivity, relatively low leakage currents, and high intrinsic mobility - lifetime ( ut ) product, which are required for room - temperature nuclear radiation detectors. so it is widely used in nuclear medical imaging system, space engineering, and astrophysics, environmental monitoring, and so on. in addition, it is the best substrate for lattice matched epitaxial growth of hg1 - xcdxte ( mct ) thin films and solar cells

    用單晶czt製成的探測器可在室溫下工作，工作溫度范圍寬（ - 20 40 ） ，能量探測范圍寬（ 10kev 6mev ） ，對x射線、射線能量解析度高，在x射線、射線成像、天體物理研究、工業探測、安全檢測、核輻射探測、核廢料監控、 x射線熒光分析（ xrf ） 、 x射線斷層掃描和核醫學等方面有重要用途。
分享友人
分享到 Line

分享到臉書